Linear LDO33, LDO50 User Manual

USA & Canada [phone] & [phone]

[phone] - Toll Free FAX [phone]

www.linearcorp.com

LDO & LSO GARAGE DOOR OPERATOR OPEN LIMIT SWITCH ADJUSTMENT

IMPORTANT BULLETIN - FIELD ACTION REQUIRED

This bulletin applies to all Linear Model LDO & LSO garage
door operators manufactured from December 3rd, 2007
to April 6th, 2008. Products manufactured between these
dates have the preset factory location of the open limit
adjustment set abnormally high. This can affect operator
setup and testing in 7-foot and 8-foot rail installations.

To prevent possible damage to the operator and/or
rail components, BEFORE APPLYING POWER TO THE
OPERATOR, turn the OPEN LIMIT adjustment screw
downward (counterclockwise) seven (7) full turns. This
will return the operator to the normal factory setting.
After adjusting, FOLLOW ALL PRINTED INSTRUCTIONS
supplied with the operator.

If the open limit is not readjusted prior to testing the
operator, with the trolley disconnected from the traveler
(also known as the inner slide), it is possible to overrun
the traveler into the drive sprocket during testing. This
can cause damage to the traveler and/or the operator.

TECHNICAL BULLETIN

TB2008-002

ISSUE DATE: 4/8/2008

LDO33 and LDO50 Garage Door Operators

How to identify affected products:

The date of manufacture is stamped on the outside of the
operator’s packing box above the product identifi cation
label. If the product has already been corrected at the
factory, a light blue dot will be seen on or near the
label. Operators produced after April 7th, 2008 have
the correct preset open limit setting and no fi eld action
is required.

DOWN

OPEN LIMIT

ADJUSTMENT

LSO50 Garage Door Operator

USE A SCREWDRIVER TO ADJUST
THE OPEN LIMIT DOWNWARD

SEVEN FULL TURNS

COUNTERCLOCKWISE

Adjusting the Open Limit on an LDO Operator

Copyright © 2008 Linear LLC P484 X5