Little Giant TE-5.5-MD-HC User Manual

TE-5.5-MD-HC

Features

n Thermally protected, totally enclosed, fan

cooled, split phase motor

n Ball bearings

n Conduit box (Must be field wired — cord not

included)

n Specific gravity to 1.1

n Fluid temperature to 180°F

Magnetic Drive

n Ambient air temperature to 77°F

n Run-dry capability up to 8 hours

NOTE: Consult your local distributor or the

factory for applications with higher ambient
temperatures, specific gravities and viscosities.

Construction

n Volute — Glass-filled Ryton

n Backplate — Glass-filled Ryton

n Impeller — Glass-filled Ryton

bushing

n Shaft — Ceramic

n Thrust Washers — Ceramic

n O-Ring — Viton

®

®

®

®

with carbon

The Little Giant MD-HC series features leakproof, seal-less magnetic drives and are designed for in-line, non­submersible use. Volute, magnet housing and impeller are glass-filled Ryton® for excellent chemical resistance.
Ceramic shaft and thrust washers are 99.5% pure alumina for excellent wear and reliable service. Pumping heads are
easily rotated, cleaned or serviced. Spindle shaft is supported at both ends to prevent impeller damage during start-up and
stop of pump.

Ryton® is a registered trademark of Chevron Phillips Chemical Company
Viton® is a registered trademark of DuPont Performance Elastomers

TE-5.5-MD-HC

NOTE: Designs and dimensions may vary for various reasons (i.e. type of motor). This information should be used as

general guide rather than an unqualified guarantee. Specifications are subject to change without prior notice.

Specifications

Model

No.

TE-5.5-MD-HC 585604 1" FNPT 3/4" MNPT UR/C-CSA 1/3 115 50/60 5.6/5.0 340/525 32 30 26 19 6 40.5 17.5 N/A 28.00

TE-5.5-MD-HC 585698 1" FNPT 3/4" MNPT Pump head less motor 7.00

Item

No.

Intake

Size

Discharge

Size Listing(s) HP Volts Hertz Amps Watts

230 50/60 2.8/2.5 340/525

Performance (GPM @ Head) Shut Off

Power

Cord (ft.)

Weight

(lbs.)5' 10' 20' 30' 40' Feet PSI

Replacement Parts

ITEM PART NO. DESCRIPTION

A 185112 Volute
B 187085 Thrust Washer
C 185100 Shaft
D 185138 Impeller/Bushing
E 924016 O-Ring
F 185181 Backplate
1 903712 Bolt
2 921050 Washer
3 185172 Drive Magnet
4 185162 Magnet Housing

NOTE: Parts A–F contact fluid

PO Box 12010 • Oklahoma City, OK 73157

Phone: [phone] • Fax: [phone]

E-mail: [e-mail]

Form 995784 — 01/2007www.LittleGiantPump.com