Lightolier MINI-BEAM-MB, PARAPLUS-PP User Manual
Lightolier
45 INDUSTRIAL WAY, WILMINGTON, MA 01887
PARAPLUS (PP), COFFAIRE (CF), MINI-BEAM (MB), HP90 (H9)
INSTALLATION INSTRUCTIONS
IMPORTANT: For Paraplus remove the Louver
1
before installing fixture into ceiling system (by
others). To remove the Louver, depress one
side of the Louver to clear the Hinge Pin and
Housing
Overlay
Louver
Hinge
Pin
2
Access Plate for CF/PP
Hinge
Pin
Remove Access Plate (snaps in and out of
position). Bend Housing Tab up to attach
ground screw to green screw on the Housing
Tab. Then bend Housing Tab down into the
Housing as shown. Install Access Plate.
pull the Louver towards you. Rotate the Louver
upwards and remove from the Hinge Pins on
the opposite side of the Housing.
Louver
Louver
Housing
Hinge Pin
Access Plate
Housing
Access Plate for Mini-Beam (MB).
3
Remove Access Plate by sliding Access Plate
in the direction of Arrow 1. To remove, lift up
and slide in the direction of Arrow 2. Bend
Housing Tab up out of Housing and make
ground and ballast connections. Bend Housing
Tab back to original position. Replace the
Access Plate by reversing removal procedure.
Access
Plate
Opening
Housing Tab
Access
1.
Plate
2.
Tab
Access
Plate
Opening
Access
Plate
Opening
Ground
Screw
Fixture
Tab
© a Genlyte company
59-31115-003 Printed in U.S.A.
To install fixture into the ceiling system (by
4
others), bend Earthquake Clips out 90 degress
from Housing End. Install fixture into ceiling
system. Secure the fixture to the ceiling system
by bending the Locking Tabs on the Earthquake
Clips towards the T-bar.
Housing
Install fixture into Ceiling System (by others).
5
For Coffaire (CF) and Mini-Beam (MB), open
Lamp Shield by gripping Narrow Flange of
Lamp Shield and pull Lamp Shield towards you,
letting the opposite side of the Lamp Shield rest
on the Hinge Pins (Wide Flange).
Earthquake
Clip
Locking Tab
Housing
T-bar
(by others)
Locking
Tab
Earthquake
Clip
T-bar
(by
others)
Earthquake
Clip
Locking
Tab
Coffaire
Mini-Beam
Ceiling System
(by others)
COFFAIRE (CF) MINI-BEAM (MB)
Hinge Pin
(Wide Flange)
Hinge Pin
(Narrow Flange)
Lamp Shield
For Mini-Beam Ballast Access Cover
6
Compartment.
Ballast is accessed by removing the ceiling tile
adjacent to the Mini-Beam. Remove Screw at
end of Ballast Access Cover and slide Ballast
Access Cover towards Housing End. Lift Ballast
Access Cover for easy access to Ballast. To
replace Ballast Access Cover reverse the
procedure.
Hinge Pin
Lens
HP90 Lens Removal
Push Lens to one side A , and pull Lens off
Hinge Pins B and downward. Unlink Lens from
O
O
all Hinge Pins (both ends of fixture) clearing the
lamps for removal.
A
O
B
O
Ballast Access
Cover
Screw
Housing
End
Loading...