Magnavox MD699 Owner's Manual
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXP OS E THIS PRODUCT TO RAIN
OR MOISTURE.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, AND ANNOYING INTERFERENCE, USE THE
RECOMMENDED ACCESSORIES ONLY.
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
EMOVE COVER (OR BACK). NO USER-SERVICEABLE
ART
NSIDE
EFER SERVICING T UALIFIED
ERVICE PERSONNEL.
The lightning flash with arrowhead symbol
within an equilateral triangle is intended to alert
the user to the presence of uninsulated
dangerous voltage within the product`s
enclosure that may be of sufficient mag ni tu de t o
constitute a risk of electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance(servicing) instructions in the
literature accompanying the appliance.
S
I
P
S
O Q. R
R
2
Before using the unit, be sure to read all operating instructions carefully. Please note that these
are general precautions and may not pertain to your unit.
For example, this unit may not have the capability to be connected to an outdoor antenna.
1) Read these instructions.
All the safety and operating instructions should be read before the product is operated.
2) Keep these instructions.
The safety and operating instructions should be retained for future reference.
3) Heed all warnings.
All warnings on the product and in the operating instructions should be adhered to.
4) Follow all instructions.
All operating and use instructions should be followed.
5) Do not use this apparatus near water.
Do not use this product near water and moisture, for example: near a bathtub, washbowl, kitchen
sink or laundry tub; in a wet basement; or near a swimming pool.
6) Clean only with dry cloth.
Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a dry cloth for cleaning.
7) Do not block any ventilation openings. Install in accordance with the manufacturer' s
instructions.
Slots and openings in the cabinet and in the back or bottom are provided for ventilation, to ensure
reliable operation of the product and to protect it from overheating. These openings must not be
blocked or covered. The openings should never be blocked by placing the product on a bed, sofa,
rug or other similar surface. This product should never be placed near or over a radiator or heat
source. This product should not be placed in a built-in installation such as a bookcase or rack
unless proper ventilation is provided or the manufacturer' s instructions have been adhered to.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus( including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug
has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
10)Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11) Only use attachments/ accessories specified by the manufacturer.
12)Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold
with the apparatus. When a cart is used,
use caution when
moving the cart/ apparatus
combination to
avoid injury from tip- over.
An appliance and cart combination should be moved with care.
Quick stop, excessive force and uneven surfaces may cause the
appliance and cart combination to overturn.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
To protect your product from a lightning storm, or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This
will prevent damage to the product due to lightning and power- line surges.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain
or moisture does not operate normally, or has been dropped.
15) Power source
This product should be operated only from the type of power source indicated on the marking label.
If you are not sure of the type of power supply to your home, consult your appliance dealer or local
power company. For products intended to operate from battery power, or other source, refer to the
operation instructions.
16) Power lines
An outside antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be taken to keep from touching such
power lines or circuits as contact with them might be fatal.
IMPORTANT SAFETY INSTRUCTIONS
3
17) Overloa ding
Do not overlo ad wall outlets and extensi on cords as this can result in a ri sk o f fire or electric
shock.
18) Object an d liquid entry
Never push ob jects of any kind into the prod uct through openings as the y may touch dangerous
voltage poi nts or short out parts that cou ld result in fire or electric s ho ck. Never spill or spray an y
type of liqui d on the product.
19) Outdoor a ntenna grounding
If an outside a ntenna is connected to the pr oduct, be sure the antenna sy stem is grounded so as to
Provide som e protection against volt age surges and built up stati c ch arges. Section 810 of the
National El ectric Code ANSI/NFPA 70 provides information wi th respect to proper ground ing
of the mast and s upporting structure, gr ounding of the lead- in wire to an an tenna discharge produ ct ,
size of groun ding conductors, locati on of antenna- discharge prod uct, connection to ground ing
electrode s and requirements for the gr ounding electrodes.
20)Service
Do not attemp t to service this product you rself as opening or removin g co vers may expose you to
dangerous v oltage or other hazards. Re fer all servicing to qualif ied service personnel.
21)Replaceme nt parts
When replac ement parts are required, b e sure the service technici an u ses replacement parts
specified b y the manufacturer or those t hat have the same character is tics as the original part s.
Unauthori zed substitutions may res ul t in fire or electric shock o r ot her hazards.
22)Safety ch ec k
Upon comple tion of any service or repair s to this product, ask the serv ic e technician to perform
safety chec ks t o determine that the prod uct is in proper operating co nd ition.
3
24)Damage requ ir ing service
Unplug this p roduct from the wall outlet a nd refer service to qualifi ed service personnel unde r the
following c onditions.
a) When the pow er- supply cord or plug is damage d.
b) If liquid ha s been spilled or objects hav e fallen into the product.
c) If the produ ct has been exposed to rain or wa ter.
d) If the produ ct does not operate normall y by following the operatin g instructions. Adjust on ly
those contr ols that are covered by the ope rating instructions, as a n adjustment of other
controls ma y result in damage and will req uire extensive work by a qual if ied technician
to restore th e product to its normal opera tion.
e) If the produ ct has been dropped or the cabi net has been damaged.
f) When the pro duct exhibits a distinct ch ange in performance- this ind icates a need for service.
2 )Note to CATV s ys tem installer
This remind er is provided to call the CATV system installer' s attention t o Article 820- 40 of the
NEC that prov ides guidelines for prope r grounding and, in particu lar, specifies that the cab le
ground shal l be connected to the groundi ng system of the building, as c lose to the point of cable
entry as prac tical.
NOTE: Refer a ll servicing to qualified s ervice personnel. Servi cing is required when
the unit has be en damage
n any way such as t he following: the power-s upply cord
or plug has bee n damaged, liquid has bee
pilled into u nit, the unit has been
exposed to ra in or moisture, the unit has be en droppe
r the unit doe
ot operate no rmally.
IMPORTANT SAFETY INSTRUCTIONS
d
i
n
s
d
o
s
n
4
Top View
Location of Controls
E
N
I
I
N
L
B
O
T
N
O
H
P
LINE IN
HEADPH ONE
ON
OFF
1 2 3
4
5
6
7
8
9
10
11
12
13
1. Turntable platter
2. Turntable center spindle
3. 45 RPM adapter
4. Lever
5. Tone arm holder
6. LINE IN jack
7. Speed selector
8. Function knob
9. Tone arm
11. Indicators
12. HEADPHONE jack
13. Stylus
14
15
16
18
16
LINE
OUT
R
L
19
18. DC IN jack for main unit
19. LINE OUT jacks
14. Metallic buckle
15. Handle
16. Speakers
10.Power ON-OFF/
Volume knob
INDICATOR
DC IN
DC 9V,1300mA
17
DC IN
5
DC 9V,1300mA
Front View
Rear View
17. DC IN jack for
Decorative LED lights
Loading...