Linear MDS-LLK Owner's Manual

MDS-LLK

Linear LLC

2055 Corte Del Nogal, Carlsbad, CA 92009, USA 760-438-7000

800-999-5225

fax: 760-931-1340

www.channelplus.com

ADHESIVE FEET ARE SUPPLIED TO ATTACH TO THE BOTTO

OF THE CASE

THE MDS-LLK CAN BE ATTACHED WITH DOUBLE-SIDED TAPE TO A MODE

MB-55 OR MB-5

6 STRUCTURED WIRING MOUNTING BRACKET

LINE LEVEL INPUT

LEFT

RIGH

SPEAKER OUTPUT

LEFT RIGHT

LEFTRIGHT

RIGHT LEF

MDS-6A

MUSI

DISTRIBUTION

SYSTEM

MDS-LLK LIN

LEVEL ADAPTER

HIGH POWER AMPLIFIE

SPEAKER

SPEAKER LEVEL AUDIO IN

LINE LEVEL AUDI

LINE LEVEL OUTPUTS

BALANCE ADJUSTMENT

PUSH ORANGE LEVER

TO INSERT OR REMOVE

WIRE IN TERMINAL

ADJUST AFTER INSTALLATION FOR PROPER AUDIO BALANCE

TERMINAL LEVERS

SPEAKER LEVEL INPUTS

TERMINALS ACCEPT UP TO

16 AWG WIRE

RCA TYPE AUDIO CONNECTOR

Line Level Adapter

Installation Instructions

PRODUCT DESCRIPTION

The Model MDS-LLK Line Level Adapter is designed to connect between an audio ampliﬁer’s stereo speaker outputs and another audio ampliﬁer’s line level inputs. The MDS-LLK attenuates the audio signal approximately 28 dB to prevent overloading of the ampliﬁer’s line level inputs. The MDS-LLK can also be used to supply stereo audio signals to a tape deck, VCR, computer, or any audio device that requires a line level input signal. A left/right balance adjustment is accessible through a hole in the top of the case.

ADAPTER MOUNTING

AUDIO CONNECTIONS SPECIFICATIONS

NUMBER OF CHANNELS: 2

SIGNAL ATTENUATION:

(set by balance control)

BALANCE CONTROL RANGE: 10 dB maximum channel difference

POWER REQUIREMENTS: None (passive device)

ACCESSORIES: Four self-adhesive foam rubber feet

OPERATING TEMPERATURE:

(-25° to 70° C)

DIMENSIONS: 2.6” W x 1.1” H x 2.6” D

23 dB to 33 dB

-13° to 158° F

LIMITED WARRANTY

Linear LLC warrants this product to be free from defects in material and workmanship for 2 years. The time period will be measured using the date code labeled on the product. Linear LLC is not responsible for damage to the product resulting from the buyer’s improper handling, stocking or warehousing of the product. Any implied warranty arising from the sale of the product including implied warranties of merchantability and fitness for purpose are limited. Linear LLC shall not be responsible for any losses, damages or expenses, whether direct, consequential, or incidental arising from the use or the inability to use the product. Some states and countries do not allow limitations or how long an implied warranty lasts or the exclusion or limitation or incidental or consequential damages, so the above exclusions may not apply. The Linear LLC warranty gives specific legal rights in addition to other rights, which may exist and vary from state to state and country to country. The warranty is limited to repair or replacement of products returned, freight prepaid, to Linear LLC, there is NO PROVISION FOR LABOR COST OR OTHER REIMBURSEMENTS OF ANY KIND.

1. Failures due to product abuse, such as negligence, improper use, and electrical surge including damage from lightning, water damage or other damage due to natural disasters are not covered by the warranty. The most common form of product abuse is surge damage caused by lightning.

2. The warranty shall also be voided by any tampering with the date code, labels or other markings on the product.

3. Products that are damaged in transit to Linear LLC due to improper packaging or by the carrier (shipping company) will not be covered under the warranty. If the product was damaged or lost by the carrier, it is the sender’s responsibility to create a claim against the carrier.

4. The user is responsible for all labor costs associated with removing, reinstalling and returning the product to Linear LLC.

Linear LLC, at its option, will repair or replace the defective product. Replacements will be made from B-Stock, if an exact replacement is not available, Linear LLC, at its option, will select the nearest equivalent product. The user is responsible for freight charges to Linear LLC. Linear LLC will return warranted repaired or replacements by UPS Ground or an equivalent service. A customer may pay the additional costs for second-day or next-day service. All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-999-5225 for an RPA# and other important details.