Linear H110 Owner's Manual

ChannelPlus Video Wall Plate

The H110 video wall plate provides an easy way to add a new TV

channel to your existing television channels. The H110
connects to one of its companion channel injectors

AUDIO R

(H511HHR or H511BID) via a single run of CAT-5 wire - no
coax is needed. Use the H110 with any video/audio source.

AUDIO L

The H110 provides switchable 75ohm or Hi-Z termination
and loop-through capability. The “looped” video can be fed

VIDEO

POWER

N
O
R
M

to a local monitor or VCR.

L
O
O
P

Note: The H110 is not a standalone video interface.

Use only with an H511 channel injector.

Connecting a Video Source

SATELLITE
RECEIVER

audio/video

outputs

Typical Installation

Connect the H110 wall plate using only method:
1 Terminate cable with a CAT-5 jack and connect to the H511 using

supplied RJ45 jumper. (Also see example H628 manual)

2 Wire camera or wall plate directly to the 8 position terminal block

matching the CAT-5 wire colors to the colors on the terminal block.
Insert wires and tighten screws.

1

2

CAT-5 video

Channel Injector

H511HHR

or

H511BID

Output

one

Program

CATV

/Ant

Power

Power the H511 or H110
last - make all cable and
CAT-5 connections first.

AUDIO R

AUDIO L

VIDEO

N
O
R
M

POWER

Model

H110

L
O
O
P

video

input

AUDIO RECEIVER

LOCAL TV

Maximum CAT-5 run:
System powered from H511 300 feet
System powered from H110 100 feet

H110

(rear view)

Insert wire into terminal block and tighten screws. Use the color bar to match
wire colors. The color bar has two rows, one for CAT-5 and one for quad wire:

- For CAT-5 wire, remove the default resistor and use all 8 wires.

- For quad wire , leave default resistor in place and match four color wire.

*

Connect antenna or incoming
cable to H511 input.

Connect H511 output to splitter
or distribution panel input.
(See H511 manual)

POWER

POWER:
When the H110 is wired to the
H511HHR or H511BID, both units
can be powered from either location.
The H110 does not come with its
own power supply - to power the
system from the H110, use the power
supply provided with the H511.

The green power LED will be lit
showing active power when the
power supply is plugged into either
the H110 or the H511.

12:00

N
O
R
M

audio

inputs

L
O
O

P

NORM:
Select NORM when a television or
a/v receiver is not used at the wall
plate to view the connected source.
The NORM position terminates the
video source with 75 .

LOOP:
Select LOOP when a television or
a/v receiver is connected to the wall
plate to view the connected source.
The LOOP position leaves the
source unterminated - the local
monitor will provide termination.

The H110 was designed to work with CAT-5 wiring. Although the system will function with quad

*

wire, CAT-5 delivers the highest quality picture. CAT-5 allows the use of an automatic line length
sensor and picture compensator. Quad wire does not take advantage of this enhancement.

DECLARATION OF CONFORMITY

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.

Installation requirements:

FCC classifies this product under part 15 of its rules as a “television interface device”.
Systems designed using television interface devices have the following legal

requirements:

1) The modulated channel signal strength may not exceed 15.56dBmV at any
television.

2) If an antenna is used in the system, the modulated channel signal strength may
not exceed -51dBmV at the antenna input port.

47CFR15.115(c)(4).

For the Installer:

Any system you design must comply with these regulations. As the installer, you are
responsible. The H110 (when used with an H511) has the necessary characteristics
to comply with the above requirements as designed without additional accessories.
The H511HHR is suitable for use with an antenna or with CATV systems.
The H511BID is suitable for use with CATV systems only.

Federal Regulation 47CFR15.115(b)(1)(i).

Federal Regulation

Multiplex Technology, Inc., Brea, CA 92821Multiplex Technology, Inc., Brea, CA 92821

600-176 Rev A600-176 Rev A

TM

3 RG-6

2 RG-6

2 RG-6

3 Cat-5

2 Cat-5

1 Cat-5

Home Office

3 RG-6

3 RG-6

3 RG-6

Home office - phone, TV, ethernet, satellite receiver, cable modem, hi-speed data
Media center - phone, TV, ethernet, satellite receiver, AV modulators, hi-speed data

Compatible

Typical room - phone, TV, ethernet, satellite receiver

ethernet,

Best …

phone, TV, ethernet, cable modem

Home office ­Media center - phone, TV, satellite receiver, AV modulators
Typical room - phone, TV, ethernet

ChannelPlus Enclosures, Modules,

Accessories & Wall Plates

Better …

cable modem

Home office - phone, TV,
Media center - phone, satellite receiver, AV modulators
Typical room - phone, TV

Good ...

Service center
enclosures

A full line of OpenHouse compatible

2 RG-6

3 Cat-5

2 Cat-5

Best

1 RG-6

Better

2 Cat-5

2 Cat-5

1 RG-6

1 Cat-5

Media Center

Good

1 Cat-5

Typical Room

Starter systems

RF splitters and telephone punch
downs. When it is time to upgrade,
just snap this module out and
replace with one of more of the
more sophisticated units.

the service center to the rooms indicated.
We recommend the following pre-wire schemes . Run these wires from
VCR or a satellite receiver.)

DataHub (8 cables, TIA-568A) Category 5 Compliant

ChannelPlusmodel H628

modulator creates new TV channels for front door camera, DVD player, a
cable), satellite dish, cable modem, or AV modulator signals. (An AV
data or 1 to 4 telephone lines. RG-6 coax handles television (antenna or

UTP

entertainment: Cat-5, 4-UTP (4 nshielded wisted airs) wire handles
wiring.) Two types of wire are used for communication and
directly to the service center location.(This is known as ‘home run’
The cables in an OpenHouse run from the various rooms of the house

Wiring a house for OpenHouse

Telephone hubs

Connections for 1-4 phone lines to
every room. Starter hub adds RJ­31X jack for security system dialer.

enclosures, from simple, inexpensive
mounting plates to high capacity in-wall
cabinets. AC outlets can be mounted
inside the cabinets using a UL listed
accessory.

OUTINOUT

Telco

R

2

T
R

1

T

IN

IN

ComboHub (2 lines x 6 phones, 1input x 4 televisions)

532-230 5MHzto1000MHz

SPLITTER

TelephonesFrom

OUTINOUT

OUT

COMBINER

ChannelPlusmodel H801

IN

R

Data hubs

Termination blocks for the CAT-5 cables,
Ethernet hubs. Bring the Internet to any
room in the home. Or create a home data
network.

TelephoneMaster Hub (4 lines x 6 phones)

From

Expansion

Telco

Ports

RJ31X

R

4

T
R

3

T
R

2

T

Out

R

1

T

ChannelPlusmodel H616

Telephones

Model H110

®

TM

multiplex

technology, inc.

®

Video Wall Plate

ChannelPlus

Wall plates

Wall plate systems for all rooms. The typical room gets TV
and telephone. The Home office wall plate adds data ports.
The media center wall plate adds satellite feeds.

AV modulators
(for service center)

Create a new TV channel for a front
door camera. Some models feature
Cat-5 input connections.

Coax panels

Distribute antenna or cable TV to every
room of the house. Some models include
bi-directional amplifiers for interactive cable
systems. Some models include
inputs and

IR engines.

modulator

3001 Enterprise Street, Brea, CA 92821-6213, U.S.A.

714-996-4100 800-999-5225 FAX [phone] www.channelplus.com

*

*

*

Warranty

Multiplex Technology, Inc. warrants this product to be free from defects in materials and workmanship
for a period of one year from the date of purchase or MTI will repair, or at its option, replace the
defective product. To obtain warranty service, call MTI for a return material authorization (RMA)
number and return theproductprepaid to Multiplex Technology, Inc., 3001 Enterprise Street, Brea, CA

92821, Attention: Customer Service. Please put the RMA number on the outside of the carton.

Any implied warranty arising from the sale of the product including implied warranties of
merchantability and fitness for purpose are limited to the warranty stated above. MTI shall not be
responsible for losses or damages or expenses, whether direct, consequential or incidental arising
from theuse of or the inability to use this product. Some states do not allow limitations on how long the
implied warranty lasts or the exclusion or limitation or incidental or consequential damages, so the
above limitations and exclusions may not apply to you. This warranty gives you specific legal rights,
and you may have other rights which may vary from state to state.

AV modulators
(for media center)

Create new TV channels for DVD, VCR,

®

select

program

DCBA

model 5445 quad digital modulator

pll frequency control

or a satellite receiver. These modulators
sit in the media center. Some offer true
MTS stereo.

IR Accessories

Control video devices from any room.

New ChannelPlus products are added all the time.

Visit our website to learn more: www.channelplus.com