Liebherr SBS 70I4, HRB 1120, HC 1001B, HF 861, HC 1070 User Manual

Design Guide 2014

Fully Integrated Models 24" and 48"

Welcome

Liebherr's engineering excellence in Germany provides the largest
selection of freezers, refrigerators and wine refrigerators worldwide.

Liebherr appliances consistently specializes in the manufacturing of high
quality freezers and refrigerators. With more than 300 basic models, we have
the widest selection in the world. Liebherr appliances feature premium quality,
numerous innovative product ideas and advanced design. Liebherr freezers and
refrigerators are manufactured at three modern production plants:

Liebherr Marica in Bulgaria, Liebherr-Hausgeräte Ochsenhausen GmbH in
Germany and the Liebherr-Hausgeräte Lienz GmbH in Austria.

We produce more than 2.2 million quality freezers, refrigerators and wine
refrigerators each year, and these are sold all over the world. Liebherr­Hausgeräte Ochsenhausen GmbH in Germany makes over 900.000 appliances
a year and employs 1.900 people. The Liebherr-Hausgeräte Lienz GmbH
manufactures more than 500.000 freezers and refrigerators and employs 1.500
people.

The appliances for the North American market are produced in Austria and in
Germany.

Liebherr is commited to the protection of the environment and recognizes it
as a critical priority. To guarantee an optimum and consistent implementation,
all ecological aspects were observed and integrated into the quality control of
Liebherr in compliance with DIN EN ISO 9001.

Liebherr's Commitment to the Environment

The components of Liebherr products can be recycled when the necessary
resources are applied. A concern for the environment and a desire to protect
resources has lead to increased levels of recycling year after year. When
Liebherr manufactures products, it is essential that the recyclable recovery rate
of the materials we use constantly increases.

Recycling is a common goal among all manufacturers, municipalities and
recycling companies to protect our environment. Protecting the environment
and producing products which have a low impact on the environment, is one
of Liebherr's core values. Whether you are replacing a unit or starting fresh,
remember to dispose of your old appliance in an environmentally safe and
friendly manner.

Introduction

LIEBHERR WARRANTY PLAN

FULL TWO YEAR WARRANTY - For two years from the date of original purchase, your Liebherr Warranty

covers all parts and labor to repair or replace any part of the product which proves to be defective in mate­rials or workmanship.

FULL FIVE YEAR WARRANTY - For five years from the date of original purchase, your Liebherr Warranty
covers all parts and labor to repair or replace any components that prove to be defective in materials or
workmanship in the sealed system. The "Sealed System" means only the compressor, condenser, evapo­rator, drier and all connecting tubing.

LIMITED 6TH THROUGH 12TH YEAR WARRANTY - From the 6th through 12th year from the date of
original purchase, your Liebherr Warranty covers all parts that prove to be defective in materials or work­manship in the sealed system (parts only).

For Service and Parts in the U.S.:
PlusOne Solutions, Inc.

3501 Quadrangle Blvd, Suite 120
Orlando, FL 32817

Customer Service

If your appliance is not working properly, or if the tem­perature display reads "F0" to "F5”, please call the
numbers listed below.

Give the fault number displayed, together with the

Type Designation,
Service Number and
Appliance Number (Serial Number)

from the model plate, to ensure prompt, accurate servic­ing. The model plate is located inside the appliance.

Phone: [phone]
Fax: [phone]

Toll Free: 1-866-LIEBHER or

1-866-543-2437

[e-mail]
www.liebherr-appliances.com

Leave the appliance door closed until the customer ser­vice technician arrives to minimize any further cold loss.

For Service and Parts in Canada:
Euro-Parts Canada

39822 Belgrave Road,
BELGRAVE, Ontario, N0G 1E0

Phone: [phone]
Fax: [phone]

Toll Free: 1-888-LIEBHER or

1-888-543-2437

www.euro-parts.ca

Need help?

For design related inquiries not addressed
in this Design Guide please email install.

[e-mail]

Contents

General Remarks

Safety Warnings I

Electrical Requirements & Safety II

IceMaker (if equipped) III

Area Requirements IV

Safety Regulations V

Fully Integrated Models 24" and 48" Models

HC 1070 1

Ventilation Requirements 3

Kitchen Cabinet Base Grille 4
Location Of The Electrical Outlet

Unit Dimensions 5

Kitchen Cabinet Doors 6

Definition of the Door Panel Heights 7

HC 1000B, HC 1001B 9

Ventilation Requirements 11

Kitchen Cabinet Base Grille 12
Location Of The Electrical Outlet

Unit Dimensions 13

Kitchen Cabinet Doors 14

Definition of the Door Panel Heights 15

HF 861 / HRB 1120, SBS 70I4 17

Ventilation Requirements 19

Kitchen Cabinet Base Grille 20
Location Of The Electrical Outlet

Unit Dimensions 21

Kitchen cabinet setup for the water filter 22

Kitchen Cabinet Doors 23

Definition of the Door Panel Heights 24

General Remarks

I. Safety Warnings

PLEASE READ AND FOLLOW THESE INSTRUCTIONS

This design guide contains Warning and Caution statements. This information is important for safe and
efficient installation.

This design guide is not replacing the use and care manual which contains important information on how to use Lieb­herr appliances.

Always read and follow all Warning and Caution statements!

indicates a hazardous situation, which if not avoided, will result in death or serious injury.

indicates a hazardous situation, which if not avoided, could result in death or serious injury.

indicates a hazardous situation, which if not avoided, will result in minor or moderate injury.

NOTICE

indicates a hazardous situation, which if not avoided, could result in damage to property.

NOTE

indicates useful advice and tips.

Make sure incoming voltage is the same as the unit rating.

To reduce the risk of fire, electric shock, or personal injury, the installation work and electrical wiring must be done by
a qualified electrician in accordance with all applicable codes and standards, including fire rated construction.

To the Installer

It is very important that the guidelines and instructions are followed in this design guide to ensure proper installa­tion and operation of the unit. The Installation Guidelines section contains important information for making sure the
installation is correct. Read and understand all the information and installation guidelines in this manual before the
unit is installed.

It is also very important to know the Safety Information.

General Remarks

II. Electrical Requirements & Safety

A 115 Volt, 60 Hz, 15 Amp (20 Amp for side-by-side in­stallation) fused electrical supply is required. Connect an
undercounter wine cabinet to a 115 VAC, 10 amp
(15 Amp for side-by-side installations) circuit that is con­trolled by a circuit breaker or fuse.
We recommend using a dedicated circuit for these ap­pliances to prevent electrical overload. Comply with
the National Electrical Code as well as local codes and
ordinances when installing the receptacle.

Do not ground to a gas pipe. Check with a
qualified electrician if you are not sure the
appliance is properly grounded. Do not have
a fuse in the neutral or grounding circuit.

ELECTROCUTION HAZARD

Electrical Grounding Required. This ap­pliance is equipped with a three-prong
(grounding) polarized plug for your protec­tion against possible shock hazards.

• DO NOT remove the round grounding
prong from the plug.

• DO NOT use a two-prong grounding
adapter.

• DO NOT use an extension cord to connect
power to the unit.

• DO NOT use a power cord that is frayed
or damged.

III. IceMaker (if equipped)

The icemaker is located in the freezer compartment.
The appliance must be level for the icemaker to function
properly.
If you have hard water, we recommend you install a
water softener. Also, a filter must be installed if the water
contains solids such as sand. All equipment and devices
used to supply the water to the appliance must comply
with the current regulations for your geographical area.

Safety Instructions and Warnings

• Do not attach the water source while the appliance is
connected to an electrical outlet.

• The water quality must comply with the drinking water
regulations for the geographical area where the appli­ance is located.

• The icemaker is designed exclusively to make ice
cubes in quantities needed by a household and may
only be operated with water appropriate for this pur­pose.

• All repairs and work on the icemaker may only be done
by customer service personnel or other trained person­nel.

Appliances with water connection:

• The water pressure must be between 21.8-87.0 psi (1.5-6
bar). Use a 1/4" OD copper line (not supplied) to con­nect the water supply to the solenoid valve.

• A shut-off valve, must be installed between the hose
line and the main water supply so that the water sup­ply can be stopped if necessary. Do not install the
shut-off valve behind the refrigeration unit.

• The connection to the water supply may only be made
by a trained and licensed plumber.

• The manufacturer cannot accept liability for damage
caused by equipment or water lines between the sole­noid valve and the water supply.

Appliances with water tank:

• Fill the water tank with cold potable water only. Never
use fluids containing sugar such as soft drinks, fruit­juices etc..

• Through the use of filtered, decarbonized water, drink­ing water with the best possible flavor is achieved,
and this can be used for problem-free production of
ice cubes. This water quality can be achieved using
a table water filter of the kind available in trade retail
outlets.

General Remarks

IV. Area Requirements

Verify the following:

• Floors can support refrigerator’s weight plus approxi­mately 1200 pounds (544 kg) of food weight. Not
all Liebherr products are designed for 1200 pounds
(544 kg) of food. Some units are smaller and total
weights may vary.

• Finished kitchen floor height is level. Refrigerator must
be shimmed to the floor level, or levelled, to make
sure, air vents are not obstructed.

• Remove anything attached to the rear or side walls
that can obstruct refrigerator opening.

• Cutout dimensions are accurate.

• Electrical outlet is in correct location.

Do not install this unit next to any other refrigerator or
freezer except another Liebherr model. Liebherr models
are designed to allow side by side installation. They are
equipped with a heating system to eliminate condensa­tion when units are installed side by side. Installing this
unit next to any other refrigerator or freezer can cause
condensation or cause damage to the Liebherr unit.

NOTICE
To protect the refrigerator from possible
damage, allow the appliance to stand 1/2 to
1 hour in place before turning the electricity
on. This allows the refrigerant and system
lubrication to reach equilibrium.

V. Safety Regulations

The appliance complies with UL250 and CAN/CSA-C
22,2 No. 63-93 (HF 851, HRB 1110) and respectively
CAN/CSA-C22.2 No. 60335-1-11, 60335-2-24-06 and
UL 60335-1, UL 60335-2-24 (HC 1070, HC 1000B, HC
1001B, HRB 1120) and is designed to cool, freeze, store
food as well as make ice (if equipped). It is designed as a
household appliance. If used commercially, the relevant
regulations on commercial use must be observed.

The appliance is set to operate within specific ambient
temperature limits according to its climate rating. These
temperature limits should not be exceeded. The cor­rect climate rating for your appliance is indicated on the
model plate.

This is explained as follows:

Climate

Rating

SN 50°F to 90°F (10°C to 32°C)

N 61°F to 90°F (16°C to 32°C)

ST 61°F to 101°F (16°C to 38°C)

T 61°F to 110°F (16°C to 43°C)

SN-ST

SN-T

- The refrigerant circuit has been tested for leaks.

Set for Ambient Temperatures of

50°F to 101°F (10°C to 38°C)

50°F to 110°F (10°C to 43°C)

Blocking For Safety

The anti-tip brackets must be installed to prevent the
unit from tipping after it is installed.

Fully Integrated

HC 1070, HC 1000B, HC 1001B, HF 861/HRB 1120 - SBS 70I4

24" Model: HC 1070

Integrated units are the most stylish option available - they're totally out of sight, fully concealed behind a cabinet door. Installed in
a tall kitchen cupboard, the refrigerator door simply opens in unison with the cupboard door.

HC 1070

Energy Star: qualified
Energy consumption p. a.: 475* kWh
respectively 407** kWh
Energy Supply: 115V/60Hz
Total capacity: 9,32 cu ft (264 L)
Refrigerator: 6,92 cu ft (196 L)
Freezer: 2,4 cu ft (68 L)
Climate Rating: SN-T
Door hinges: right / reversable

• Automatic refrigerator and freezer compartment defrosting

• LED light column at both sides

• HC 1070 with soft closing system

• IceMaker with water tank

• Height-adjustable feet at front and levelling rails

* Measurement determined according to Appendix A to Subpart B of 10 CFR Part 430
** Measurement determined according to Appendix A1 to Subpart B of 10 CRF Part 430

1

Fully Integrated

HC 1070, HC 1000B, HC 1001B, HF 861/HRB 1120 - SBS 70I4

2