LifeSource DT-607 User Manual

SPECIAL PRODUCT FEATURES

■

Reads temperature in Fahrenheit or Celsius.

■

Memory feature: automatic recall of last temperature reading.

■

Beeps when peak temperature is reached.

■

Auto-Off in approximately 9 minutes.

■

Thermometer is water resistant, but not 100% waterproof. Do not submerge unit
in

any liquid.

■

Long-life, replaceable battery (approximately 3,000 temperatures).

■

Low Battery Indicator “ ”.

■

Oral, Rectal or Underarm use.

HOW TO CARE FOR THIS PRODUCT

■

The thermometer should be cleaned after every use even when probe covers are
used.

■

Clean the thermometer tip and probe using isopropyl alcohol or soap and water.
Do

not boil the thermometer. Do not submerge the thermometer in any liquid.

■

Store the unit in the protective case while not in use.

■

Do not store or keep in direct sunlight, or in high temperatures.

■

Do not open the thermometer except to replace the battery.

■

Do not drop the thermometer, as this may break the unit.

■

Do not attempt to disassemble the unit except to replace the battery.

WHAT IS A “NORMAL” TEMPERATURE?

Temperature readings vary among individuals. A normal temperature refers to each
individual
range
conside
higher
an

’s average temperature while they are well. Normal average temperatures

from 97°F/36.1°C to 100°F/37.7°C when taken orally. A rectal temperature is

red your real or “core” body temperature. A rectal temperature is 1°F/0.5°C

than an oral reading and an underarm temperature is 1°F/0.5°C lower than

oral reading.

HOW TO TAKE TEMPERATURE

1.

Select oral, underarm or rectal as your measurement site (see following instruc­tions).

2.

Push the START button located at the top of the thermometer. The thermometer

beep and the display will show all symbols.. This is a function check indi

will

the unit is working properly. If a previous reading is stored in memory,

cating
the

thermometer will display the last temperature for two seconds. The flashing

symbol

°F (or °C) will appear with the “L” or “H” symbol indicating that the

thermometer

3.

When the °F (or °C) symbol stops flashing and the thermometer emits eight

beeps,

4.

Read and record the temperature and time for reference. The reading will auto­matically
are removed from the thermometer.

5.

Push the START button to turn the unit off. If you do not turn the unit off, it will

shut

NOTE: If the measured temperature is higher than 99.5°F (37.5°C), the fever alarm
will beep quickly for about four seconds.

is ready for measurement. Begin measurement.

the temperature measurement is complete.

be stored in the memory until another reading is taken or the batteries

off automatically in approximately 9 minutes.

-