Lightolier 1104F2632ES User Manual
Lytecaster
13" MIN.
24" MAX.
7"
APERATURE
10 3/4"
OVERALL
LENGTH
7 5/16"
OVERALL
WIDTH
7 1/2"
OVERALL
HEIGHT
1
2
3
4
5
6
7
®
Recessed Downlighting 1104F2632ES
Page 1 of 1 6 3/4" Aperture 0
®
1 Lt 26/32W Quad/Triple Tube Compact Fluorescent
IC Frame-In Kit
Ceiling Opening 7" diameter
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit Reflector Trims — See Individual Reflector Trim Specification Sheets
1104F2632ES
1104F2632ESN
Voltage Lamp
120V 26/32W
Quad or
Triple
Tube
Anodized
Reflector
1143*
1144*
1144CD*
Anodized
Cone
1112
1112NM
1113
1113BK
1113BKNM
1113CD
1113CDNM
1113NM
1113WH
Open Downlight
Satin
Cone
1108
1108NM
1110
1110NM
Baffles
1105
1105BNM
1105NM
1105WH
1176
1176WH
Basic
White
1171*
1170M1
Enclosed
Diffusers
1121
1124
1126** (26W Only)
1134
1177SH**
1178SH
1190** (26W Only)
Wall
Washer
1185**
1186
1186WH
1135**
1135WH**
Features
1. Housing: .032” (#20 ga.) UL listed for direct contact with thermal
insulation. Allows installation in ceilings up to 2" thick. Can be removed
for access to junction box, ballast and ceiling plenum. AirSeal® housing
minimizes air leakage to less than 2 CFM at 1.57 PSF (or 75pa), which
complies with Model Energy Code (Section 602.3.3) and Washington State
Energy Code (Section 502.4) and reduces heat loss and condensation
in ceiling.
2. Mounting Frame: .048” (#18 ga.) galvanized steel. Locks into position
along length of mounting bars with locking spring and bendable slot. (3)
slots 90° apart simplif y alignment.
3. Junction Box: 2" X 4" X 3 1/2" (22 cu. in.) .032" (#22 ga.) galvanized steel.
UL listed for branch circuit wiring supplying connected luminaires. Integral
cable clamps permit attachment of non-metallic (#12 or #14 ga.) Romex®
cable without tools or additional connectors.
4. Mounting Bars: .059” (#16 ga.) galvanized steel. Bars pivot for easy
attachment and wire-in below ceiling line. Bars extend to accommodate
16" to 24" O.C. joist spacing. Bars can accommodate 9" O.C. joist spacing
after a slight field modification (see Instruction Sheet). Features integral
self-tapping phillips screws for secure attachment to wood or metal
construction. Attaches to T-bar ceilings without the need of accessories.
5. Socket Housing: Trim retaining spring secures trim to any height on
housing wall.
6. Socket: (4 Pin, GX24q-3) base, molded thermo-plastic. Pre-wired with #18
AWG leads to junction box.
7. Ballast: Electronic 120V, end of life protected, FCC class “B” consumer
limits, class “A” sound rating. Energy Star® qualified.
Electrical
Input Watts: 27 *Recommend Triple Tube Lamp for Optimal Performance.
Amps: .47 **Use Triple Tube Lamp Only.
Ballast Factor: 1.0
Power Factor: .98
Electrical (cont.)
Max THD %: 10
Min Start Temp: 0˚F/ -18˚C
Options & Accessories
AirSeal® Kit: L AS56† (Optional)
Note: Use only if factory installed tape or knockouts are removed from ver ti-
cal adjustment slots in housing wall.
Labels
† UL (Type IC Suitable for Damp Locations)
Complies with Air Leakage Requirements stated in the Model Energy Code,
California Title 24 Code and the Washington State Energy Code.
Romex® is a registered trademark of General Cable Industries Inc.
US and Foreign Patents Pending.
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lightolier a Genlyte company www.lightolier.com
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2006 Genlyte Group LLC • C0906
Loading...