Simply Connected
Quick Install Guide
AMS-2616P
AV Series 26-Port Gigabit
Managed PoE+ Switch
Use the AMS-2616P to:
Add 802.3af/at PoE+ Capability to Your
AV Rack Solutions
Deliver Power and Data for up to
16 PoE-Enabled Network Devices at a
Maximum Output of 250 Watts
Simplify PoE Device Installation, Including
IP Security Cameras, VoIP Devices, and
Wireless APs
Optimize and Protect Your Network with
Advanced VLAN, QoS and Network
Security Features
AMS-2616P
Quick Install Guide
Quick Install Guide
Model Number: AMS-2616P
AV Series 26-Port Gigabit Managed PoE+ Switch
© 2015 Luxul. All Rights Reserved.
No part of this publication may be modified or adapted in any way, for any
purposes without permission in writing from Luxul. The material in this manual
is subject to change without notice. Luxul reserves the right to make changes to
any product to improve reliability, function, or design. No license is granted, either
expressly or by implication or otherwise under any Luxul intellectual property rights.
An implied license only exists for equipment, circuits and subsystems contained in
this or any Luxul product.
DOCUMENT CONVENTIONS
These graphical alerts are used in this document to indicate notable situations:
NOTE: Tips, hints, or special requirements that you should take note of.
CAUTION: Care is required. Disregarding a caution can result in data
loss or equipment malfunction.
WARNING!: Indicates a condition or procedure that could result in
personal injury or equipment damage.
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CONTACT LUXUL
Sales
P: 801-822-5450
E: sales@luxul.com
2
14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
Technical Support
P: 801-822-5450
E: support@luxul.com
LUX-QIG-AMS-2616P-v2 026151104
Simply Connected
PACKAGE CONTENTS
The following items are included in the box:
AMS-2616P AV Series 26-Port Gigabit Managed PoE+ Switch
Power Cord
Rack Mount Brackets and Screws
Four Rubber Foot Pads
Quick Installation Guide
If any of the listed items are missing or damaged, please contact the Distributor
from whom you purchased for return/replacement.
HARDWARE DESCRIPTION
Front Panel
The front panel of the AMS-2616P Switch includes dual colored Link/Activity LEDs
that can be switched from green to blue. In addition, the front panel has Link/
Activity and PoE mode indicators as well as System and Power LEDs.
AMS-2616P Front Panel View
Rear Panel
The rear panel of the AMS-2616P Switch includes 1 console port, 24 1000Mbps
RJ45 and 2 RJ-45/SFP combo ports, as well as LED indicators for each port. Each
1000Mbps port has one Link/Activity/PoE LED. A mode/reset button switches the
display between Link/Activity and PoE modes.
AMS-2616P Rear Panel View
Power Input: Please use the included power cable
© 2015 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
3
AMS-2616P
Quick Install Guide
NOTE: Ports 1-8 are non PoE, ports 9-24 are PoE. All PoE Ports. are
enabled as PoE+ and low priority and Max power at 30W. This
results in a 480W allocation but with the management set to
“actual consumption” the PE units should power up until they hit
the 250W power budget limit.
LED Indicators
Each port has one Link/Activity/PoE LED. A mode/reset button on the rear panel
switches the LED display between Link/Activity and PoE modes.
LED Indicators
LED indicators show the working status of the switch. The following table describes the LED functionality:
Indicator
Name
Power
System
Link Act/
PoE Mode
4
Description
Front
On This LED indicates that there is power to the AMS-2616P
Off If LED is off, check the power connection on the back of the
unit
Flashing Indicates that the AMS-2616P is running normally
On Indicates a malfunction. Contact technical support
Off Indicates that the AMS-2616P is in startup and initialization
process or is not on
Link Activity Port LED’s display Link/Activity status
PoE Port LED’s display PoE status
14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-QIG-AMS-2616P-v2 026151104
Loading...