Linear SST00078 User Manual

DXS-81

PULL BAIT BILL FROM
MONEY CLIP

VERIFY THAT RECEIVER
ACTIVATES WHEN
BILL IS PULLED

INDICATOR

WILL NOT

LIGHT WHEN BILL IS PULLED

WIRELESS
CASH DRAWER
BILL TRAP
TRANSMITTER

Installation Instructions

[phone] • FAX [phone]

USA & Canada [phone] & [phone]

Toll Free FAX [phone]

DXS-81 FEATURES TRANSMITTER SETUP PROGRAM SYSTEM

MONEY
CLIP

STORAGE
INSERT OR
"BAIT" BILL

TEST
BUTTON

TEST
INDICATOR

DXS

FORMAT

By

The DXS-81 is a battery powered cash drawer bill trap with a built-in

PRODUCT DESCRIPTION

transmitter designed for use with Linear’s DX Format receivers. This
transmitter can be used in a variety of retail hold-up applications.

The DXS-81 is concealed in a cash drawer under a stack of currency, with
a single “bait” bill secured in its money clip. During a hold-up, the cashier
removes the stack of currency along with the “bait” bill. When a “bait” bill is
removed, the transmitter sends a 1-second digitally coded wireless signal
to its companion receiver. Four additional 1-second signals are sent
within the first minute after the “bait” bill is removed. When the “bait” bill
is replaced, a restore signal is sent.

The jumper located under the battery door can be set to “ON” which will
send an hourly status signal or to “OFF” which will send a signal only after
an hour if the DXS-81 senses cash drawer motion.

The digital DX code format features over a million possible codes. The DX
transmitters are precoded at the factory to unique codes, so no field coding
is required. The DXS-81 can send three different signals: alarm, restore
and low battery.

For versatility, any transmitter can be programmed into any receiver
channel. Receivers must be programmed to the transmitter’s code before
system testing and operation. Refer to the receiver’s instructions for details
on programming.

PULL AND DISCARD
BATTERY INSULATOR

SLIDE BATTERY DOOR
OPEN ON BACK
OF TRANSMITTER

The transmitter has a red test indicator which lights when a bill is in the trap
and the test button is pressed. It also lights when the “bait” bill is inserted
into the trap. For safety, the indicator doesn’t light when the “bait” bill
is removed. The test indicator will not light when pressing the test button
with the “bait” bill removed.

The test button is disabled for 60-seconds after removing the “bait” bill.
Pressing the test button without a bill in the trap sends an alarm signal.
Pressing the test button with a bill in the trap sends a restore signal.

The unit is powered from two 3-Volt lithium batteries with an expected
battery life of up to two years. When the batteries get low, the test indicator
will flash when the test button is pressed or when the bait bill is replaced.

NOTE: Do not store the unit without a “bait” bill or storage insert

in the money clip. Battery life will be reduced.

Inside the transmitter is a rolling ball that detects when the cash drawer
opens and closes. In the “OFF” mode this determines when status
transmissions are sent. Because the transmitter’s signal might be shielded
in a closed cash drawer, the status signals are sent when the drawer is
opened. In the “ON” mode, the DXS-81 transmits status signals once per
hour regardless of motion. Some DX receivers can receive low battery
signals, others cannot (see receiver instructions).

PREPARE RECEIVER
FOR PROGRAMMING

PRESS TEST BUTTON
WITH STORAGE INSERT
UNDER MONEY CLIP

STICK VELCRO TO BACK OF UNIT
(DON'T COVER BATTERY DOOR)

PEEL OFF BACKING

TRANSMITTER MOTION
SENSOR DETECTS WHEN
DRAWER IS OPEN

AUTOMATIC STATUS
TRANSMISSIONS WILL OCCUR

LOW BATTERY OPERATION BATTERY REPLACEMENT LINEAR LIMITED WARRANTY

STATUS JUMPER

HOURLY STATUS

ENABLED

(HOURLY STATUS DISABLED)

BATTERY

CAVITY

INSTALL BILL TRAP INSERT BAIT BILL TEST SYSTEM

REMOVE STORAGE INSERT
AND SLIDE BAIT BILL
UNDER MONEY CLIP

STICK TRANSMITTER INTO
CASH DRAWER TRAY

WHEN BATTERIES GET LOW
TEST INDICATOR WILL
BLINK WHEN TEST BUTTON
IS PRESSED

SLIDE BATTERY DOOR
OPEN ON BACK
OF TRANSMITTER

INSERT TWO
TYPE 2032
BATTERIES
PLUS SIDE UP

BATTERY

CAVITY

This Linear product is warranted against defects in material and workmanship for twelve (12) months.
The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale

customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does
not warrant this product to consumers. Consumers should inquire from their selling dealer as to the
nature of the dealer’s warranty, if any. There are no obligations or liabilities on the part of Linear
corporation for consequential damages ari sing out of or in connection with use or performance
of this product or other indirect damages with respect to loss of property, revenue, or profit, or
cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for

merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled
on the product. This Linear Corporation Warranty is in lieu of all other warranties express or implied.
For warranty service on Linear equipment return product, at sender’s expense to:

Linear Corporation Repairs Department
2580 Pioneer Avenue, Suite C
Vista, CA 92083

Linear radio controls provide a reliable communications link and fill an important need in portable wireless
signalling. However, there are some limitations which must be observed.

For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as

Part 15 devices. As such, they have limited transmitter power and therefore limited range.

A receiver cannot respond to more than one transmitted signal at a time and may be blocked by

radio signals that occur on or near their operating frequencies, regardless of code settings.

Changes or modifications to the device may void FCC compliance.

Infrequently used radio links should be tested regularly to protect against undetected interference

or fault.

A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale

distributor or dealer, and these facts should be communicated to the ultimate users.

Copyright © 1996 Linear Corporation 212863 A

IMPORTANT !!!

TEST INDICATOR
SHOULD LIGHT