LG Innotek REBETZ75E Users Manual

7.5” 3-color Graphic type ESL

User manual

대외비 2급

Copyrightⓒ. 2018. All Rights Reserved.

1. Overview

 Remote control device provides customer with several functions as below

 Waking Tag up from sleep mode

 Updating new purchase image on Tag

 Deleting purchase image on Tag

 Returning a Tag to be factory settings

대외비 2급

Display Area

A remote controller or

a NFC Device contact point for communication.

 Remo-con description

Profile Hook

Battery Cover

 LED : One of any buttons is pushed, red led turns on.

 Registration : Updating New Purchase Information on Tag

 Release : Deleting Purchase Information on Tag

 Reset : Returning a Tag to be factory settings

 Keep Alive : Waking Tag up from sleep mode

Copyrightⓒ. 2018. All Rights Reserved.

After sending some data to a Tag, red led will turn off.

2. Updating new purchase image on Tag

☜

대외비 2급

To change purchase information on Tag, perform the following steps :

1. Put remote controller near center of Tag‟s display

2. Press and hold „Registration‟ button on remote controller until Red LED off

(about 0.5 seconds)

3. When Tag is successfully received „Registration‟ data from remote controller, Tag‟s

display will be changed to “Connected” for a few minutes. That means Tag hides

purchase image to read Tag‟s IEEE MAC address through the Barcode scanner.

4. In NMS Client, download new purchase image to the Tag in registration status

5. When image downloading is finished successfully, Tag‟s display will be changed to new

purchase image

Case1) If image downloading is failed, Tag‟s display will be changed to “Busy”.
After “Alive Time”, this Tag will be download new purchase image again

Copyrightⓒ. 2018. All Rights Reserved.