Lochinvar EGS040 User Manual

ENERGY SAVER INDIRECT WATER HEATERS

ENERGY SAVER

INDIRECT WATER HEATER

Submittal Sheet

EGS-Sub-02

JOB NAME ______________________________________________________________________
LOCATION ______________________________________________________________________
ARCH./ENGR.____________________________________________________________________
WHOLESALER __________________________________________________________________
MECH. CONTRACTOR ___________________________________________________________
MODEL NO. _____________________________________________________________________
TYPE GAS ______________________________________________________________________
Btu/hr INPUT____________________________________________________________________
RECOVERY RATE IN GPH_______________________________________@________°F RISE
GALLON CAPACITY_____________________________________________________________
NOTES

Standard Features

• Non-CFC Foam Insulation

• Glass-Lined Steel Tank

• Large Capacity Single Wall, Glass Lined Heat Exchanger Coil

• (3) Aluminum Tank Saver Anode Rods

• Dielectric Nipples

• Adjustable Aquastat

• Temperature and Pressure Relief Valve

• Brass Drain Valve

• Warranty - Ten year limited tank warranty.

Six year warranty on parts.
(See warranty for details)



Lochinvar Corporation • 300 Maddox Simpson Pkwy • Lebanon, TN 37090 • 615-889-8900/Fax: [phone]

www.Lochinvar.com

4/07—Printed in U.S.A.

Energy Saver Indirect Water Heater Dimensions & Specifications

1st Hour 1st Hour

Gal. Rating Rating Shipping

Model Cap. @140°F @115°F A B D E F Weight

EGS030 30 204 313 33-3/4" 22" 27-1/2" 5-1/4" 11-1/2" 140
EGS040 40 210 320 36" 24" 27-1/2" 5-1/4" 11-1/2" 168
EGS050 50 217 326 36" 26" 27-1/2" 5-1/4" 11-1/2" 196
EGS065 60 223 333 59-1/4" 22" 27-1/2" 5-1/4" 11-1/2" 196
EGS080 75 234 343 59" 24" 27-1/2" 5-1/4" 11-1/2" 224
EGS120 116 261 370 62-1/2" 28-1/4" 27-1/2" 6-1/4" 11-1/2" 355

Notes: All water connections are 3/4" NPT on 8” centers. Aquastat, relief valve, and drain valve connections are 3/4" NPT.

All heat exchanger connections are 1" NPT.
All ratings are based on 180°F boiler water temperature, 50°F potable water inlet temperature and an approximate boiler output of 220,000 Btu/Hr.

Certified for Potable Water and Space Heating Applications

This water heater is suitable for water heating and space heating. Toxic
chemicals, such as those used for boiler water treatment shall NEVER be
introduced into the potable water system. This water heater may NEVER
be connected to any existing heating system or components previously
used with non-potable water heating appliances.

All models available with a Ten Year
Limited Warranty Against Tank Failure.
All parts are warranted for six years.
Three year limited warranty on all
models when installed in a commercial
application.

NOTE: The uniform plumbing code
limits the boiler pressure relief valve
to 30 psi when installing in a potable
water system.