LG LD-2163MH User Manual
DISHWASHER
OWNER'S MANUAL
MODEL : LD-2160(3)W(S,M,L,T)H
LD-2160(3)W(S,M,L)HB
LD-2160(3)W(S,M,L,T)HU
Please read this manual carefully before operating your
dishwasher. Retain it for future reference.
CONTENTS
SAFETY AND CAUTION 3
INSTALLATION INSTRUCTIONS 5
PARTS NAME 9
FUNCTION OF CONTROL BUTTON 10
HOW TO USE AND OPERATE 12
OPERATING SEQUENCE 19
PROGRAM 20
USER MAINTENANCE INSTRUCTIONS 21
TROUBLE SHOOTING GUIDE 22
SPECIFICATION
SAFETY AND CAUTION
IMPORTANT SAFETY INSTRUCTIONS
WARNING - When using your dishwasher, follow basic precautions,
including the following:
• Please read this manual carefully before
using the dishwasher for the first time.
• This manual contains very important notes
regarding the installation, use and
maintenance of your dishwasher.
• The manufacturer can not be responsible
for problems caused by ignoring these
safety and caution instructions.
• This dishwasher is designed for normal
household use.
• Do not use the dishwasher for industrial
and commercial use, or other purpose.
• The appliance is not intended for use by
young children or infirm persons without
supervision.
During installation
• Electrical connection must be in
accordance with the rating label.
• Electrical safety is only guaranteed when
the earth system of your house is in
accordance with the related local
regulations.(Do not use an extension cable
or cord.)
• If the hot water exceeds 65ºC, adjust the
water heater setting. If the hot water
temperature can not be maintained below
65ºC, the dishwasher must be connected
to cold water.
• If power supply cord is damaged, it must
only be replaced by the manufacturer or
its service agent or a similar qualified
person in order to avoid a hazard.
• This appliance must be positioned so that
the plug is accessible.
• The appliance is to be connected to the
water mains using new hose-sets and that
old hose-sets should not be reused.
During use
• Only suitable household utensils should
be placed in the dishwasher.
(Please avoid utensils; that are nonheatresistant, metal decorated, etc.)
• Do not use any kinds of solvent in your
dishwasher. They may cause an explosion
or fire.
• Do not spray water on the appliance.
It may cause the failure of electric parts or
electric shock.
• Do not push down or sit on the inner door
when the door opened. It may cause the
deformation or failure of your dishwasher.
• Do not use the detergent for hand
washing.
The detergent for dishwasher should be
used for normal operation.
• This appliance is fitted with a safety
function that automatically stops the
operation of the dishwasher when it is
exposed to heavy disturbance on its
mains.
• Dishwasher detergents are strongly
alkaline. They can be extremely
dangerous if swallowed. Avoid contact
with skin and eyes and keep children
away from the dishwasher when the door
is open.
Check that the detergent receptacle is
empty after completion of the wash cycle.
Child Safety
• Controls may be locked using “Child
Lock” mode to prevent from all the setting
from being changed by a child.
• Keep children away from detergents and
rinse-aids.
• Do not allow children to operate the
dishwasher.
• Young children should be supervised to
ensure that they do not play with the
appliance.
3
SAFETY AND CAUTION
CAUTION concerning the Power Cord
• Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet
circuit which powers only that appliance and has no additional outlets or branch circuits. Check
the specification page of this owner's manual to be certain.
• Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension
cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these
conditions could result in electric shock or fire. Periodically examine the cord of your appliance,
and if its appearance indicates damage or deterioration, unplug it, discontinue use of the
appliance, and have the cord replaced with an exact replacement part by an authorized servicer.
• Protect the power cord from physical or mechanical abuse, such as being twisted, kinked,
pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the
point where the cord exits the appliance.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of a malfunction or breakdown,
grounding will reduce the risk of electric shock by providing a path of least resistance
for electric current. This appliance is equipped with a cord having an equipmentgrounding conductor and a grounding plug. The plug must be plugged into an
appropriate outlet that is installed and grounded in accordance with all local codes and
ordinances.
WARNING - Improper connection of the equipment-grounding conductor can result in
a risk of electric shock. Check with a qualified electrician or service
representative if you are in doubt whether the appliance is properly
grounded. Do not modify the plug provided with the appliance; if it will not
fit the outlet have a proper outlet installed by a qualified electrician.
Disposal of your old appliance
1. When this crossed-out wheeled bin symbol is attached to a
product it means the product is covered by the European
Directive 2002/96/EC.
2. All electrical and electronic products should be disposed of
separately from the municipal waste stream via designated
collection facilities appointed by the government or the local
authorities.
3. The correct disposal of your old appliance will help prevent
potential negative consequences for the environment and human
health.
4. For more detailed information about disposal of your old
appliance, please contact your city office, waste disposal service
or the shop where you purchased the product.
4
INSTALLING INSTRUCTIONS
WARNING
A qualified electrician/plumber or
competent person should carry out any
electrical/plumbing work required to
install this appliance.
Step 1 :
PREPARE CUPBOARD OPENING
This dishwasher is designed to fit the size
1
shown as below.
Select a location as close to sink as
2
possible for ease of connection to the
water and drain pipes.
To ensure good drainage, the dishwasher
3
should not be installed more than 3 meters
away from the sink.
If dishwasher is installed in a corner, a
4
minimum of 5cm of space is required
between the washer and an adjacent
cabinet or wall.
Step 2 :
PREPARATION FOR ELECTICAL WIRING
CAUTION
For personal safety, remove house fuse
or open circuit breaker before installation.
Do not use an extension cord or adapter
plug with this appliance. Electrical and
earthing connections must comply with
the national electrical code/provincial and
municipal code and/or other local codes.
This appliance must be supplied with
1
correct rating voltage and hertz as shown
on instruction manual, and connected to
an individual, properly earthed branch
circuit, protected by a minimum 15 amp
circuit breaker or time delay fuse.
Wiring must be 2 wire with Earth.
The power plug must be in a accessible
2
location adjacent to and not behind the
dishwasher and within 1.2 meters of the
dishwasher side.(See page 7 Fig.A)
Unit:mm
Any bare wood surrounding the dishwasher
should be sealed with a waterproof paint or
sealant to prevent swelling.
3
The power plug must be correctly
earthed, if in doubt, have it checked by a
qualified Electrician. No other appliance
should be connected to the same plug
outlet by a double adapter or similar
plug.
5
INSTALLATION INSTRUCTIONS
Step 3 :
PREPARING THE DISHWASHER
FOR INSTALLATION
Lay the dishwasher on its back.
1
Adjust the legs to the required height
2
as shown in below figure.
Step 4 :
INST ALLING THE DISHW ASHER
IN CUPBOARD
Before sliding the dishwasher into the
1
cupboard opening, all necessary height and
balancing adjustments should be made
using a spanner.
2
Slide the dishwasher into the cabinet
opening carefully. Make sure that the
drain hose inside the cabinet is not
kinked or stretched.
CAUTION
If the height of the cupboard is below 850mm,
you should remove the top table by
unscrewing the 2 screws. (Two of rear)
6
INSTALLATION INSTRUCTIONS
Step 5 :
DRAIN LINE CONNECTION
If the end of drain hose does not fit to
1
the drain line, use a rubber
connector(not supplied) that is
resistant to heat and detergent.
This should be available from a
plumbing shop or DIY merchants.
There are two typical connections as
2
shown in Figure A, B.
The “S” trap spigot must be drilled out
cleanly and free of obstruction to its
maximum internal diameter, if used for
drainage.
To prevent siphoning, one of the following
methods must be used:
■ When the drain hose is connected to a
separate standpipe, it is essential that an
airtight connection be made.
Refer to Fig.B
■ When the drain hose is connected to a
sink “s” trap or waste disposal unit, the
hose must be looped up to the underside
of the bench top and secured.
Fig. A
Fig. B : Drainage connection - stand pipe.
Drain hose Extension
Extend drain hose as shown below.
CAUTION
When you connect or extend drain hose,
make sure that drain hose is not kinked.
(Bends should have a 40 mm radius.)
7
INSTALLATION INSTRUCTIONS
Water tap
Water supply
hose
Step 6 :
WATER SUPPLY CONNECTION
Connect the water supply hose to the
1
water tap as shown.(Some models consist
of an inlet valve and hose.)
This dishwasher may be fed with either
hot or cold water. If the water can not be
maintained below 65ºC, the dishwasher
must be connected to cold water.
When connecting, the sealant tape or
2
sealing compound to avoid water leaks.
Make sure that the line is not kinked or
sharply bent.
Step 8 :
HOW TO LEVEL THE DISHWASHER
After installing the dishwasher, you may notice
a slight sticking of the door to the dishwasher ,
when you open or close the door. If this does
happen you need to adjust the level of the
dishwasher.
Case 1. In case the door is slanted to the right
Fig. C
• If the door slants to the right, see fig, C and
follow these instructions:
1) Unscrew(counter-clockwise) the left leg of
the back side and correct the level.
2) Check the opening of door and repeat if
necessary until the door opens and closes
properly.
• When the product is correctly leveled, There
should be no slant , stickiness or friction sound.
Step 7 :
FINAL CHECK AND ASSEMBLING
Securely hand tighten supply hose to the
1
water supply .
Plug the power supply cord into an
earthed electrical point and switch on.
After installing and prior to using the
2
dishwasher with crockery , we
recommend that you use the dishwasher
on ‘Quick’ mode to rinse through. At this
stage it is useful to ensure that there are
no operating problems or water leaks.
When the dishwasher is used for the first,
there may be a loud noise, if this
happens, turn off the power and restart
the dishwasher .
Case 2. In case the door is slanted to the left
Fig. D
• If the door slants to the left, see fig. D and
follow these instructions:
1) Check the opening of door if there still
remains sticky or friction sound.
2)
Check the opening of door and repeat if
necessary until the door opens and closes
properly.
• When the product is correctly leveled, There
should be no slant , stickiness or friction
sound.
8
Loading...