Manitowoc Ice K00067 User Manual

K00067 ICE BAGGER

Installation Instructions

ASSEMBLING BAGGER MOUNTING BRACKET

1. Remove the ice chute.

2. For left-handed users, assemble the bagger mounting

bracket on the left side, as illustrated in Figure A.
For right-handed users, assemble the bagger
mounting bracket on the right side of the bagger
cabinet, using the machine screws and lockwashers
provided.

TO USE ICE BAGGER

1. Hang bags on the rear bracket through the

rectangular slot in the bag hanger (see Figures B and
C).

2. Place supplied twist ties in front tray.

3. Replace the ice chute.

4. Pull open one bag under the ice chute.

5. Fill bag with ice, leaving enough room so the bag

can be twisted and closed.

6. Firmly pull bag of ice off of hanger, twist, and close

with twist tie.

Manitowoc Ice, Inc.

2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8008093
Telephone [phone], Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Rev. 10/03/97

REFILLING EMPTY BAG HANGER

1. Remove empty wire wicket from bag hanger and

discard.

2. Lay wicket of new bags down on a flat surface with

ends of wicket sticking straight up.

3. Slide the bag hanger down onto the wire wicket so

that the ends of the wire wicket go through the holes
in the bag hanger.

4. Tuck the top ends of the bags under the tab on the

front of the bag hanger.

5. Keep the bags and hanger lying flat. Use one hand

to compress the wire wicket, bags, and hanger.
While one hand compresses, use your other hand to
pull up the ends of the wire wicket and bend them
90 toward center.

6. Tuck the ends of the bent wire wicket under the tab

on the back of the bag hanger.

7. Remove the cardboard from the front of the bags and

hang bags in place.