Lynx LHEM48 Owners Manual
Mooddeell
M
Noo.. LL
N
HPP
H
M
M
Infrared Outdoor Patio Heater
Manual for Installation, Operation & Maintenance
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to appliance.
2. Extinguish any open flame.
3. If odor continues, immediately call your
gas supplier.
WARNING: Improper installation, adjustment, alteration,
service or maintenance can cause injury or property damage.
Read the installation, operating and maintenance instructions
thoroughly before installing or servicing this equipment.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
*FOR OUTDOOR USE ONLY
* The Lynx Patio heater has been approved for indoor use in non-residential
applications (See page 8 for details)
Please retain these instructions for future reference.
IMPORTANT: The installer must leave these instructions with
the owner. Only those who are certified to do so should
perform service on these heaters.
LT087
INDEX
1) Caution and General Safety ............................................................................ 4
2) Pre-installation Overview ................................................................................ 5
3) What you need to supply ................................................................................. 7
4) Location Planning ............................................................................................. 8
5) Clearance to Combustible Materials................................................................. 9
6) Installation Instructions ................................................................................... 10
Equipment dimensions.............................................................................. 10
Power/Gas Specification...........................................................................11
7) Assembly ....................................................................................................... 12
8) Wiring ............................................................................................................18
8) Lighting and Shutdown Instructions ............................................................... 19
9) Maintenance and Trouble Shooting .............................................................. 20
10) Parts List ...................................................................................................... 21
11) Internal Wiring Diagram ...............................................................................22
12) Warranty ......................................................................................................23
Lynx Page 3 Rev. 3/06/08
Caution and General Safety
• At all times maintain clearance to combustible materials as further
• Never operate heaters in atmosphere containing flammable vapours or
• This heater is equipped with an electronic and automatic ignition device.
• Certain materials, when stored under this heater are subjected to radiant
• Appliance surfaces, other than the obvious flame and emitter surfaces,
• Children should be strictly supervised when in the area of this heating
• Clothing or other flammable materials should not be hung on or near this
CAUTION: FIRE OR BURN INJURY HAZARD
specified in this manual. Failure to do so can result in serious fire hazard.
combustible dusts.
Do not attempt to light the burner by hand. Failure to comply can result in
a serious fire and personal injury hazard.
heat can soften, distort or otherwise be damaged, special care should be
taken of plastic materials
attain elevated temperatures during operation. Do not touch the heater
head during operation. Everyone should be alerted to this hazard to avoid
burning.
appliance. Playing or running around the structure should be strictly
forbidden.
heater.
Lynx Page 4 Rev. 3/06/08
Pre-installation Overview
What you will receive:
Top Reflector
Heater head Assembly
Pole Assembly
Hardware
Lynx Page 5 Rev. 3/06/08
Pre-installation Overview
Mounting Plate hole Pattern
(Full size)
4.42"
6.25"
Ø0.40"
Lynx Page 6 Rev. 3/06/08
What you need to Supply:
1. Heater post anchoring hardware.
2. Materials necessary to construct a concrete base for floor mounting.
3. Gas supply line that is installed to the Gas and Electric Supply according to the:
National Fuel Gas Code, ANSI Z.223.1 (NFPA 54) in the US and CAN/CGA
B149.1 and B149.2 Installation Codes in Canada.
4. Electrical supply rated at 24 Vac with two stage control
What you need to Supply
Lynx Page 7 Rev. 3/06/08
Loading...