Page 1
IMPORTANT- PLEASE KEEP FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR
I FAL ION INSTRUCTI(:
READ "SAFETY INSTRUCTIONS" IN USE AND CARE BOOK BEFORE USING OVEN.
In orderto assurethe best resultsin service, properoperationand maximum efficiency,the originalinstallation and
adjustmentshouldbe made byyourdealer,his authorizedagent,or by yourlocalutilitycompanybeforeyouattemptto
operatetheoven,
LOCATION
Placeovenwhere itwillbewelllighted.For properbaking and cookingresults, ovenmustbelevel.Use aspiritleveloncenter
oven rack to level. THIS ELECTRIC OVEN IS APPROVED FOR INSTALLATION IN COMBUSTIBLE CABINETRY.SEE
INSTALLATIONDIAGRAM FOR THE OVEN ON THE FOLLOWING PAGES. CAUTION: Some cabinets and building
materialsare not designedto withstandthe heatproduced bythe normal safeoperation ofa listed appliance. Discoloration
ordamage, such as delamination, may occur.
OUTSIDE WIRING
Your local Utility Company will tell you whether the present electric
servicetoyour homeis adequate. Itmay benecessaryto increase the
size of the wiring to the house and service switch to take care of the
electrical loaddemanded bytheoven and/ortop section.The wattage
(K.W.rating) load for the oven is specified on the name plate on the
unit.
HOUSE WIRING
Most local Building Regulations and Codes require that all electrical
wiringbe done by licensed electricians. All wiringshould conform to NEUTRALJ
Localor National ElectricalCodes. This oven requires a single phase (POWERSUPPL_
three wire 120/240 or a 120/208volt, 60 Hz, AC circuit.Wiring codes RANGEGROUNDED
requirethat a separate circuit be runfrom the mainentrance panel to THROUGHNEUTRALCONDUCTOR
theoven and that it beequipped with separate disconnect switch and
fuses, either in the main entrance panel or in a separate switch and
APPROVED
CONNECTO RANGE CONDUIT
3-WIRE
RANGE CONNECTIONS RE BLACK
The flexible armored conduit supplied with the oven must be
connected to an approved electrical junction box by means of an WHITE BARE
approved conduit to box connector. THE FRAME OF THE OVEN IS
GROUNDED TO NEUTRAL ONLY WHEN THE WHITE AND BARE APPROVEOBOX
WIRES AT THE END OF OVEN CONDUIT ARE JOINED L1 APPROVED
TOGETHER.Connect the whiteand barewire atthe end ofthe oven CONNECTION
fusebox. _!
conduit to the neutral (white) wire of the branch circuit. If used in a ' "_
MOBILEHOME or ifLOCAL CODEdoes notpermit grounding through , BRANCHCIRCUIT
theneutral conductor,the whiteand bare wires atthe end ofthe oven (POWERSDPPL_
conduit shall NOT be connected. Use bare wire to ground range in L_'--SEPARATEGROUND
accordance with local code. The whitewire must beconnected to the
neutral wire of the branch circuit. The red and black wires must be THROUGHNEUTRALCONDUCTOR&ALSOREQUIREDIN
connected to the remaining two conductor of the branch circuit. MGBILEHDMES
Connectall wires to the branchcircuitwith approved connectors. Use 4-WIRE
only COPPER wire for the branch circuit.
WIRINGMETHODIFCODEDOESNOTPERMITGROUNDING
NEUTRAL_ I_I_L2
WARNING:
BE SURE OVEN IS DISCONNECTED FROM POWER SUPPLY BEFORE EXAMINING ANY OF THE ELECTRICAL
EQUIPMENT.
8101P235-60
(05-96-00)
Page 2
SINGLE 30" WALL OVEN INSTALLATION
_OPENING
ENTER JUNCTION
AFTER UNIT I$ BOX AT LEFT SIDE.
CABINET-- _'-'_/ OVEN PROVIDE FOR
=_===_=====_=_ "// ALL_ FOR Y _ _ -- ELECTRICAL CONNECTION
AD_TER_ _;_ "// IN CORNER SIDE. 4 SO. BOX
SIDE TRIM- _ /// PROVIDED FOR _ " 90*JUHCTI_ELB_TU_NEDBOX"STD.
• IN PLACE OPEN
,i/
//" UNIT TRIM
WITH SCR_
// AND ADAPTER
ToSEC_EcABINETOVEN EACH1/4" _"M'-/'/'- 120/240,. 120/208 VOLT
_" _/'/ OF SIDE TRIM, ." -1 ATTACHToRIGHTOVENsIoECONDUIToF
ADAPTER IS _
OVERLAP
!_.,w _ I DOWN REQUIRED.
IN THIS AREA.
22 11\16" FROM SHELF
NYLON GRIP NUTS THAT _ _ ,"_" :
IMP_TANT 2_ -_------_a_/G- , TOBOTTOMFkooROFDOX.
MUST BE REMOVED _30 t/8 MAX_ _ . RECO_ENDED TO
BEFORE INSTALLATION_ I" _'_"_-_--'_-_-" _2¢"PREVENTMIN,UNUSUAL DRAFTS.
28 5q6" 34" RECOMMENDED HEIGHT
HOLD CRATE DOTT_ _f2_4,,_ 30" _IN _._/------COMPLETE
30 _ _ _ _ x_'-- FLOOR SURFACE.,'_... -_1._:_,_,°
DO NOT COVER _ BL_K OVEN DOOR_',._. --
AREA UNDERNEATH L_EST
FRONT TRIM OF OVEN. CABINET WALL_
SEE SIDE DETAIL, TRIM"_- "--
OVEN SIDE TRIM'-_
IS
A,BF_OW_,_. D_I_
SINGLE 30" UNDERCOUNTER INSTALLATION
GAS OR ELECTRIC C_KTOPS _Y BE INSTALLED OVER THIS
OVEN, SEE COOKT_ JNSTALLATI_ JNSFR_TI_$ FOR CUTOUT
SIZE. SEE LABEL ON BACK OF OVEN FOR APPROVED C_KTOP _DELS.
NYLIoNM_T_?THA, t------ _B_TW:_TT_I_TER JUNCTION
HOLD CRATE BDTT_
H,TBEREVEO \\o. DOCOTOOTOPER'
OEORE,HSTA.AF,OH.
24" MIN. _ _ _'_ I I_BOX " /UPPER _ MIDDLE RIGHT SIDE
INSIDE j OF JUNCTIONS BOX; STD. DO*
, _ _ _ _j._ -"/ _LBOW TURNED O0'_N REQU RED
28 1 B' MIN. _ I
29 11 16" MIN. FROM TOP OF =_ I TO BOTTOM OF BOX.
C_HT_R _EN USED BEL_ _ _ --I _ "
ELECTN,CCDOKT .=,,N. C,,,ETTO,.
FR_ TOP OF COUNTER _EN _ _" //
USED BEL_ GAS COOKTOP -" " _>" t.I ,Z_
' i I '_"
_" _'_ / 4" SQ _ATTACH OVEN CONDUIT TO
_.--- 211,lO"FN TOPOFSLAT
_%AOOT'O_ALHg_gN_gR "-<--<.....<///._/j.._-'-._, / --
is EDEO FO U " - ""'_'_/ _ _AS A LECT
INSTALLATION, SEE TOP TRIM DETAIL. _,_ "''. _ _ NO E R,C
/
=_, _ _ _ N AN ADJACENT ACCESSIBLE
I _ RECOMMENDED. / _ ---
_.,.__ I _' - INPLACEO-_H
"_. _ / .... -,--'m-._- r_ooR CA_INET--_yT/OV_NO_R._
_0 ..... _ / OVEN DOOR-'_ ' _ SURFACE =_--_-" /_ TO CABINET
3 1/2" __ I / /
_ _ --_ \ i ADAPTER_ i // AND ADAPTER
DO NOT COVER OR BLOCK AREA OVEN SIDE TRIM_.,,._ _ _ _"_'_3_ / / "
UNDERNEATH LOWEST FRONT TRIM. AD TER S
SEE SIDE DETAIL AIRFL_ ........ SIDE SIDE TRIM-_-_ , , / pRAP
, ....... OV,OEDFOR
CABINET WALL_ _ _-- WITH SCR_
OVEN FRONT TRIM ...... I THRO_H HOLE
_._DETAIL EACH SIDE.
_ _ CONNECTIONS FOR GAS
!LOCATION./30' MIH. ,_
AFTER UNIT IS
SECURE OVEN
/ / ONE SCR_ AND
-2-
Page 3
DUAL 30" WALL OVEN INSTALLATION
FRONT OF
CABINET OVEN DOOR. ELECTRICAL CONNECTION
ADAPTER AND ADAPTER
S_DEDETR_M ADAPTER IS 90" ELBOW TURNED
T_M I4Y:_R___'a_ _/// ONE SCREW AND JUNCTION BOX; STD.
AFTER UNIT IS 120/240, 120/208 VOLT
SECURE OVEN ALLOW FOR 1/4" iN THIS AREA.
TO CABINET UNIT TRiM
WITH SCREW OVERLAP EACH 4" SQ. BOXES.
THROUCHHOLE
IN CORNER _TTACH OVEN CONDUIT
OF SIDE TRIM. TO RIGHT SiDE OF
IN PLACE OPEN
PROVIDED FOR DOWN REQUIRED.
EACH SIDE.
IMPORTANT _ USEOF3 l/Z" W_OE
HOLD CRATE BOTTOM _ SiDE RECOMMENDED,
MUST BE REMOVED
28 BOX AT LEFT BIDE.
BEFORE (NSTALLATION._
30 FLOOR SURFACE,
NYLON GRiP NUTS THAT _- SLATS ON EACH
I_I_0_T/LI'_ " AIR FLOW AREA,
DO NOT COVER OR BLOCK OVEN DOOR-',.=,. 33" MIN.
AREA UNDERNEATH LOWEST
FRONT TRIM OF OVEN.
SEE S_DE DETAIL, OVEN FRONT TRIMs,
OVEN SIDE TRIM-_
AIRFLOW"_..._ ,L._DETAIL
SIDE
_OPENING
PROVIDE FOR
22 11\16" FROM SHELF
TO BOTTOM OF BOX.
WiRE TO
ENTER JUNCTION
DUAL 30" UNDERCOUNTER INSTALLATION
CABINET WALL
OVEN FRONT TRIM
OVEN SIDE TRIM
AIRFLOW
OVEN DO0_
SIDE DETAIL
JUNCTION BOX STANOARD gO"
ELBOW TURNED DOWNREQU RED.
USE OF 3
ON EACH T1/16" EROM TOP OF SLAT
DETAIL
28i__ IMPORTANT
_'_ IMPORTANT AIR PLOW AREA,
CABINET OVEN DOOR.
ADAPTER THROUGH HOLE
SIDE TR ADAPTER IS
BE IIYO.ESOR
i. EACH SIDE.
SECURE OVEN
TO CABINET
WITH SCREW
AND ADAPTER
(N CORNER
OF SIDE TRIM.
IN PLACE OPEN
PROVIDED FOR
--3-
Page 4
TOP TRIM DETAIL
VVHENADDITIONAL CLEARANCEIS NEEDED
FORUNDERCOU_TERINSTALLATIONS:
I. REMOVE THE (2) SCREWS FROklEACH END
OF SIDE TRIM.
2. REMOVE TOP TRIM FR_ WALL OVE_,
3. BREAKAWAYTHE FLANGEOF THE TOP TRIM.
4. RE-INSTALL TOP TRIM.
30"WALL OVEN/MICROWAVECOMBO INSTALLATION
_OPENING
I_)RT_T
NYLON GRIP NUTS THAT
HELD CRATE BOTTOM
MUST B£ REMOVED
BEFORE INSTALLATION.
FRONT OF CABINET--
ALLOW FOR 1/4" UNIT
OVERLAP EACH SIDE.
HOUSE WIRE TO ENTER CABINET
CUTOUT AREA ABOVE LOCATION OF
JUNCTION BOX THEN ENTER LEFT
SIDE OF JUNCTION BOX.
MAY REQUIRE REROUTING OR 42
RECESSING HOUSE WIRE ON 42
REPLACEMENT INSTALLATIONS. WIRES TO
PROVIDE FOR ENTER TOP OF
120/208 VOI
CONNECTION IN THiS AREA.
COMPLETE FLOOR IS
TO PREVENT UNUSUAL DRAFTS. 23"
43
-CUTOUT
JUNCTION BOX.
RECOMMENDED
HEIGHT
i/8" /I / ' OVEN TO CABINET
THROUGH HOLES PROVIDED
IN TRIM WITH FOUR SCREWS
SHIPPED WITH UNtT.
3o --...@
--4--
Loading...