Lynx LIJ27, LIJ54, LIJ30, LIJ36, LIJ42 Installation Guide

LYNX GRILLS INSULATED JACKET INSTALLATION INSTRUCTIONS

y 

IMPORTANT:efore you build the frame, you must take into consideration the total weight of the liner, grill and an

nishing materials

Refer to the table below for the proper framing dimensions for the insulation jacket. Determine the entry point for both the gas inlet and electrical connections. Make the 4” square holes for gas and electrical connections (rear or bottom access) based on your requirements. Note that the electrical connections are located on the left side and the gas connections are located on the right side.

A Carpenter’s “spirit level” should be used to assure that the framing is level, both front to back and side to side.

Note: Never under any circumstance should you install the transformer or run a quick disconnect hose in-between the grill and the inside of the insulating jacket.

Model A B C D E F LIJ27 33 5 23 ¾ 4 ½ 3 11

5/8

LIJ30 36 5 26 ½ 4 ½ 3 11 5/8

LIJ36 42 5 23 ¾ 4 ½ 3 11 5/8 LIJ42 48 5 26 ½ 4 ½ 3 11 5/8 LIJ54 60 5 26 ½ 4 ½ 3 11 5/8

LINER INSTALLATION

Posititon the liner into the frame. No part of the combustible enclosure can protrude above the top surface or in front of the face surface of the liner. Shim the liner if necessary.

GRILL INSTALLATION

Use the proper equipment to support the grill. Place the grill into the liner and engage it over the liner lip across the back and sides. The liner is designed to support the grill without additional fasteners.

FINISHING

If desired any gap remainng between the liner and the combustible enclosure may be  lled with a non-combustilble sealant or caulk.

1” Screws can be provided to help straighten out the sides of the

LIJ if necessary. Contact customer service for details

” square holes for gas nd electrical connections

both left and ri

rear or bottom access).

ke these holes in the frame based on requirements

ht sides

our

P/N 35030 Rev A. 2018