LG TM05GAJN User Manual

1. P-IVI Introduction, Specification

 P-IVI (Plugin In-Vehicle Infotainment)

 IVI device equipped in the JLR(Jaguar Land Rov er) vehicles.
 In charge of wireless communications in LTE-A/L T E/WCDMA/GSM network
 Multi functional AVN such as Broadcast, Media, Phone and so on

 P-IVI Specification

1. Model Name : TM05GAJN

2. Supported band : GSM850/1900, WCDMA B2/4/5, LTE B2/4/5/7/12/26

3. Supply Voltage : 6.5~16V

4. DC Current : ~ 7A

5. T emperature Range : (-)40 ~ 75ºC

<Major Functions>

LGE Confidential

2. P-IVI Specification

 P-IVI Specification

- RF Band Information

GSM/UMTS/LTE

Band Tx [MHz] Rx[MHz]

B2 1,850~1,910 1,930~1,990 FDD
B4 1,710~1,755 2,110~2,155 FDD
B5 824~849 869~894

B7 2,500~2,570 2,620~2,690 FDD
B12 699~716 739~746 FDD
B26 814~849 859~894

2DL CA (Carrier Aggregation) band combination

Frequency

FDD/TDD RoW (TM05GAJN)

GSM,WCDMA,LTE

WCDMA

FDD

FDD

CA_3C, CA_7B, CA_7C, CA_3A-3A, CA_7A-7A, CA_1A-3A, CA_1A-5

A, CA_1A-7A,CA_1A-8A, CA_3A-5A, CA_3A-7A, CA_3A-8A, CA_3A-2

GSM, WCDMA, LTE

LTE

LTE

LTE

0A, CA_5A-7A,CA_7A-20A

LGE Confidential

3. Appendix

RFx information

The strength of the RF field produced by the wireless module or modules embedded in the P/G-IVI is well within all international RF

exposure limits known at this time. Because the wireless modules embedded in the P/G-IVI emit less than the maximum amount of
energy permitted in radio freq uency safety standards and rec ommenda tio ns, the manufactu rer bel iev es these module s are safe for
use.

Regardless of the power level s, care should be taken to minimize human c ontact duri ng nor mal operati on . This modul e shoul d be

remain more than 20 cm (8 inches) from the body when wirel ess devices are on and transmitti ng.

This transmitter must not be col l ocat e d or operated in conj unc ti o n with any other antenna or transmitter . Operation is subject to the

following two condition s: this module does not cause interference , (2) this module accepts any interference that may cause
undesired operation.

Information for the integrator

The integrator must not pr ov i de i nforma ti o n to the end user regardi ng how to install or remove this RF module in the user manual

of the end product. The user manual that is provi ded by the integrator for end users must include the follow i ng i nformatio n i n a
prominent location. T o comply w it h FCC RF and IC RSS‐102 exposure requirements, the antenna used for thi s transmitter must be
installed to pr ovide a separation di st ance of at least 20 cm from all persons and must not be c oll oc ated or operated in conjunc ti o n
with any other antenna or transmitter. The label for the end product must include FCC ID: BEJTM05GAJN or A RF transmitter
inside, IC: 2703H-TM05GAJN.

LGE Confidential

3. Appendix

Approbation FCC

This module complies with FCC/IC rules.
FCC : Part 22, Part 24, Part 27, Part 90
ISED : RSS-130, RSS-132, RSS-133, RSS-139, RSS-199, RSS-247
Furthermore, this device complies with FCC radiation exposur e limits set forth for uncontrolled environmen ts.

This module must be installed and oper ated w i th minimum distance of 20 cm between the radiating eleme nt and t he user.
This module must not be co-l ocated w it h any other transmitters or antennas.
To comply with FCC regulations limiting both the maximum RF output power and human ex posure to RF radiation, the max imum

antenna gai n i ncl udi ng cable loss in a mobile-on ly ex posure conditi on must not exceed the v alues listed in the followi ng tabl e.

Band Frequency Range [MH z ] Maximum Antenna Gain[dBi]

GSM850 824~849 -2.45

GSM1900 1850~1910 1.13
WCDMA(B2) 1850~1910 1.13
WCDMA(B4) 1710~1755 1.45
WCDMA(B5) 824~849 -2.45

LTE(B2) 1850~1910 1.13
LTE(B4) 1710~1755 1.45
LTE(B5) 824~849 -2.45

LTE(B7) 2500~2690 -0.63
LTE(B12) 699~716 -0.98
LTE(B26) 814~849 -2.45

LGE Confidential

3. Appendix

Approbation FCC

To satisfy the FCC’s exter i or labeli n g requirements, the following text must appear on the exteri or of the end pr oduct .
Contains transmitt er module FCC ID: BEJTM05GAJN
Contains transmitt er module IC: 2703H-TM05GAJN

Changes or modification s to this equipment may cause harmful interference unless the modification s are expressl y approved in the

instruction manual. Users may lose the authority to operate this equipment if an unauthorized change or codification is made.

Note: If this module is intended for us e i n a portable device, additional testing will be required to satis fy the RF exposur e and SAR

requirements of FCC Part 2.1093 and RSS-102.

LGE Confidential

3. Appendix

Approbation FCC

Note: The OEM integrator is responsible for ensuring that the host product which is installed and operating with the module is in

compliant with Part 15B unintentional Radiat or requi rements, pl ease note that For a Class B digital device or peripheral, the
instructions furnished t he user manual of the end‐user product shall include the following or similar statement, placed i n a
prominent locati on in the text of the host product manual:

Note: This equipment has been teste d and found to comply w i th the li mi ts for a Clas s B digi tal device, pursuant to Part 15 of t he

FCC Rules. These limits are designed to provide reasonable prot ection again st harmful interferen ce in a residential inst allation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interferenc e to radio communicatio ns. How ever, there is no guarantee that interference will not
occur in a particular i ns tal lat ion.

If this equipment does cause harmful inter ference to radio or telev is ion rec eption , w hich can be determine d by turning the

equipment off and on, the user is encourage d to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipmen t and receiv er.
Connect the equipme n t into an outlet on a cir cui t dif fer en t from that to which the receiv er is connecte d .
Consult the dealer or an experienced radio/TV technician for help.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et

Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :(1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.

L’étiquette d’homologation d’un module d’Innovation, Sciences et Développement économique Canada devra être posée sur le

produit hôte à un endroit bien en vue, en tout temps. En l’absence d’étiquette, le produit hôte doit porter une étiquette sur laquelle
figure le numéro d’homologation du module d’Innovation, Sciences et Développement économique Canada, précédé du mot «
contient », ou d’une formulation similaire allant dans le même sens et q ui va comme suit :

Contient IC : 2703H-TM05GAJN est le numéro d’homologation du module.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR‐102 établies pour un environnement non contrôlé. Cet

équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.

LGE Confidential

3. Appendix

RF Exposure (MPE)

This equipment complies wi th FCC and IC RF Radiation exposure limi ts set forth for an uncontrolled environment. This devi ce and

its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

This equipment should be installed and operated w ith a minimum distance of 20 cm between the radiator and your body.
Cet équipement est conforme à l'exposition de FCC et IC rayonnements RF limites é-tablies pour un environnement non contrôlé.

L’antenne pour ce transmetteur ne doit pas être même endroit avec d’autres émetteur sauf conformément à FCC et IC procédures
de produits Multi-émetteur. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et
votre corps.

LGE Confidential

4. Regulatory notice to host manufacturer (KDB 996369 D03)

2.2 List of applicable FCC rules
This module has been granted modular approval as below listed FCC rule parts.

- FCC Rule parts 22, 24, 27, 90

2.3 Summarize the specific operational use conditions

- The OEM integrator should use equivalent antennas which is the same type and equal or less
gain then an antenna listed in 2.7 in this instruction manual.

2.4 Limited module procedures

- This limited module is directly on PCB and it is defined the area on the PCB. Therefore any extra instructions are
not needed. This limited module is compatible with P/G-IVI host device. Basically, all the power source is from the
host device such as 0.8V~ 3.075V for MSM Part and 1V~3.9V for RF Part(Main RF Transmitter part and other RF
Ics). This limited module including MSM Part and RF Part such as lines and ICS is in the shield can on the host
PCB, but the detailed test data such as FCC data is reviewed. If the power from the Host is applied, the limited
module is powered on the MSM8996AU and it controls WTR and the installed NVs to be maintained the limitations.

2.5 Trace antenna designs

- N/A

2.6 RF exposure considerations
The module has been certified for integration into products only by OEM integrators under the following condition:

- The antenna(s) must be installed such that a minimum separation distance of at least 20 cm is
maintained between the radiator (antenna) and all persons at all times.

- The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
As long as the three conditions above are met, further transmitter testing will not be required.
OEM integrators should provide the minimum separation distance to end users in their end product manuals.

LGE Confidential

4. Regulatory notice to host manufacturer (KDB 996369 D03)

2.7 Antennas list
This module is certified with the following integrated antenna.

- Type: Shark Antenna Peak gain (dBi)
Any new antenna type, higher gain than listed antenna should be met the requirements of FCC

rule 15.203 and 2.1043 as permissive change procedure.

2.8 Label and compliance information
The module is labeled with its own FCC ID and IC Certification Number.
If the FCC ID and IC
Certification Number are not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the
enclosed module. In that case, the final end product must be labeled in a visible area with the
following:
“Contains FCC ID: BEJTM05GAJN”
“Contains IC: 2703H-TM05GAJN”

LGE Confidential

4. Regulatory notice to host manufacturer (KDB 996369 D03)

2.9 Information on test modes and additional testing requirements

- OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC
peripheral requirements, additional transmitter in the host, etc.).

- Tools to control the product into RF test mode in high/mid/low channels, hopping or non-hopping mode : Mobile
test unit_CMW500 (R&S)

- What power level is used

: GSM 850 Max power : 32 dBm (tolerance : +/-2 dBm)
: GSM 1900 Max power : 28.5 dBm (tolerance : +/-2 dBm)
: WCDMA B2/B4/B5 Max power: 23 dBm (tolerance: +/-2 dBm)
: LTE B2, B4, B5, B7, B12, B26 Max power : 23 dBm (tolerance : +/- 2dBm)

2.10 Additional testing, Part 15 Subpart B disclaimer

- The final host product also requires Part 15 subpart B compliance testing with the modular

transmitter installed to be properly authorized for operation

LGE Confidential