LINKSYS CIT200 User Guide
®
13
Setting up the Telephony Kit
A Division of Cisco Systems, Inc.
Package Contents
• Handset
• 2 NiMH batteries
• Charger with Power Adapter
• USB Base Station with 5 foot USB Cable
• Quick Installation
• Setup Wizard CD with Skype Software
• Registration Information Card
Cordless Internet Telephony Kit
Quick Installation
A
Remove the Setup CDROM from the Telephony
Kit’s box and place it in
your PC’s CD-ROM drive.
The Setup Wizard should
run automatically, and
the Welcome screen
should appear.
B From the Welcome
screen, select the language in which you want
the Setup Wizard to
appear from the pulldown menu. Then, click
the Next button.
C From the next screen that
appears, click the Click
Here to Start button.
B
C
D
Read the License Agreement by scrolling down
the screen. Then, click I
Accept the agreement.
Click Next to continue the
installation.
E As shown on the next
screen, connect the USB
Base Station to your PC’s
USB port. Then, click the
Next button to continue.
E
D
F
As shown on the next
screen, insert the batteries into the handset and
place the handset on the
charger. The phone
should charge for at least
14 hours before use. Click
the Next button to continue.
G Read the cautions on the
following screen before
clicking the Next button
to continue and the Wizard will start coping files
to your PC.
Before using the handset, you must have SKYPE
installed and running on
your PC.
After the handset is
charged and SKYPE is
installed on your PC,
press the SKYPE button on
your phone to view your
contact list and make
calls.
Internet access is
required to utilize SKYPE.
F
G
Model No.
Model No.
CIT200
2
Before you use the Telephony Kit
3
Important Safety Information
H
After files are installed on
your PC, the Setup Wizard
will conclude. Click the
Online Registration button
to register this product or
the Exit button to close
the Setup Wizard
I After you open the SKPYE
application on your PC,
the following screen will
appear. Select Allow this
application to use SKYPE
and click OK.
Congratulations! The Cordless
Internet Telephony Kit is
installed!
H
I
Before you use the Cordless
Internet Telephony Kit, please
make sure you:
A Have SKYPE installed and
running on your PC.
B Have connected the
Telephony Kit properly
C Have charged the hand-
set.
BEFORE USING YOUR TELEPHONE EQUIPMENT, BASIC
SAFETY PRECAUTIONS SHOUD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND
INJURY, INCLUDING THE FOLLOWING.
• Read and follow all warnings and instructions marked
on the product.
• Do not use this product near water, laundry tub, in a
wet basement, or near a swimming pool.
• Do not place this product on an unstable table. The
product may fall and be damaged.
• This product should never be placed near or over a
radiator or heat register.
• This product should be operated only from the type of
power source indicated on the label.
• Do not allow anything to rest on the power cord. Do not
locate this product where the cord will be abused by
persons walking on it.
• Do not overload wall outlets and extension cords as
this can result in the risk of fire or electric shock.
• Avoid using a telephone during an electrical storm.
There may be a remote risk of electric shock from
lightning.
• Do not use this product to report a gas leak in the
vicinity of the leak.
• Do not use this product near intensive care medical
equipment or by persons with pacemakers.
• Due to the radio signals between base station and
handset, wearers of hearing aids may experience
interference in the form of a humming noise.
BATTERIES
• Use only the battery type listed in the instruction
manual. Do not use lithium batteries or nonrechargeable batteries that may damage the handset
and charger.
• Do not dispose of the battery in a fire, as
they can explode.
• Do not open or mutilate the battery.
Released electrolyte is corrosive and can
cause damage to the eyes or skin. It can
be toxic if swallowed.
• Avoid contact with metal objects when
handling the battery. These objects could
short out the batteries or cause the
conductor to overheat resulting in burns.
• Do not attempt to recharge the battery cell
by heating it. Sudden release of battery
electrolyte can cause burns or irritation to
the eyes or skin.
• Observe the proper polarity, or direction, of
any battery. Reverse insertion of the
battery cell can result in leakage or
explosion.
• Remove the battery cells if you do not plan
to use the product for several months at a
time.
• Discard any "dead" batteries because they
are likely to leak into the product.
• Do not store this product or the battery in a
high temperature area. Battery stored in a
freezer or refrigerator should be protected
from condensation during storage and
defrosting. Battery should be stabilized at
room temperature before using.
•Your battery is rechargeable and can be
recycled once it outlives its usefulness.
Depending upon your local and state law, it
might be illegal to dispose of this battery
into a municipal waste system. Check with
your local solid waste company for more
information on your recycling options for
the battery cells.
SAVE THESE INSTRUCTIONS
For additional information or troubleshooting
help, refer to the User Guide on the Setup CDROM. You can also call or email for further
support.
24-hour Technical Support
800-326-7114
(toll-free from US or Canada)
E-mail Support
support@linksys.com
Website
http://www.linksys.com or
http://support.linksys.com
RMA (Return Merchandise Authorization)
http://www.linksys.com/support
FTP Site
ftp://ftp.linksys.com
Sales Information
800-546-5797 (800-LINKSYS)
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2005
Cisco Systems, Inc. All rights reserved.
CIT200-QI-50722 KL
Loading...