LINKSYS CTV1RM Users Manual

Xiamen Hello Electronics CO., LTD
Specification For Approval
Product Description: Radio frequency remote control
Customer: Foxconn
Customer Part No: 311.00008.005
CUSTOMER APPROVAL
(PLS COPY TO XIAMEN HELLO )
Part number
APPROVAL CHECKED BY DATE
Xiamen Hello Electronics Co., Ltd
UPDATE:
NOTES EDITION DATE
1 2
3
DESIGNED BY CHECKED BY APPROVAL
Yewei Wujb Yehao
User manual
1open the battery warehouse, according to identity into two AAA
batteries (1.5V × 2), insert the battery warehouse and close battery warehouse;
2Either a button press of the remote control will launch remote
code, until the release button. Wave the following figure
3The machine has mistakenly fired protection, that is, more than
five minutes after the keys have not yet released, such as keys, remote control, remote control output will be shut down into standby sleep state.
FCC ID: Q87CTV1RM
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC ID: 3839A-CTV1RM
Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Company: Cisco Systems, Inc. Product: RF control Model: CTV1RM country of origin: China
changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Loading...