LG LRE30453ST/00, LRE30757SW/00, LRE30955ST/00, LRE30757SB/00, LRE30757ST/00 Installation Guide

Website: http://us.lge.com

ElectricRange

LRE30955S / LRE30855S
LRE30755S / LRE30451S

........ these instructions thoroughly before

.............................................................i taJJi_ Bdoperafingtherange.

JJJJJii_,

P/No.: MFL37118101

_-I BEFORE YOU BEGIN

Remove all tape and packing materials before using the range.

Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials.

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or
damage when using the range. This guide does not cover all possible conditions that may occur. For further

assistance contact your service agent or manufacturer.

•The information in this manual should befollowed exactly.

-A fire or electrical shock may result causing property damage, perasonal injury or death.

•DO NOT step or sit on oven door. Install the Anti-Tip Bracket supplied with the range.

-The range could betipped and injury might result from spilled hot liquid, food, or the range itself.

- Ifthe range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip Device is properly
reengaged when the range is pushed back against the wall.

•New branch-circuit installations (1996 NEC) for mobile homes, recreational vehicles, and

installations where local codes do not allow grounding through the neutral wire require a 4-
conductor UL listed range cord or 4 wire conduit connection.

•The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected

to the middle post of the main terminal block. The remaining two wires of the power cord or
conduit have to be connected to the outside posts of the main terminal connection block.

- Failure to do so can result in electrical shock, severe personal injury or death.

•Only a4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use with

ranges with closed-loop connectors or open-end spade lugs with upturned ends shall be used.
The middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the middle
post of the main terminal block. The other two wires of the power cord or conduit have to be
connected to the outside posts of the main terminal connection block. The 4th ground wire must

be connected to the frame of the range with the ground screw.

,.- Failure to do so can result in electrical shock, severe personal tnjuryor death.

• Make sure that the wall covering, countertop and cabinets around the range can withstand

the heat (up to 194°F) generated by the range.

- Discoloration, delamination or melting may occur.

- This range has been designed to comply with the maximum allowable wood cabinet temperatures of 194°E

•Cabinet storage space located above the surface units should be avoided.

• Install a range hood that projects horizontally a minimum of 5 inches beyond the bottom of

the cabinets If cabinet storage is to be provided.

,.- The risk of burns or fire by reaching over the heated surface elements can be reduced.

2

• The information in this manual

should be followed exactly.

- A fire or electrical shock may result causing

property damage, perasonal injury or death.

PREPARE TO INSTALL THE RANGE

TOOLS NEEDED

Phillips Screwdriver Level

Flat-blade

Screwdriver

Adjustable Wrench

• DO NOT step or sit on oven

door. Install the Anti-Tip

Bracket supplied with the

range.

- The range could be tipped and
injury might result from spilled hot
liquid, food, or the range itself.

- If the range is pulled away from the

wall for cleaning, service, or any
other reason, ensure that the Anti-

Tip Device is properly reengaged
when the range is pushed back

against the wall.

NOTE

• Read all instructions contained in these installation
instructions before installing range.

• Remove all packing materials from the oven
compartments before connecting the electrical
supply to the range.

• Observe all governing codes and ordinances.

• Be sure to leave these instructions with the consumer.

1/4" Nut Driver

Pliers

PARTS PROVIDED

Template

Anchor Sleeves

(For Anti-Tip Bracket Mounted

on Concrete Floors and Walls)

PARTS NOT PROVIDED

Anti-Tip Bracket Kit

%%%%

Lag Bolts

NOTE

Keep these instructions with your owner's manual for
future reference.

• As when using any appliance generating heat, there
are certain safety precautions you should follow.

• Be sure your range is installed and grounded
properly by a qualified installer or service technician.

• Make sure the wall coverings around the range can

withstand the heat generated by the range.

• To eliminate the need to reach over the surface
elements, cabinet storage space above the elements

should be avoided.

(ULApproved 40 or50AMP}

4-Wire Cord OR 3-Wire Cord |nstaHations Only)

Strain Relief
(For Conduil