POWER-FIN®GAS BOILER 1.5, 1.7, 2.0 MBH MODELS
POWER-FIN
®
BOILER
Submittal Sheet
PBE-Sub-05
JOB NAME ______________________________________________________________________
LOCATION ______________________________________________________________________
ARCH./ENGR.____________________________________________________________________
MECH. CONTRACTOR ___________________________________________________________
MODEL NO. _____________________________________________________________________
TYPE GAS ______________________________________________________________________
Btu/hr INPUT__________________________________Btu/hr OUTPUT____________________
NOTES
Standard Features
• 87% Thermal Efficiency
• 25 - 100% Infinitely Proportional Firing Rate
• Digital Display w/ Alarm & Status LED’s
• Variable Frequency Drive
• Digital Temperature Control Accurate to 1ºF
• Tamper Resistant Temperature Controls
• Alcromesh Burner with 5-Year Limited Warranty
• Low NOx Operation Exceeds the most
Stringent Air Quality Requirements
• Low Gas Pressure Operation
• Selectable Supply/Return Temperature Controls
• ASME Copper Finned TubeHeat Exchanger
• 160 PSI Working Pressure
• Gasketless Heat Exchanger Design
• Pump Delay
• Glass-Lined Water Surfaces
• Low Gas Pressure Operation
• Zero Clearance to Combustible Materials
• Temperature and Pressure Gauge
• ASME Pressure Relief Valve
• Down Stream Test Cock
• Adjustable High Limit w/ Manual Reset
• Flow Switch
• Small Footprint
• 24 Volt Circuit Breaker
• Freeze Protection
• Construction Air Filter
• 10 Year Limited Warranty on Heat Exchanger
(See warranty for details)
Optional Equipment
Place an X in the box by all options that apply
Alarm Bell
Contacts on any Failure
Contacts for Air Louvers
Cupro-Nickel Heat Exchanger
High Gas Pressure Switch w/ Manual Reset
Low Gas Pressure Switch w/ Manual Reset
Indoor/Outdoor Reset
Low Water Cut-Off
Probe Type
Probe Type Manual Reset w/ Test
HARMONY SEQUENCER
1-4 Unit Master Control Module SMP2100
5-12 Unit Extension Module SMP2101
Outdoor Air Sensor SMP2102
Harmony Sequencer Ordering Information
Sequencing of up to 4 Units requires the following:
1 - SMP3100 Master Control Module
Sequencing of 5 - 12 units requires the following:
1 - SMP3100 Master Control Module
and 1 - SMP3101 Extension Module
Firing Control Systems
M9 HSI (Standard)
M13 GE GAP/FM/IRI
M7 California Code