LG RDD264, MDT354-A0U, RDD264-A0U User guide

MDD64 (MDD64-A0U, MDS64V) MDD104 (MDD104-A0U, MDS104V)

MDT354 (MDT354-A0U, MDS354V/W) RDD264 (RDD264-A0U, RDS264V)

As an Energy Star® Partner, LG has determined that this product or product models meet the Energy Star® guidelines for energy efficiency.

Energy Star® is a U.S. registered mark.

P/NO : MFL41698467

RDD264-A0U_DARELL_ENG_8467.indd 1

ENGLISH

PORTUGUÊS

Français

2009.3.30 4:0:26 PM

Safety Precaution

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage

within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing)

instructions in the literature accompanying the product.

WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING: Do not install this equipment in a confined space such as a book case or similar unit.

CAUTION: Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.

Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from over heating. The openings shall be never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product shall not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instruction has been adhered to.

CAUTION: This product employs a Laser System.

To ensure proper use of this product, please read this owner’s manual carefully and retain it for future reference. Shall the unit require maintenance, contact an authorized service center.

Use of controls, adjustments or the performance of procedures other than those specified herein may result in hazardous radiation exposure.

To prevent direct exposure to laser beam, do not try to open the enclosure. Visible laser radiation when open. DO NOT STARE INTO BEAM.

CAUTION: The apparatus shall not be exposed to water (dripping or splashing) and no objects filled with liquids, such as vases, shall be placed on the apparatus.

CAUTION concerning the Power Cord

Most appliances recommend they be placed upon a dedicated circuit; That is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be certain.

Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire. Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized service center.

Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance.

To disconnect power from the mains, pull out the mains cord plug. When installing the product, ensure that the plug is easily accessible.

in NIGERIA

POWER: This unit operates on a mains supply of 200-240V, 50/60Hz.

WIRING : This unit is supplied with a BSI 1363 approved 13 amp mains plug, fused at 3 amp. When replacing the fuse always use a 3 amp BS 1362, BSI or ASTA approved type. Never use this plug with the fuse cover omitted. To obtain a replacement fuse cover contact your dealer. If the type of plug supplied is not suitable for the mains sockets in your home, then the plug should be removed and a suitable type fitted. Please refer to the wiring instructions below:

WARNING: A mains plug removed from the mains lead of this unit must be destroyed. A mains plug with bared wires is hazardous if inserted in a mains socket. Do not connect either wire to the earth pin, marked with the letter E or with the earth symbol or coloured green or green and yellow.

If any other plug is fitted, use a 3 amp fuse, either in the plug, or at the distribution board.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following codes:

- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the wires in the mains lead of this unit may not correspond with the coloured marking identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

RDD264-A0U_DARELL_ENG_8467.indd 2

2009.3.30 4:0:26 PM

Contents

Safety Precaution	2
Contents	3
Setting up	4
Hooking up the unit	5
Main Unit	6
Remote control	7
OSD Initial language setting - Optional	8
Initial Setting the Area Code	8
Adjust the general settings	8-10
Setting the sound mode	10-11
Setting the clock	11
Displaying Disc Information	12
Playing a Disc	12-14
Viewing photo files	14
Listening to the radio	15
Listening to the cassette tapes	15
Listening to music from your external device	16
Using an USB device	16

Recording to USB	17
Recording to TAPE	18
Synchronized Recording from CD to TAPE	18
Language Codes	19
Area Codes	19
Troubleshooting	20
Types of Playable Discs	21
Specifications	22

RDD264-A0U_DARELL_ENG_8467.indd 3

2009.3.30 4:0:27 PM

Setting up

Attaching the speakers to the unit

Connect the black end of each wire to the terminals marked - (minus) and the other end to the terminals marked + (plus).

To connect the cable to the each speakers, press each plastic finger pad to open the connection terminals on the back of each speaker. Insert the wire and release the finger pad.

Be careful of the following

•Be careful to make sure children not to put their hands or any objects into the *speaker duct.

* Speaker duct : A hole for plentiful bass sound on speaker cabinet (enclosure).

MDT354 (2.1 channel)

COLOUR	SPEAKER	POSITION
Red	Front	In front of you, to the right of the screen.
White	Front	In front of you, to the left of the screen.
Orange	Sub Woofer	This can be placed in any front position.

MDD64/MDD104/RDD264 (2 channel)

COLOUR	SPEAKER	POSITION
Red	Front	In front of you, to the right of the screen.
White	Front	In front of you, to the left of the screen.

RDD264-A0U_DARELL_ENG_8467.indd 4

2009.3.30 4:0:27 PM

Hooking up the unit

VIDEO OUT jack connection

Connect the VIDEO OUT jack on the unit to the corresponding input jacks on your TV using a Video cable.

Antenna connection

Fit the AM loop aerial to its stand

Connect the AM loop aerial to the unit.

Connect the FM aerial

The reception will be at its best when the two loose ends of the aerial are in a straight line and horizontal.

COMPONENT VIDEO OUT (PROGRESSIVE SCAN) jacks connection

Connect one end of the component (Y PB PR) cable to the COMPONENT VIDEO OUT (PROGRESSIVE SCAN) jack on the unit and other end to the COMPONENT INPUT jack on your TV.

AUX IN (L/R) jacks connection

Connect a VCR or Auxiliary device, etc. to the INPUT jack of this unit.

Press the FUNCTION button on the remote control until the “AUX” indicator is displayed in the display window.

RDD264-A0U_DARELL_ENG_8467.indd 5

2009.3.30 4:0:27 PM

Main unit

1	Disc tray			12	Z OPEN/CLOSE: Open or close your CD
2	1/\ Turn ON/OFF.			13	door.
3	Display window				DISC SKIP
4	CLOCK			14	Choose a desired disc.
					EQ
5	TIMER	1			You can choose fixed sound
6	USER EQ	2	12	15	impression
7	Selects DVD/CD function.				XDSS
	Selects TUNER function.	3	13		Extreme Dynamic Sound System
	Selects TAPE function.	4	14		Reinforce the treble, bass and
		5
	Selects AUX function.		15		surround effect.
		6
8	SET Confirms the settings.		16		MP3 OPT
	(TIMER/ CLOCK)				Optimizes compressible MP3 files so
		7			that it improves the bass sound.
	CD II Pauses
			17	16	REC/PAUSE(USB)
	USB Selects USB function.
	DEMO In power off state to	8	18	17	LG EQ
	demonstrate the function on display	9	19		You can choose fixed sound
	window. To cancel it, press 1/\ or	10			impression
	this button again.		20	18
					DUBB. Recording from tape to tape.
	PRESET (-)
					CD SYNC. CD to Tape Synchronized.
	TUNING .m (-)		21
9					B PRESET (+)
	Headphone jack
					M> TUNING (+)
10	USB connector			19	x STOP
11	Cassette Door 1, 2				MIC VOL.
		11			Adjust microphone volume.
				20	MIC 1, 2
				21	Volume control

Power Save Mode

You can set up the unit into an economic power save mode.

In power-on status, press and hold 1/\ button for about 3 seconds.

- Nothing is displayed in the display window when the unit is turned off.

To cancel, press 1/\.

RDD264-A0U_DARELL_ENG_8467.indd 6

2009.3.30 4:0:28 PM

Remote control

a

b

c

d

1

1 POWER: Switches the unit ON or OFF. FUNCTION: Changes the function.

SLEEP: Sets the System to turn off automatically at a specified time. (Dimmer : Dims the LED (Light-emitting diode) of front panel by half in power-on status.)

Z OPEN/CLOSE: Open or close your CD door.

TITLE: If the current DVD title has a menu, the title menu appears on the screen. Otherwise, the disc menu may appear.

DISPLAY: Accesses On-Screen Display. MENU: Accesses the menu on a DVD disc. SETUP: Accesses or removes setup menu.

I i U u (left/right/up/down): Used to navigate on-screen displays.

ENTER: Acknowledges menu selection.

PRESET (U u): Selects programme of Radio. TUN. -/+ (I i): Tunes in the desired radio station.

2 RETURN (O): Moving back wards in the menu. REC (z): Recording to USB/ TAPE.

STOP (x): Stops playback or recording. PLAY (B): Starts playback.

MO./ST.: MONO/STEREO FM mode state, selects MONO or STEREO by pressing this button.

PAUSE/STEP(X): Pausing playback. SCAN(bb/BB): Search backward or forward.

SKIP(./>): Go to next or previous chapter/track/Title.

Remote control Operation

Point the Remote Control at the display window and press the buttons.

Remote control Battery Installation

1 Detach the battery cover on the rear of the remote control. 2 Insert the R03 (size AAA) battery with 3 and # aligned

correctly.

3

D.SKIP: Choose a desired disc. MUTE: To mute the sound.

VOL (Volume) +/-: Adjusts speaker volume.

EQ/ LG EQ (EQUALIZER Effect): You can choose sound impressions.

0-9 numerical buttons: Selects numbered options in a menu.

REPEAT/RANDOM : To select a play mode. (Random, repeat)

SUBTITLE: During playback, you can select a desired subtitle language.

4

TV Control buttons : Controls the TV. (LG TV only)

Controlling the TV.

You can control the sound level, input source, and power switching of LG TVs as well. Hold POWER (TV) and press PR/CH (+/–) button repeatedly until the TV turns on or off.

PROG./MEMO.: Accesses or removes Program menu. MIC VOL.(+/ - ): Adjusts microphone volume.

ECHO VOL.(+/ - ): Adjusts echo volume.

VOCAL FADER: You can enjoy the function as karaoke, by reducing singer vocal of music in the various source.

CLEAR: Removes a track number on the Program List.

RDD264-A0U_DARELL_ENG_8467.indd 7

2009.3.30 4:0:29 PM