Philips CNC – 432 (Maho)
NCnet 7.0 settings
Set these parameters on the machine
116= 2400
117= 2400
To set the controller in the Drip-feed mode
Drip feed is not available on this controller.
Set these parameters on the PC
Machine details
Machine name |
MCH-1 |
Control system |
Maho |
Machine ID |
01 |
Communication Channel |
Serial Port |
Port Number |
Any free COM port) |
Folder for PC to Machine transfer |
Transmit directory |
Folder for Machine to PC transfer |
Receive directory |
Baud rate |
2400 |
Data bits |
7 |
Parity |
Even |
Stop bits |
2 |
Handshake |
Hardware |
General settings
Ignore this. Leave all data as it is.
Transmit settings
Wait period at start of transmission |
10.00 |
Wait period after transmitting program |
5.0 |
Size of transmit packet |
0 |
Delay period after each packet |
0 |
Wait for XON before transmitting program |
No |
Transmit comments? |
Yes |
Comment start character |
( |
Comment end character |
) |
Translation mode for CR |
Transmit as CR |
Translation mode for LF |
Transmit as LF |
Acknowledgement and error (Mode of transmission) |
Transmit descriptive message |
ACK/ERR Message start text |
% PM |
|
N9001 |
ACK/ERR Message start text |
M30 |
|
% |
Filter Null Character |
Yes |
Page 1 of 3
Loading...