Loctite B1613334 User Manual
Safety Data Sheet
Revision Number: 001.1
Issue date: 12/12/2014
IDH number: 1270884
Product name: Loctite® Fun-Tak® Mounting Putty
1. PRODUCT AND COMPANY IDENTIFICATION
Product name:
Loctite® Fun-Tak® Mounting Putty
IDH number:
1270884
Product type:
Not available.
Restriction of Use:
None identified
Region:
United States
Company address:
Contact information:
Henkel Corporation
One Henkel Way
Rocky Hill, Connecticut 06067
Telephone: +1 (800) 624-7767
MEDICAL EMERGENCY Phone: Poison Control Center 1-877-6714608 (toll free) or 1-303-592-1711 TRANSPORT EMERGENCY
Phone: CHEMTREC 1-800-424-9300 (toll free) or 1-703-527-3887
2. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
NOT CLASSIFIED. READ ENTIRE SAFETY DATA SHEET.
HAZARD CLASS
HAZARD CATEGORY
None
None
PICTOGRAM(S)
None
Precautionary Statements
Prevention:
Not prescribed
Response:
Not prescribed
Storage:
Not prescribed
Disposal:
Not prescribed
Classification complies with OSHA Hazard Communication Standard (29 CFR 1910.1200) and is consistent with the provisions of the
United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS).
See Section 11 for additional toxicological information.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous Component(s)
CAS Number
Percentage*
Mix of polyisobutenes, polybutenes,
calcium carbonates, paraffinic oil &
stearic acid~
60 - 100
* Exact percentage is a trade secret. Concentration range is provided to assist users in providing appropriate protections.
4. FIRST AID MEASURES
Inhalation:
Move to fresh air in case of accidental inhalation of vapours.
Skin contact:
Wash affected area immediately with soap and water.
Eye contact:
Immediately flush eyes with plenty of water for at least 15 minutes. If
symptoms develop and persist, get medical attention.
Page 1 of 5
IDH number: 1270884
Product name: Loctite® Fun-Tak® Mounting Putty
Ingestion:
Consult a physician if necessary.
Symptoms:
See Section 11.
5. FIRE FIGHTING MEASURES
Extinguishing media:
Carbon dioxide, foam, powder Water fog.
Special firefighting procedures:
Use water spray to keep fire exposed containers cool and disperse vapors.
Unusual fire or explosion hazards:
None expected.
Hazardous combustion products:
Oxides of carbon.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions:
Not available.
Clean-up methods:
Absorb spill with inert material. Shovel material into appropriate container for
disposal.
7. HANDLING AND STORAGE
Handling:
Avoid prolonged or repeated skin contact with this material. Keep out of the
reach of children.
Storage:
Not available.
For information on product shelf life, please review labels on container or check the Technical Data Sheet.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous Component(s)
ACGIH TLV
OSHA PEL
AIHA WEEL
OTHER
Mix of polyisobutenes, polybutenes,
calcium carbonates, paraffinic oil &
stearic acid~
None
None
None
None
Engineering controls:
Use local ventilation if general ventilation is insufficient to maintain vapor
concentration below established exposure limits.
Respiratory protection:
None necessary.
Eye/face protection:
Safety goggles or safety glasses with side shields.
Skin protection:
Suitable protective clothing
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state:
Putty-like
Color:
Blue
Odor:
Characteristic
Odor threshold:
Not available.
pH:
Not available.
Vapor pressure:
Not available.
Boiling point/range:
Not available.
Melting point/ range:
Not available.
Specific gravity:
1.8000
Page 2 of 5
Loading...