Lightolier LytespanTrack system, Conduit Adapter Instructions For Maintenance Reference Manual

P

3

READANDUNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE

INSTRUCTION SHEET NO,

Thisfixtureisintendedfor installation in aczordan~ with the National Electrical Code and local regulations,

To assure full compliance with local codes and regulations, check with your local electrical inspector before
Installation, Toprevent electrical shock, turnoff electricity at fuse box before proceeding.

IS:7596

Retainthese instructions for maintenancereference,

R0892

CONDUIT ADAPTER

FOR USE WITH BASIC LYTESPAN”TRACK SYSTEM ONLY.

The CONDUIT ADAPTER is used for power feed10theLIVE END of Basic

Lytespanfromsurfaceconduitthatterminatesin 1/2-14 IPSthreadedconnector.

CAUTiON:

“ TURNOFFPOWERAT FUSE BOX BEFOREInstalling

TRACK.

“ usEoNLY #12 GA, soLIDcoPPER wlREIN connectors To

MAINTAiN PROPERRATiNGOFTRACK,

PLUG

o

OBSERVEPOLARITY,WHITE(NEUTRAL)WIRE MUSTBE

BOTTOM->

CONNECTEDTO TERMINAL MARKED“NEUT”, FAILURETO

COVER

OBSERVEPOLARiTY MAY RESULTINAN ELECTRICAL
HAZARD,

FIG, 1

~ DO NOT USETRACK AS A CONDUITSUPPORT,

INDEPENDENTCONDUITSUPPORTS(SUCHAS SUiTABLE
CONDUITSTRAPS)MUST BEUSEDTOATTACH THECONDUIT
lNSTALLATiONTOTHE BUILDINGSTRUCTURE,

INSTALLATION FORBASICLYTESPAN
l, UnscrewPLUGandremoveBOTTOMCOVERfromLIVEEND(Fig,l),
2,ScrewinCONDUlTADAPTER(Fig,2),
3,Screweleckimlconnector(byothers)intoCONDUITADAPTER,Passsupplyleads
throughassemblyandfastensupplyIeadsasshown

ontrackinstructionsheet1S:6020,

NOTES:TheNUTinside the LIVE END can be rotated to permit
sufficient clearance for suppiy leads. CONDUITADAPTER is NOT
required for Advent Lytespanm,

FIG. 2

[m I <> H

iC> L I E H

RRR&R<!SE!~R’