LG TS105CM Manual book

Safety Information

Read carefully and thoroughly through this booklet as it contains important safety information that will protect the user from unexpected dangers and prevent potential damages to the product.

This booklet is divided into 2 parts : Warning and Caution.

:This is a warning sign specifying user’s applications which might be dangerous.

: This is a sign specifying ‘Strictly Forbidden’ applications.

WARNING: Failure to comply with the instructions under this sign may result in major physical injuries or death.

CAUTION: Failure to comply with the instructions under this sign may result in minor physical injuries or damages to the product.

	WATER	WARNING
	HEATER
	SAFETY	• Under certain conditions hydrogen gas may be produced in a water heater that has not been
		used for two weeks or more. Hydrogen gas can be explosive under these circumstances.
		If the HOT water has not been used for two weeks or more, prevent the possibility of
		damage or injury by turning on all Hot water faucets and allowing them to run for several
		minutes. Do this before using any electrical appliance which is connected to the HOT
		water system. This simple procedure will allow any built-up hydrogen gas to escape. Since
		the gas is flammable, do not smoke or use an open flame or appliance during this process.
	PROPER	CAUTION
	INSTALLATION
		•Thebaseopeningmustnotbeobstructedbycarpetingwhenthewashingmachineisinstalledona
		carpetedfloor.
		•Installorstorewhereitwillnotbeexposedtotemperaturesbelowfreezingorexposedtotheweather.
		If the product is exposed to such conditions, electric shock, fire, break down or
		deformation may occur.
		•Properlygroundwashertoconformwithallgoverningcodesandordinances.Followdetailsin
		InstallationInstructions.
		If not grounded properly, break down and leakage of electricity may occur, which may
		cause electric shock.
		•Mustbepositionedsothattheplugisaccessible.
		If the plug is placed between the wall and the machine, it may get damaged, possibly
		causing fire or electric shock.
		•Makesuretheplugiscompletelypushedintotheoutlet.
		Failure to do so may cause electric shock and fire due to overheating.