Safety Data Sheet
Product name: Loctite Super Glue
1. PRODUCT AND COMPANY IDENTIFICATION
Henkel Corporation
One Henkel Way
Rocky Hill, Connecticut 06067
Telephone: +1 (800) 624-7767
MEDICAL EMERGENCY Phone: Poison Control Center 1-877-6714608 (toll free) or 1-303-592-1711 TRANSPORT EMERGENCY
Phone: CHEMTREC 1-800-424-9300 (toll free) or 1-703-527-3887
2. HAZARDS IDENTIFICATION
BONDS SKIN IN SECONDS.
COMBUSTIBLE LIQUID.
CAUSES EYE IRRITATION.
MAY CAUSE RESPIRATORY IRRITATION.
SPECIFIC TARGET ORGAN TOXICITY - SINGLE EXPOSURE
Keep away from heat, sparks, open flames, hot surfaces - no smoking. Avoid breathing vapors,
mist, or spray. Wash thoroughly after handling. Use only outdoors or in a well-ventilated area.
Wear protective gloves, eye protection, and face protection.
IF INHALED: Remove person to fresh air and keep comfortable for breathing.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if
present and easy to remove. Continue rinsing. Call a poison control center or physician if you
feel unwell. If eye irritation persists: Get medical attention. In case of fire: Use foam, dry
chemical or carbon dioxide to extinguish.
Store in a well-ventilated place. Keep container tightly closed. Store in a well-ventilated place.
Keep cool. Store locked up.
Dispose of contents and/or container according to Federal, State/Provincial and local
governmental regulations.
Classification complies with OSHA Hazard Communication Standard (29 CFR 1910.1200) and is consistent with the provisions of the
United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS).
See Section 11 for additional toxicological information.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Page 1 of 6
Product name: Loctite Super Glue
* Exact percentage is a trade secret. Concentration range is provided to assist users in providing appropriate protections.
Move to fresh air. If breathing is difficult, give oxygen. If not breathing, give
artificial respiration. If symptoms develop and persist, get medical attention.
Do not pull bonded skin apart. Soak in warm soapy water. Gently peel apart
using a blunt instrument. If skin is burned due to the rapid generation of heat
by a large drop, seek medical attention. If lips are bonded, apply warm water
to the lips and encourage wetting and pressure from saliva in mouth. Peel or
roll lips apart. Do not pull lips apart with direct opposing force.
Immediately flush with plenty of water for at least 15 minutes. Get medical
attention. If eyelids are bonded closed, release eyelashes with warm water by
covering with a wet pad. Do not force eye open. Cyanoacrylate will bond to
eye protein and will cause a lachrymatory effect which will help to debond the
adhesive. Keep eye covered until debonding is complete, usually within 1-3
days. Medical attention should be sought in case solid particles of polymerized
cyanoacrylate trapped behind the eyelid caused abrasive damage.
Ensure breathing passages are not obstructed. The product will polymerize
rapidly and bond to the mouth making it almost impossible to swallow. Saliva
will separate any solidified product in several hours. Prevent the patient from
swallowing any separated mass.
Surgery is not necessary to separate accidentally bonded tissues. Experience
has shown that bonded tissues are best treated by passive, non-surgical first
aid. If rapid curing has caused thermal burns they should be treated
symptomatically after adhesive is removed.
5. FIRE FIGHTING MEASURES
Foam, dry chemical or carbon dioxide.
Special firefighting procedures:
Wear a self-contained breathing apparatus with a full face piece operated in
pressure-demand or other positive pressure mode.
Unusual fire or explosion hazards:
Hazardous combustion products:
Trace amounts of toxic and/or irritating fumes may be released and the use of
breathing apparatus is recommended.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions:
Ventilate area. Do not allow product to enter sewer or waterways.
Page 2 of 6