Linear DMCRAC Quick Start Manual

dmcRAC Antenna Upgrade Kit
Installation Instructions
dmcRAC – Antenna Upgrade Kit
Installing the dmcRAC
The dmcRAC is only required when using a dmc1 master for a retrofit application. The dmcRAC is not required on the dmc3-4 retrofit master.
Tools required:
#1 Phillips screwdriver
To install the dmcRAC you must first remove two screws from the dmc1 master on either side of the antenna connections. Refer to Figure 1 for screw locations.
Then place the dmcRAC board over the AM and FM antenna positions lining the connectors up with the antenna inputs. Make sure to push in the antenna tabs while inserting the AM connections. Once the connectors are aligned push the
antenna board into place.
Spacer
After the antenna board is in position, use the enclosed screws, spacer and washer to connect the board. Position the lock washer on the spacer and insert between the antenna board and the open screw hole on the dmc1. Make sure the
lock washer is between the board the spacer. Use the enclosed screw to fasten
Lock Washer
Figure 2 - Installed dmcRAC
the spacer in place. Repeat with both
sides of the dmcRAC board. Refer to Figure 2 for completed board installation.
Figure 1 - dmcRAC installation
Remove
thes e
screws
www.msststems.com | 800.421.1587 | Page 2
Loading...
+ 2 hidden pages