M17 Device description
Version 0.1 – Aug 26th 2009
Part 15.21 statement
" Change or Modifications that are not expressly approved by the manufacturer could void
the user's authority to operate the equipment. “
Part 15.105 statement
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Part 15 Class B Compliance
This device and its accessories comply with part15 of FCC rules.
Operation is subject to the following two conditions:
(1) This device & its accessories may not cause harmful interference.
(2) This device & its accessories must accept any interference received,
including interference that may cause undesired operation.
1.1 Feature
Copyright
Copyright © 2009 LG Electronics Inc. All Rights Reserved.
Though ever y care has been taken t o ensure t he accuracy of this document , LG Electronics I nc. cannot
accept responsibilit y for any errors or omissions or for any loss occurred to any person, whether legal or
natural, from act ing, or refraining from action, as a result of the information cont ained herein.
Information in t his document is subject t o change at any time w ithout obligation to notify any person of
such changes.
LG Elect ronics Inc. m ay have patents or patent pending applications, trademarks copyright s or other
int ellectual property right s covering subject matter in this docum ent. The fur nishing of this document
does not give the recipient or reader any license to these patents, trademarks copyrights or other
int ellectual property right s.
No part of this document may be communicated, distributed, reproduced or transmitt ed in any form or
by any m eans, electronic or mechanical or otherwise, for any purpose, without the prior written
perm ission of LG Electronics I nc.
The document is subject t o revision wit hout f urt her notice.
All brand names and product names ment ioned in this document are tradem arks or registered
trademarks of their respective owners.
1.1. Feature
Caution
To comply with FCC RF exposure compliance requirements, a separat ion distance of at least 20 cm (8
inches) bet ween the equipment and the body must be maintained.
<UE> <User>
At least 20 cm (8 inches)
M4
1.1 Feature
About This Document
Revision Hist ory
Version Dat e Comment Author
0.1 2009-04-07 Initial Draf t Sang Ha Park
References
1.1. Feature
Contents
1 General Description .........................................................................................6
1.1 Feature ................................................................................................................................................7
2 Mechanical description ................................................................................10
2.1 Dimension......................................................................................................................................... 11
3 Functional description ..................................................................................12
3.1 External connector description ......................................................................................................13
3.2 External RF connector description ................................................................................................14
3.3 Antenna description ........................................................................................................................15
3.4 External Power descript ion.............................................................................................................16
3.5 Battery description ..........................................................................................................................17
1.1 Feature
1 General Description
1.1 Feat ure
This document describes briefly the board level operations, key features and t he
environment of the M17 Platform. The purpose of this plat form is the verif ication of
LG LTE ASI C, namely ‘L1000’, and the evaluation of LG UE system performance. The
further details about t he characteristics and funct ions of L1000 are available on other
docum ents.
1.1. Feature
< Table 1. M17 Device Feat ure>
Specification L TE only
SW Date
HW
General
Interface Spec.
External port Micro USB 1 Port
Standard(SW ver.)
Band support
Main chipset
Max. Data rate
LTE USB 2.0 High Speed
LTE 3GPP Rel. 8 (Dec. 2008)
LTE 3GPP Band 17
LTE L1000 (by LGE)
LTE DL 50Mbps / UL 25Mbps
(Category2)
Remark
Transmitter
GPS Not Support
Battery Support
Tx Diversity LTE Not support
Max. Tx Power LTE 23 dBm
Band Width LTE 10MHz
UE Antenna
Selection will not
be supported
At antenna port
1.1 Feature
SW
Receiver
Interface
Modulation Method LTE Up to 16QAM
Rx Diversity LTE Support
MIMO L TE 2x2 MIMO
Band width LTE 10MHz
Modulation Method LTE Up to 64QAM
Interface protocol
USB Driver
Downloading Tool Support
LTE USB Ethernet
LTE 3 Ports (Data, DM, Control)
Adaptive
swit ching
between downlink
Transmit Diversity
and SU MI MO
Downloading t ool
for f ield upgrade
through USB port
System
selection
Authentication
&
Identity
IP support
DM (Diagnostic Monitor) Support
Prefered system selection Support 'LTE only' mode
Support System LTE only
PRL/PLMN List
User Identity Module
(IMSI)
Authentication
Numbering & Identities NAI based upon the IMSI
IPv4/6 dual IP stack LTE Support for IPv4/6 (need to test
LTE Support PLMN
LTE Device
LTE Not Support
1 1digit MDN
with Network)
LGE tool for LTE
DHCP L TE N/A
LTE Proxy mobile IPv4/6
1.1. Feature
QoS
Mechani
cal
QoS
IRAT handoff
Mechanical
Active handoff
Idle handoff
IRAT measurement N/A
Dimensions (W xD xH) 185 x 133.9 x 22.8 mm
Weight 420g
Antenna Internal Antenna (MIMO)
LTE Support
N/A
N/A
Non optimized handover
Non optimized handover
2 Mechanical description
2.1 Dimension
M17 Mechanical dim ension is 133.9 x 185 x 22.8m m.
2.1. Dimension
2.1 Dimension
3 Functional description
3.1 External connector description
LTE device has several external connectors.
DC input jack connector: External Power source, 5V TA
USB connector: USB Connect to Host (PC)
SI M socket: for LTE Authentification
24Pin connector: For debug LTE Sub board
DC input Jack USB cap SIM socket cap
3.1. External connector description
HW Reset key
24Pin connector for LTE Sub board debugging
Earphone jack connector
3.2 External RF connector description
3.2 External RF connector description
LTE MIMO ANT mobile SW
LTE device has 2 external RF connectors in order t o measure wired RF performance
characteristic.
It is configured that LTE RF front-end part is two external RF port; LTE main RF port
and LTE MIMO RF port.
LTE Main ANT mobile SW
If you want t o test wired LTE RF performance, you can use t his external RF
port(mobile switch).
3.3 Antenna description
M4 Device LTE Antenna: MI MO Antenna
Type: Carrier & PI FA
Directive: Omni-directional
LTE Band 7 Support: UL; 704~ 716(MHz), DL;734~ 746( MHz)
Max power: 2W(Maximum)
Primary Ant . : 1TX and 1RX
Secondary Ant.: 1RX
3D Primary Antenna Gain: -2.00dBi(Average)
3D Secondary Antenna Gain: -2.40dBi(Average)
3.3. Antenna description
3.4 External Power description
3.4 External Pow er descript ion
To operat e and charge the battery, plug the AC Adapter into a standard wall out let
and connect it t o the LTE trial device via the DC input jack Connector.
External power supply is DC input j ack or TA. This pow er supply specif ication is
below.
Input Voltage & Current
Output Voltage & Current
3.5 Battery description
Our LTE Trial device has a battery is used for operating LTE modem part.
Battery Capacit y for used in LTE is 2400mAh.
If the battery’s charge is complet ely run down, it takes 6 t o 7 hours t o fully recharge.
But this battery capacity is not enough to operate LTE capability; you should external
power supply, which is TA (Travel Adaptor). The mandatory power supply of the LTE
UE is supplied by TA which is distributed by the LGE.
3.5. Battery description
Loading...