Manitowoc Ice GSI 200 User Manual

GSI 200 TIMER/BACK COVER REPLACEMENT

Installation Instructions

REPLACING THE TIMER CIRCUIT BOARD REQUIRES REPLACEMENT OF THE BACK PANEL

Timer Housing Back Cover

Timer Circuit Board

All Models

1. Install two (2) fresh AA batteries in timer housing

noting proper polarity (+/-).

POSITIVE

Verify timer circuit board is in the correct

RESET BUTTON

position. Snapping the control board under all four legs will correctly position the control board. The circuit board is incorrectly positioned if both lights (red and green) flash at the same time when the rear cover is installed.

Manitowoc Ice, Inc. 2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8014383 Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Sheet 1 of 2 Web Site - www.manitowocice.com 03/12/03

PLACE TIMER BOARD ON

THE FOUR SUPPORTS

SNAP THE CONTROL BOARD UNDER

ALL FOUR LEGS TO SECURE

3. Verify the small key slots are on the right side

when viewed from the front of the timer housing. Align sachet holder mounting plate holes with pins in the timer cover housing and snap into place.

Upper Keyhole Slot

Lower Keyhole Slot

Attach Sachet

Mounting Plate to Back

Cover Pins

Small Keyhole Slots on right side when viewed

from front

4. Use four pan-head screws to secure the back

cover/sachet mounting plate to the timer housing.

5. Attach sachet holder to mounting plate. Final

assembly will be with sachet holder opening facing up. a. Rotate sachet holder 90 clockwise. b. Refer to table to determine if upper or lower

keyhole slots are used. Place left side pin in the sachet mounting plate keyhole.

c. Rotate sachet holder 90 counterclockwise and

place right side pin in keyhole slot.

d. Push sachet holder down into keyhole slots to

secure.

FINAL POSITION IS

WITH OPENING

FACING UP

ROTATE 90 TO

ATTACH LEFT SIDE,

THEN ROTATE TO

FINAL POSITION TO

ATTACH RIGHT SIDE

Model Correct Keyhole Slot

Q, J, or B

0200/280/320/370/420

Q, J, or B 0450/600/800/

1000/1300/1600/1800

QuietQube Models

Q0600C/Q0800C/Q1000C

IB600C/IB800C/IB1000C

Use lower keyhole slots

Use upper keyhole slots

6. Clean and sanitize ice machine and bin/dispenser.

7. Install front cover on ice machine.

8014383

Sheet 2 of 2

03/12/03