LG RD3470 User Manual
6. Operating Manual
LG-RD3470
User Guide
CDMA PHONE
Contents
Introduction
Highlights
Important Information
Check Accessories
Before You Start
FCC RF EXPOSURE INFORMATION
Chapter 1. Getting Started
Cautions
Phone Overview
On screen Icons
Chapter 2. Basic Functions
Turning the Phone On and Off
Making a Call
Correcting Dialing Mistakes
Receiving Calls
Emergency Dialing
Speed Dialing
Phone Book Features
Chapter 3. Menu Features
General Guidelines to MENU Access and Settings
Names
Messages
Call History
Profiles
Display
Settings
Organizer
R World
Chapter 4. Book Features
Names
Chapter 5. Message Features
Write Message
Inbox
1234 Services
Outbox
Voice Mail
Archive
Draft
Templates
Msg Groups
Erase Msgs
Msg Settings
Chapter 6. Functions used during a call
Scratch pad
Mute
Voice Privacy
Send my number
Short DTMF
Chapter 7. Accessories
Chapter 1. Getting Started
Cautions
Using the phone in proximity to receiving equipment (i.e., TV or radio) may cause
interference.
Keep your phone in a safe place when not in use.
Only use the batteries, antennas, and chargers provided by LG. Using the wrong
accessories could void your warranty.
Only authorized personnel should service the phone and its accessories. Faulty installation
or service may result in accidents and consequently invalidate the warranty.
Do not hold the antenna while the phone is in use.
Do not use the phone in designated “no cellular phone use” areas.
Do not expose the phone to high temperature or humidity.
Avoid getting your phone wet. If the phone gets wet, turn the power off immediately and
remove the battery pack. If the phone is mal-functional, return it to the dealer for service.
Avoid shock or impact on the phone.
Phone Overview
On screen Icons
The phone screen displays several onscreen icons and onscreen icons appears when the phone is
power on.
D
Chapter 2. Basic Functions
Turning the Phone On and Off
Turning the Phone On
1. Install a charged battery pack or connect the phone to an external power source such as the
cigarette lighter adapter or car kit.
2. Press [END/PWR] for a few seconds until the red light on the top of the phone flashes.
Fully extend the antenna for the best performance.
<Note> Like any other radio device, avoid any unnecessary contact with the antenna while your
phone is on.
Turning the Phone Off
1. Press and hold until display screen will be turned off, and then release the key.
2. Protect the antenna by pushing it back into the phone, if extended.
Making a Call
When you make a call, follow these simple steps:
1. Make sure the phone is turned on.
If not, press [END/PWR].
2. Enter the phone number with area code, if needed.
3. Press [SEND].
If the phone is locked, enter the lock code.
“Call Failed” indicates that the call did not go through.
4. Press [END/PWR] to disconnect the call.
Correcting Dialing Mistakes
If you make mistakes in dialing a number, press [CLR] key once to erase the cursor positioned digit
or hold down [CLR] for at least two second to delete all digits, or simply press soft key 2 [BACK] to
exit dialing state. And, you can move the cursor by pressing [5],[6],[3],[4]
Receiving Calls
1. When the phone rings or vibrate (if the Vibrate Mode is enabled), press any key (except [END])
or depending on the Call settings.
When you press once, when a call is received, the phone stops ringing or vibrating
depending on the mode it is in. Press twice to disconnect.
2. To end an answered call press [END].
In call waiting mode, the present call is on hold as you answer another incoming call.
This service is provided by your service provider.
When the call waiting function is activated, your phone will beep to let you know if you have an
incoming call.
3. If you are not in the condition to receive call, pressing Soft key 2 will send a Preset SMS to
Caller. The SMS can be editted using "Edit SMS on Call Reject" function given under Settings' Call.
Dialing a call from Phone Book
You can place a call from any memory location either by speed dialing or by pressing [SEND] while
looking up the memory location.
One-Touch Dialing : One-touch dialing is a convenient feature which enables you to dial
frequently used numbers in your speed-dial data by pressing a key .
Entry 9 is designated to Emergency Call.
For locations 1 to 8, you can use one-touch dialing (if enabled, see “One-Touch” on page
9.) by pressing and holding down the key corresponding to the memory location.
OR
Press digit, then press [SEND].
Two-Touch Dialing (Speed Dialing) : This dialing feature enables you to dial numbers in your
phone book through two keys (for locations 10 to 99).
1) Press the first digit.
2) Press and hold the key of the second digit.
OR
1) Press the first and second digits, then press [SEND].
Dialing from a Memory List
1) From a memory list, press the scroll keys to go to the memory location you want.
2) Press [SEND].
Dialing from a Memory Location.
On viewing and checking the memory location to call, press [SEND].
Chapter 3. Menu Features
General Guidelines to MENU Access and Settings
1. Press Soft Key 1 [Menu]. The animation of menu category will appear on the display screen.
2. Press Soft key 1 [Ok]. The menu items will appear on the display screen.
3. Press[v] to go through the list of menu features, or use the side keys.
4. Press the corresponding number to the menu item that you want to select. Then the sub-menu
list will appear on the screen.
5. Press the appropriate key to select the sub-menu you want to access.
6. Select preferred settings, using the [v] keys. Press Soft Key 2 [Back] to go one step backward
while accessing menu or selecting settings.
7. Press Soft Key 1 [Ok] to save the settings or Soft Key 2 [Back] to cancel without saving.
Names ([Menu]+[1])
see “Book Feature” on page 10.
Messages ([Menu]+[2])
see “Message Feature” on page 12.
Call History ([Menu]+[3])
Allows you to view list of all Missed/Received/Dialled Calls. (Maximum 60 numbers are possible
including Missed, Received and Dialled)
Save the phone numbers taken while talking and can view the list of numbers present in In Call
Memo. (Maximum 20 numbers are possible)
Missed ([Menu]+[3]+ [1])
Allows you to view list of all incoming calls and you may place a call by pressing [Send].
Received ([Menu]+[3]+ [2])
Allows you to view list of all received calls and you may place a call by pressing [Send].
Dialled ([Menu]+[3]+ [3])
Allows you to view list of all outgoing calls you made and you may place a call by pressing the
Loading...