Loctite 050A, 916282 Operation Manual

EQUIPMENT

Operation Manual



Loctite

Item Number: 916282

050A Hot Melt Dispenser

LOCTITE® 050A SAFETY RULES

PLEASE READ ALL THE SAFETY INSTRUCTIONS CAREFULLY AND
SAVE THIS OWNER’S MANUAL FOR FUTURE USE.

1. ALWAYS WEAR SAFETY GLASSES when operating electric tools. Use of electric
tools can cause severe eye injury. Wear proper safety glasses, goggles, or a face
shield when operating this tool.

2. DO NOT TOUCH heated nozzle of the dispenser or melted glue. Operating
temperature of the nozzle and melted glue is 380°F and will burn skin.

3. KEEP OUT OF REACH OF CHILDREN. Keep children and visitors out of the reach
of operating dispenser and cord.

4. DO NOT LEAVE the dispenser plugged into an electrical outlet or in a hot condition
when unattended.

5. KEEP WORK AREA CLEAN, organized and well lighted. Cluttered work areas
invite injuries. Work environment should be clean, dry and free of any flammable
materials.

6. DO NOT USE the electric dispenser in damp or wet locations. The dispenser is for
use in dry, indoor areas only.

7. DO NOT ABUSE the dispenser’s power cord. Do not pull cord from electrical outlet
or carry the dispenser by its cord.

8. DO NOT LAY the dispenser on its side when it is hot. Always use the wire stand to
keep hot nozzle and dispenser housing away from surfaces.

9. UNPLUG THE DISPENSER after use and let cool before storage. After dispenser
has air cooled to touch, store in dry area.

10. DO NOT EXPOSE dispenser to heat, oil, sharp objects or other abuse.

11. STAY ALERT. Use common sense, do not use the dispenser when you are tired or
under the influence of alcohol or any medication.

12. ONLY USE .45” diameter glue sticks in this dispenser.

13. DO NOT APPLY oil base paint or stain to hot melt glue.

TECHNICAL DATA

Electrical Supply: 120 VAC, 15 AMPS, 50/60Hz
Power Consumption: approx. 250W
Heat up time: 3-5 minutes
Operating temperature: 380ºF / 193ºC nominal
Adhesive inlet 1/2” (.45”) (12mm) nominal diameter