Supervised
Supporters and Proud Members of
All Models Listed
UL 325 Compliant
Door & Access Systems
Manufacturers Association
International
®
Gate Edge
Monitoring
System
Gate Edge Radio
Monitors the presence
and function of
10k sensing edges
• Works with all 10K monitored gate operators
• Uses 10K terminated edges
• 2 channels for up to 2 edges and transmitters
per receiver
• Low Battery alert before failure
• Receiver powered by 12-30 VDC
• 2 output relays. 10K during normal
conditions, shorted during sense or power fail
• Simple setup and programming
• Audio and LED feedback for installation and
troubleshooting
• UL325 listed device
• Hard wired motor sensing for 12-24 volt DC
motors; non-contact ACSENS module for
high voltage AC motors (115-460VAC)
SGET Edge Transmitter
SGER Edge Receiver
The SGER monitors for motor
running condition, monitoring
the edges at all times.
Upon the motor stopping, the
SGER sends an individual
query to each transmitter for a
status check. This monitoring
occurs after each run, two
times per cycle.
SGEK-AC:
• SGER Receiver
• SGET Edge Transmitter
• ACSENS module
SGER board
ACSENS Module
CAUTIONS
• Automatic gates are not for
pedestrians
• Automatic gate operators are
designed for vehicular traffic
only; operators are powerful
and can cause serious injury or
death; DIRECT ALL PEDESTRIAN
TRAFFIC TO SEPARATE
PEDESTRIAN GATE
LEARN 1 LEARN 2
SENSE INPUT
SENSE POWER
3.3V
GND
SGEK-DC:
• SGER Receiver
• SGET Edge Transmitter
SGET also sold individually for expansion to
two edges
ACSENS module sold separately to convert
SGEK-DC to SGEK-AC
800-543-4283 / linearproaccess.com
Copyright 2017, GTO Access Systems, LLC 10019873