" Change or Modifications that are not expressly approved by the manufacturer could void
the user's authority to operate the equipment. “
Part 15.105 statement
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. if this equipment does cause harmful interference or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Part 15 Class B Compliance
This device and its accessories comply with part15 of FCC rules.
Operation is subject to the following two conditions:
(1) This device & its accessories may not cause harmful interference.
(2) This device & its accessories must accept any interference received,
including interference that may cause undesired operation.
Body-worn Operation
This device has been tested for typical body-worn operations
with the distance of 0.19inches (0.5cm) from the user’s body.
To comply with FCC RF exposure requirements, a minimum separation distance
of 0.19inches(0.5cm) must be maintained from the user's body.
Additionally, Belt clips, holsters & other body-worn accessories may not contain
metallic components.
Copyright
LGE Co., Ltd has the copyright for this manual.
This manual should not be reproduced or distributed with no prior written
consent by LGE Co., Ltd.
Registered Trademark
The registered trademark stated in this manual is the registered trademark
owned by the corresponding company.
Confidential & Proprietary
This manual is the technical property of LGE Co., Ltd and it is prohibited to copy or utilize the manual with
no prior consent by the technical data department.
- 2 -
- 3 -
Table of Contents
Cautions for Safety.......................................................................5
The cautions for safety are the contents to keep the safety of users and to
prevent possible loss in property or convenience caused by accidents. The
product should properly be used after sufficient understanding of the contents.
Warning
z Do not discretionally disassemble, modify, or repair the product.
z Do not use the product if possible at the place where the use of
handsets is prohibited.
z Use the product according to the rules and regulations of hospitals or
medical institutions when using the product in such places.
z Do not use the product in the Airplane.
z Keep the product and accessories out of children’s reach.
z Do not touch or use with wet hands.
z Do not use the product outside in the thundering or lightning weather.
Cautions
z Be careful not to give impact to the product and not to throw (or drop)
the product because the product may be broken or deformed.
z When a trouble is occurred with the product, visit a designated service
center to receive the service.
z Keep the USB port of the product clean always.
z The data to use the product is stored in USIM CARD; be careful to
avoid possible damage to USIM CARD.
z Do not use or keep the product with magnetic storage media together.
z Do not use or keep the product at the very hot or very cold place or the
place with large variation of temperature.
z If the model is disconnected from PC in switch-on status, the data may
be damaged; disconnect the model from the PC after the programs are
terminated and the power LED is turned off.
- 5 -
z When the product is used in connection with a notebook with use the
battery only, the battery of the notebook may be somewhat rapidly
discharged due to additional consumption of the power by the product.
- 6 -
Introduction
Thanks you for purchasing LHU2100T of LGE Co., Ltd.
LHU2100T is a USB Modem by
HSDPA
method to use wireless internet anytime
and anywhere with no limit in time or place.
* HSDPA (High Speed Downlink Packet Access): This is the mobile communication
method for sending/receiving data at the speed significantly faster than that of W-CDMA
or CDMA.
Specific Features
* General Features
- USIM Support
- Internet
- SMS
- Address
- Connection logs
* Mechnical Features
- Compatible microSD card
- Main Intenna
- UMTS Diversity Intenna (2100MHz)
- 3 Colors LED
- Dimension: 33.5mm(W) × 11mm(H) × 82.5mm(D)
* Data Rate
- Download: Up to 7.2 Mbps
- Upload: Up to 384 Kbps
* Frequency Band
- GSM: 850 / 900 / 1800 / 1900 MHz
- UMTS: 850 / 1900 / 2100 MHz
- 7 -
Configuration
The configuration of LHU2100T product is as shown below:
The configuration of the product may be somewhat changed wit no prior notice to improve
the functions of the product.
Condition for Use
The minimum specification of the PC to use LHU2100T is as described below:
z Operating System: Windows® 2000, XP or Vista(32bit, 64bit), Mac® OS X
z CPU: Pentium 4, 1 GHz or above
z Memory: 128MB RAM or above
z Hard disk space: 100MB or above
z Connection port: USB slot A-Type
- 8 -
Name of Each Part
Front Part Lateral Part
LED Display
USIM Slot
USB Port
Micro SD 슬롯
Lower Part
USB Port
- 9 -
Installing Program
S/W is included in USB Modem.
1. When LHU2100T is inserted into the USB port of the PC to use LHU2100T,
the installation program is automatically run.
Note: If LHU2100T Dialer program is already installed, the program is not automatically run.
If you want to reinstall the program, manually start the installation program with use of explorer.
2. When the installation is automatically started, below-shown screen is
displayed. Choose the setup language and click [OK] button.
Note: If the installation is not automatically run, doubleclick “setup32.exe” file in CD. (In case of
Vista 64, setup64.exe)
3. To install the program, files are copied from Modem to PC.
- 10 -
4. When “Welcome to the Installshield Wizard” message is displayed, click
[Next] button.
5. Designate the destination folder to install the program and click [Next] button.
Destination folder of
the program
- 11 -
Loading...
+ 29 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.