Make Noise Brains User Manual
BRAINS
Limited WARRANTY:
Make Noise warrants this product to be free of defects in materials or construction for a period of one year
from the date of purchase (proof of purchase/invoice required).
Malfunction resulting from wrong power supply voltages, backwards power cable connection, abuse of the
product or any other causes determined by Make Noise to be the fault of the user are not covered by this
warranty, and normal service rates will apply.
During the warranty period, any defective products will be repaired or replaced, at the option of Make Noise,
on a return-to-Make Noise basis, with the customer paying the transit cost to Make Noise. Please contact
Make Noise for Return To Manufacturer Authorization.
Make Noise implies and accepts no responsibility for harm to person or apparatus caused through operation
of this product.
Please contact technical@makenoisemusic.com with any questions, needs & comments, otherwise...
go MAKE NOISE.
http://www.makenoisemusic.com
THANK YOU
Installation:
The Make Noise Brains is an electronic signal generator requiring 20mA of +12V
regulated power and properly formatted distribution receptacle to operate. It is designed
to be used within the euro format modular synthesizer system.
Go to http://www.doepfer.de/a100_man/a100t_e.htm for the details of this format.
To install, find 4HP of space in your euro-rack synthesizer system, on the left side of the
Pressure Points to be expanded. Make all jumper settings on both BRAINS and the one or
two Pressure Points to be connected to BRAINS. Connect the EXPND cable between
BRAINS and Pressure Points number 1 (points 1-4). If there will be a second Pressure
Points, connect EXPND cable number 2 (points 5-8), and connect CHAIN cable between the
two Pressure Points. Now, plug the 16pin power cable into the euro-rack style power
distribution board, minding the polarity so that the RED stripe on the cable is oriented to the
NEGATIVE 12 volt supply line.
Please refer to your case manufacturers’ specifications for location of the negative supply.
Please see next page for further installation instructions.
Loading...