LG TLVLM3IU-N User Manual

Product name : Telematics

TLVLM3IU-N

(Online Connectivity Unit)

Telematics

LG Electronics Inc.

What is the OCU(Online Connectivity Unit)

Product Image

Telematics product supporting Emergency Call/LTE service

service

Function

• Emergency Call

• Mobile Online Serv

• Positioning/Dead Reckoning

-GPS/G

NSS/Beidu/Galileo/SBAS

ices

LGE Confidential

Specification

Specification Dimension

GSM 850/1900

Supporting Bands

Modem Chip Qualcomm MDM9628

GNSS GPS/Glona

Bluetooth No

WiFi

Size 130mm x 70.14mm x 37.5mm

Weight 300g

WCDMA B2/B4/B5
LTE FDD B2/B4/B5/B12/B17

ss/Beidou/SBAS/Galileo

2.4 GHz WIFI(b,g,n20)

Power DC 12V , 2A

LGE Confidential

OCU3 Low Hardware block diagram

Confidential

LGE Confidential

Notice
FCC
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

with part 15 of the FCC Rules. Operation is subject to the following two

This device complies with FCC radiation exposure limits set forth for
environment. This device should be installed and operated with minimum distance
20cm between the radiating element of this device and the user.

This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and operated with minimum distance 20cm
between the radiating element of this device and the user.
IC
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
This radio transmitter has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna impedance for
each antenna type indicated. Antenna types not included in this list, having a gain greater
than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p) is not more than
that necessary for successful communication.

an uncontrolled

Le présent émetteur radio a été approuvé par Industrie Canada pour fonctionner avec les
types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance
requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont
le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de
l'émetteur. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain
de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité
nécessaire à l'établissement d'une communication satisfaisante.

This device should be installed and operated with minimum distance 20cm between the
radiating element of this device and the user.

Cet appareil doit être installé et utilisé avec une distance minimale de 20 cm entre l'élément
rayonnant de cet appareil et l'utilisateur.

The maximum antenna gain including cable lo

Band

B2 1850 ~ 1910
B4 1710 ~ 1755
B5 824 ~ 849

B13 777 ~ 787

B12(17) 699 ~ 716

Frequency

Range[MHz]

(Impedance: 50Ω)

ss must not exceed the table below;

Maximum antenna gain

(including cable loss)[dBi]

Main antenna

including cable

-4.26 -

-5.50 -

-2.52 -

-2.39 -

-2.92 -

-

Manufacture : LG Electronics Inc.

11/11