makita SKR60 service manual

SKR60 Service Manual

Table of Contents

1. Introduction ………………………………………… Page 2

2. Specification ………………………………………… Page 3

3. Laser Keypad ………………………………………… Page 4

4. Setup ………………………………………… Page 5

5. Disassemble ………………………………………… Page 7

6. Parts Replacement ……………………………… Page 13

7. Checking ………………………………………… Page 16

8. Spare parts list ……………………………… Page 15

9. Tools …………………………………………………… Page 16

Makita SKR60 Service Manual Page 1

Introduction

The SKR60 is a compact manual laser with an attached and adjustable wall
mount. It can be used in the horizontal and vertical modes, complete with
90° beam.

The SKR60 laser has these advanced features:

• Manual-leveling in both horizontal and vertical modes

• Choice of beams: rotation plane, scanning, single point

• All beam modes are grade adjustable

Makita SKR60 Service Manual Page 2

Specifications

Recommended Operational Range
(diameter)
Leveling Accuracy 3/8” at 100 ft. or 10mm at 30m
Scanning angle 2°, 8°, 25°
Power 3 x AA alkaline batteries
Battery life 40 hours
Rotation speed 0, 80, 150, 600 rpm
Weatherproof Rain and dustproof (IP65)
Laser beam 635nm Class IIIR
Size 170 x 130 x 130 mm
Weight 2.6lbs (1.2kg)
Tripod mount Standard 5/8 - II
Remote control Build-in receiver

200 ft. (60m)

Makita SKR60 Service Manual Page 3

Laser Keypad

On / Off

Rotation /

Scanning

Mode

Increase or

Decrease Rotation

Speed / Scanning

Angle

Makita SKR60 Service Manual Page 4

Horizontal Setup

1) Put the SKR60 on a flat surface or a tripod. Turn the levelling knobs X and

Y until the bubbles centre in the vials. The bubbles move in the direction
you turn the knobs. Level one vial, then the other, then made fine
adjustments to both.

2) Turn the laser on in pushing the On/Off switch on the laser keypad.

3) Adjust the rotation speed in pushing the rotation pad on the keyboard. It

may be necessary to adjust the rotation speed according to the ambient
light conditions. The laser beam is more visible in slow motion. It is possible
to stop the rotation and to point out the beam manually to view the beam
over long distance.

4) To start with scanning mode, press R/S pad. Adjust the scanning range by
pressing the laser keypad.

(X-axis vial)

(X-axis Knob)

(Y-axis vial)

(Y/Z-axis Knob)

Makita SKR60 Service Manual Page 5