Hanging Cabinet Installation Instructions for
)
Workbenches and Height-Right™ Workbenches
Instructions for installing the hanging drawer to a Height-
Right™ workbench
Hardware included:
• 2 – ¼-20 x 3” hex head bolts (A111997)
• 4 –¼ -20 x ½” phillips head screw (A100318)
• 6 – ¼” washers (A108682)
• 2 – galvanized channel brackets ① (A109586)
• 2 – rear brackets ②
• 1 – front spacer bracket ③
Tools required:
• ratchet set, with extension
• Screwdriver, phillips and flat head
• Gloves
• Before starting, raise t he Height-Right workbench to the highest
setting to improve access to underneath of workbench.
• Remove drawer from housing.
• For certain housings, you may also need to remove the drawer
tracks to access bolts. If necessary, use a flat head screwdriver to
remove white, plastic retainer clips. Use gloves when removing
tracks.
• To attach rear brackets, Insert ¼ -20 x ½”phillips head bolts into
threaded nuts in housing. For 36” deep tops, use holes as shown in
Figure 1. Brackets will overhang the cabinet. For 30” deep tops,
move the bracket so it sits flush with the rear of the cabinet.
• Loosely attach ¼-20 x 3” hex head bolts and front spacer bracket
to galvanized channel brackets.
• Lifting back of housing first, place rear brackets over the bottom
flange of rear channel. (See Figure 2)
• Lift front of housing and place one channel bracket into the front
channel and turn bracket 90º. (See Figure 3)
• Secure bolt loosely.
• Repeat the same procedure for the second front bracket.
• Secure both bolts tightly.
• Using a flat head screwdriver, indent tabs on rear brackets so they
go over the bottom channel flange. This is important since it
prevents the housing from moving when drawer is opened.
• Replace tracks, and drawer.
To install hanging drawer to an
industrial or technical workbench
• If possible, turn workbench top upside down to install drawer.
• Remove drawer, white plastic retainer clip and tracks.
• If attaching hanging cabinet to a top provided by Lista, drill a
5.1mm pilot hole. Otherwise, drill a pilot hole according to top
provider’s specifications.
• Using lag screws provided with your wo rkbench top , secure to
bottom of worksurface. Lista provides 5/16” x 1-1/4” lag screws
with all workbench tops.
• Replace tracks, retainer clip and drawer.
Figure 1
Figure 2
Rear mouting brackets ②
Galv. channel bracket①
Front spacer bracket ③
Rear Height Right
channel (under
worksurface)
Rear hanging
cabinet mouting
REAR→
SIDE PROFILE (REAR OF HANGING CABINET
bracket ②
Figure 3
Front Height Right
channel (under
worksurface)
Front hanging
cabinet spacer
←FRONT
bracket ③
106 Lowland St. - Holliston, MA 01746
Customer Service: (800) 722-3020
SIDE PROFILE (FRONT OF HANGING CABINET)
http://www.listaintl.com/
MD030A3 Rev 0 – 02/2002
2002 Lista International Corp. All Rights Reserved – ISO9001 Certified
J:\ASSYINST\MD030A3\HC_REV1.DOC 03/01/02
Loading...