LG LSC5633W, LSB5682S, LST5651S, MFL55646202, LST5601S User Manual

Website:http://ca.lge.com

Installation Manual

Electric Range

LSC5622W / LSB5611S / LST5601S / LSC5633W
LSC5674W / LSC5683W / LSB5682S / LST5651S
LRE3091S / LSE3094S / LSE3092S

Please read these instructions thoroughly before
installing and operating the range.

P/No.: MFL55646202

Part 1 SAFETY

1

BEFORE YOU BEGIN

Remove all tape and packing materials before using the range. Dispose all plastic bags after unpacking the range.
Never allow children to play with packing materials.

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, injury to person,
or damage when using the range. This guide don’t cover all possible conditions that may occur. For further
assistance contact your service agent or manufacturer.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hunt you and others. All safety
messages will follow the safety alert symbol and either the word “WARNING” or “CAUTION”. These word means :

WARNING

CAUTION

This symbol will alert you to hazards or unsafe practices which could cause serious
bodily harm or death.

This symbol will alert you to hazards or unsafe practices which could cause bodily
injury or property damage.

WARNING

• The information in this manual should be followed exactly.

- A fire or electrical shock may result causing property damage, personal injury or death.

• DO NOT step or sit on the door. Install the Anti-Tip Bracket packed with range.

- The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.

- If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip Device is
properly reengaged when the range is pushed back against the wall.

•

New branch-circuit installations (1996 NEC), mobile homes, recreational vehicles, and installations
where local codes do not allow grounding through neutral require a 4-conductor UL listed range
cord or 4 wire conduit connection.

•

The middle (neutral or ground) wire of the power cord or 3-wire conduit has to be connected to the
middle post of the main terminal block. The remaining two wires of the power cord or conduit have
to be connected to the outside posts of the main terminal connection block.

- Failure to do can result in severe personal injury, death or electrical shock.

•

Only a 4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use with
ranges with closed-loop connectors, open-end spade lugs with upturned ends shall be used. The
middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the middle post of
the main terminal block. Other two wires of the power cord or conduit have to be connected to the
outside posts of the main terminal connection block. The 4th ground wire must be connected to
the frame of the range with the ground screw.

- Failure to do can result in severe personal injury, death or electrical shock.

CAUTION

• Put on gloves during installation procedure.

- Failure to do so can result in bodily injury.

• Make sure that the wall covering, countertop and cabinets around the range can withstand the heat

(up to 194°F) generated by the range.

- Discoloration, delamination or melting may occur.

- This range has been designed to comply with the maximum allowable wood cabinet temperatures of 194°F.

• Cabinet storage space located above the surface units should be avoided.

- The risk of burns or fire by reaching over heated surface units can be eliminated.

• Install a range hood that projects horizontally a minimum of 5 inches beyond the bottom of the

cabinets If cabinet storage is to be provided.

- The risk can be reduced.

2