LG SC200 Owner’s Manual

Install Manual

HECTO Series Screen

(HECTO/HECTO2/HECTOB)

Please read the safety information carefully before using this product.

(Refer to this manual when installing the screen with the Ez bracket and the ceiling-type bracket.)

SC200

www.lg.com

*MFL67864907*

P/NO.: MFL67864907 (1405-REV01)

SAFETY PRECAUTIONS

2

SAFETY PRECAUTIONS

Please take note of safety instructions to prevent any potential accident or
misuse of the product.

ySafety precautions are given in two forms, i.e. WARNING and CAUTION as detailed

below.

WARNING: Failure to follow the instructions may cause serious injury and even

death.

CAUTION: Failure to follow the instructions may cause minor injury to persons

or damage to the product.

yRead the owner's manual carefully and keep it for future reference.

Installation

WARNING

yThe product should be installed by a

qualified professional specified by the
retail store.

- The product installation by
a unqualified person is dangerous
and may cause personal injury.

yThis product should be installed

where its weight can be properly
supported.

- Otherwise, it may fall and
cause personal injury.

yWhen moving or replacing this

product after installation, contact a
qualified installer specified by the
retail store.

- If an unqualified person moves and
installs this product, it may cause
safety issues as this installation
requires specialized training.

yDo not hang on this product or

strike it in any way.

- Otherwise, it may fall and cause
injury.

CAUTION

yFollow the instructions in the manual

to properly install this product.

- Otherwise, it may cause serious
injury or product damage.

yWhen installing or adjusting the

height of this product, two or
more people are required.

- If you do it by yourself, you may
drop it, causing personal injury or
product damage.

yWhen installing the product, first

check that the wall is strong enough
and use the anchors and screws
provided.

- Otherwise, they may not bear
the weight of this product and
cause safety issues.

yWhen drilling holes into the wall,

make sure you use a drill and drill bit
with the specified diameter.
Ensure that you also follow the
instructions regarding the depth of the
holes.

- Otherwise, this product may not be
installed properly and cause
safety issues.

yDo not clean the product with a wet

towel, and do not place a heater or
humidifier beneath it.

- Moisture, steam, or heat

permeating into this product
may result in fire, electric shock, or
product damage.

yKeep this product away from

sprinklers, sensors, high-tension
wires, and power sources. Do not
install it in a location where vibrations
or impact shocks are likely to occur.

yWear work gloves when installing this

product. Do not use bare hands.

- Otherwise, personal injury may
occur.

SAFETY PRECAUTIONS

3

PREPARATION

4

PREPARATION

Accessories

Check the accessories provided with the product.
The picture may be different from the actual product.
Accessories are subject to change without prior notice in order to improve
the performance of the product. New accessories may be added or old ones may be
removed.

2 wall brackets

6 anchors for attaching

the magnet (Ф 8 mm)

6 magnets

2 washers

Preparations

Guide paper 1 tape for attaching

guide paper

6 screws for attaching

the magnet (Ф 8 mm)

1 sheet of warp

correction sponge

18 steel spacers

Install manual

A Ф 8 mm drill bit for concrete, a hammer (impact) drill, a level, a tape measure, screw­drivers, and tape.

PREVIEW OF THE SCREEN INSTALLATION

410 mm

PREVIEW OF THE SCREEN
INSTALLATION

Installation position

The picture may be different from the actual product.

5

Screen

HECTO*

Installation procedure

1

Decide the desired position of your HECTO* screen and place the HECTO* in the
center of the position.

2 Attach the guide paper according to the HECTO*'s position.
3 Drill holes according to the guide paper and attach the wall brackets on the wall.
4 Hang the screen onto the wall brackets and then project an image on the screen.
5 Adjust the position of the projected image and then attach the screen bottom.

NOTE

yIf the temperature changes abruptly and drastically, the screen may be distorted

temporarily. However, placing it at room temperature will restore the normal state.

CAUTION

yStrong impact may damage the screen.