Lotos LSSS01 User Manual

LOTOS TECHNOLOGY

Shrinker & Stretcher LSSS01

www.uwelding.com

TABLE OF CONTENTS

SPECIFICATIONS…………………………………………………………………1
SAFETY RULES………………………………..……………………………………1
FEATURES…………………………………………………………………………2
ASSEMBLY… … … … … … … … … … … … … … … … … … … … … … … … . 3
OPERATION INSTRUCTIONS………………………………………………..3
The Basic Panel Fabrication… … … …… … … … … … … ………..………..3

Cautions…..…………...…………………………………………………………….4
MAINTENANCE……………………………………………………………………4
PARTS LIST & DIAGRAM……………………………………………………….5

Operation

Hand operated or Foot pedal

Capacity(mm/gauge)

1.2/18 Mild steel,1.5/16 Aluminum

Throat(mm/in)

25.4/1

When using tool, basic safety precautions should always be followed to reduce
the risk of personal injury and damage.

WARNING

You will need the manual for the safety warnings and precautions, assembly
instructions, operating and maintenance procedures, parts list and diagram.
Keep the manual and invoice in a safe and dry place for future reference.

SPECIFICATIONS

SAFETY RULES

Read all instructions before using this tool!

1. Keep work area clean. Cluttered areas may cause injuries.

2. Observe work area conditions. Do not use machines or power tools in damp or

wet locations. Do not expose to rain. Keep work area well-lit. Do not use electrically
powered tools in the presence of flammable gases or liquids.

3. Keep children away. Children must never be allowed in the work area. Do not let

them handle machines, tools, or extension cords.

4. Store idle equipment. When not in use, tools must be stored in a dry location to

prevent rust. Always lock up tools and keep out of reach of children.

5. Do not force tool. Tool performance is more efficient and safer being used at the

rate for which it was intended. Do not use inappropriate attachments in an attempt
to exceed tool capacity.

6. Use the right tool for the job. Do not attempt to force a small tool or attachment

to do the work of a larger industrial tool. Do not modify this tool and do not use this
tool for a purpose for which it was not intended.

7. Dress properly. Do not wear loose clothing or jewelry as they can be caught in

moving parts. Protective, electrically non-conductive clothes and non-skid footwear
are recommended when working. Wear restrictive hair covering to contain long hair.

8. Use eye and ear protection. Always wear ANSI approved impact safety goggles.

Wear a full face shield if you are producing metal filings or wood chips. Wear an
ANSI approved dust mask or respirator when working around metal, wood, and
chemical dusts and mists.

9. Do not reach over. Keep proper footing and balance at all times. Do not reach over

or across running machines. Keep hands and fingers clear of the Dies when
operating.

1