Liebert 5000RT230, 6000RT230 User Manual

Liebert® GXT3™

UPS Model

Recommended

(Maximum) External

Over Current

Protection

Recommended Wire

(All wires)

75 degC Copper Wire

Maximum Wire

Accepted by

Terminal Block

Torque

GXT3-5000RT230 GXT3-6000RT230

32A

4mm2 (10 AWG)

6mm2 (8 AWG)

2.26 Nm (20 in-lb) L

OUTPUT

INPUT

Quick Start Guide – 5000-6000VA RT230 Models

The Liebert GXT3 is shipped with the following items:

• Terminal Block Communication terminals

• Compact disc with:

o Liebert MultiLink® o Configuration program o User manual (electronic version)

• USB cable, one; 2m (6-1/2 ft.) long

• Rack handles with mounting hardware

• Plastic tower support base, one set

• Plastic Bezel

• Warnings, safety instructions booklet and WEEE recycling sheet (ISO 14001 compliance)

If the UPS is intended to be installed in the Tower orientation, locate the support base and spacers then assemble the two stand assemblies with an even number of spacers in each assembly. Insert the UPS between the support base assemblies with adequate space between the assemblies as shown in the picture below. Note the display should be

located on the upper half of the unit in the Tower orientation. To rotate the display with the bezels removed, depress the grooved tabs on the sides and rotate it 90 degrees clockwise. If the USP is to be installed in a rack enclosure, follow the

instructions provided with the rack mounting hardware for proper installation.

The UPS is hardwired input with a conduit entry knockouts provided. Input and output wiring should be installed in separate conduits. All wiring should be done in accordance to all local and national electrical codes. Before wiring the UPS ensure that the breaker in the external upstream panelboard is OFF.

Terminal Block Connections

5000-6000 VA models

The UPS is equipped with a POD containing output receptacles; connect the equipment to be protected to the output receptacles.

1 SLI-23185QS6_Rev0_09-2012

Input Circuit Breaker

Maintenance

Bypass Breaker

Output Circuit Breaker

Liebert GXT3 UPS

GXT3-5000RT230

and

GXT3-6000RT230

IT Power System

Connector

(with cover removed)

GXT3-5000RT230

and

GXT3-6000RT230

IT Power System

Access Cover

External Battery

Cabinet Connector

for

GXT3-240VBATTCE

The Liebert® GXT3™ 5000-6000 VA RT230 models are compatible with IT Power Systems. To configure the unit for operation on the IT Power system, remove the 2 screws securing the cover plate in the lower right hand side on the rear of the unit and disconnect the jumper, then replace the cover and secure with the screws.

2 SLI-23185QS6_Rev0_09-2012

+ 2 hidden pages