Lifebreath TFPC2000, TFP2000 User Manual

1 TFP
4 mounting brackets
4 hanging straps
2 oval collar connections
4 8/32” X 3/4” sheet metal screws
8 8/32” X 3/8” sheet metal screws
4 pieces of mounting foam
1 set of installation \ operating instructions
1 warranty card
1 wiring diagram

The TFP is equipped with a standard power supply,
on a 5’ 5” cable. Lighted ON/OFF switch.

Materials Supplied

Electrical

* LEAVE FOR HOMEOWNER

NOTE: Due to ongoing research and product development, specifications,

ratings and dimensions are subject to change without notice.

TFP-06

0204

INSTALLATION MANUAL FOR TFP AIR CLEANER

TFP2000 (Wholehouse Model)

TFPC2000 (Portable Console Model)

WHOLEHOUSE AND PORTABLE

CONSOLE MODELS

ATTENTION

ATTENTION

The TFP can be installed in several different ways.
Please read all suggested methods before
attempting installation.

The furnace fan and/or HRV must operate
continuously for Type 1 and Type 2 installations.
If they do not operate continuously, then
interlocking them electrically with the TFP is
acceptable. Consult a certified electrician.

2

TFP Directly Connected to

Forced Air Heating System

1. Install 6” oval port collar (provided) on top and
bottom of TFP (Fig. 1). Use (4) 8/32” X 3/8”
screws (provided).

2. Remove protective backing from pieces of
foam and stick them to the 4 corners of the TFP
on the side being mounted against the plenum.

3. Remove the 4 mounting bolts from the back of the
TFP cabinet. (Fig. 1)

4. Attach top and bottom mounting brackets
(provided) vertical to the TFP cabinet and
reinstall mounting bolts.

5. Lift the TFP into position. Edge of TFP must be

positioned on plenum to allow clearance
needed for latches.

6. Install the (4) 8/32” X 3/4” mounting screws
(provided) through the brackets and into position.
Tighten and secure.

7. TFP should now sit securely against the plenum
with the foam in between.

8. Cut 2 - 6” holes in the plenum. Install ducting to
join TFP to the return air plenum (Fig. 2).

NOTE: Do not support the weight of the TFP on
the duct. Duct must be open and not pinched.

NOTE: Due to possible noise transfer through
the duct system, it may be preferable in some
situations to hang the TFP a short distance from
the plenum, and connect by running flexible
ducting between them. Four nylon hanging straps
are provided for this option.

Type 1 Installation

* Direct connect to furnace/air handler return, or hang
separately and connect to plenum with flexible ducting.

TYPE 1 INSTALLATION

Figure 1

T
F

P

Cold Air Return

Air flow direction

6" port collars

Access door

Power supply

Mounting bracket

Ducting (not included)

Clean (filtered) air port

Mounting bracket

Foam gaskets

FURNACE

Air Flow

Supply Plenum

Install plate here

1" Height

Figure 2

Round port bent to oval

Simply bend a standard duct fitting to the correct shape,
and attach to the oval port using the same method as
for a round port.

TFP

TFP

TFP

TFP air cleaner