LG Electronics Inc. 1 19-4-8
JLR VDC User Manual
TA4HEB-N Introduction
VDC (Vehicle Domain Controller)
Telematics module device equipped in the JLR(Jaguar Land Rover) vehicles.
In charge of wireless communications in LTE-A/LTE/WCDMA/GSM network
Platform for Telematics Virtual Machine (VM) and other VMs based on Hypervisor
TA4HEB-N supports GSM850/1900, WCDMA B2/4/5, LTE B2/4/5/7/12/26, 2.4/ 5GHz WLAN (UNII 1, 3)
Service types which are provided by VDC
Voice service : eCall, bCall1) via TSP2)
SMS service : MO/MT SMS between Telematics VM – TSP2)
Data service : Telematics services between Telematics VM – TSP
1/10
LG Electronics Inc. 2 19-4-8
Major functions of VDC (TA4HEB-N)
Multi-mode LTE, Wi-Fi 11ac-Client, Ethernet connection.
Micom for a vehicle interface and a power control, AP for an Ethernet interface and Wi-Fi operation
Audio circuitry for Emergency Call and Breakdown Call.
Cellular
Operating Frequency Band
Common Name Uplink Downlink GSM/EDGE UMTS FD-LTE
2100 (B1) 1920–1980 2110–2170
1900(B2) 1850–1910 1930–1990 V
1800 (B3) 1710–1785 1805–1880
850 (B5) 824–849 869–894 V V V
2600 (B7) 2500–2570 2620–2690 V
900 (B8) 880–915 925–960
800(B20) 832–862 791–821
850(B26) 814–849 859–894 V
700(B28) 703–748 758–803
Wi-Fi
VDC (Vehicle Domain Controller) supports highly integrated multimode, multiband RF CMOS transceiver IC. It
provides a single-chip solution for LTE carrier aggregation support up to 20 MHz+20 MHz for 2DLCA. For the
WiFi, Qualcomm engine are used. Overall the VDC directly supports with up to 2 GSM bands, 3UMTS bands
and 6 FDD-LTE bands with 2DLCA. Additional Qualcomm IC as QCA6574 support WiFi 11ac.
VDC is operating with LGE shark antenna approved for use with the device.
2/10
RFx information
The strength of the RF field produced by the wireless module or modules
embedded in the TCU is well within all international RF exposure limits known
at this time. Because the wireless modules embedded in the TCU emit less than
the maximum amount of energy permitted in radio frequency safety standards
and recommendations, the manufacturer believes these modules are safe for
use.
Regardless of the power levels, care should be taken to minimize human
contact during normal operation. This module should be remain more than 20
cm (8 inches) from the body when wireless devices are on and transmitting.
This transmitter must not be collocated or operated in conjunction with any
other antenna or transmitter. Operation is subject to the following two conditions:
(1) this module does not cause interference , (2) this module accepts any
interference that may cause undesired operation.
Information for the integrator
The integrator must not provide information to the end user regarding how to
install or remove this RF module in the user manual of the end product. The user
manual that is provided by the integrator for end users must include the following
information in a prominent location. To comply with FCC RF and IC RSS‐102
exposure requirements, the antenna used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be
collocated or operated in conjunction with any other antenna or transmitter. The
label for the end product must include FCC ID: BEJTM05GTJN or A RF
transmitter inside, IC: 2703H-TM05GTJN.