LG LCU3100R-DP Owner’s Manual
MODELS
Signal System
NTSC PAL
Imaging Sensor
Horizontal Resolution
Image Signal Processor
Lens Type
Minimum Illumination (30 IRE)
Day & Night
Sync. System
Scanning Frequency (H/V)
15.734 KHz / 59.94 Hz 15.625 KHz / 50 Hz
S/N Ratio
Video Output Signal
IR LED
IR OPTIMIZER
Exposure
Auto Gain Control
Electronic Shutter Speed
Auto (1/60 ~ 1/100,000) Auto (1/50 ~ 1/100,000)
White Balance
Power Source
Operating Temperature/Humidity
Storage Temperature/Humidity
Dimension
Weight
1/3" 960H Interline Color CCD ( Super HAD II )
650TVL @ Color, 700TVL @ B/W
E.Effio-E
4mm
Color : 0.1Lux, B/W : 0 Lux (IR LED ON)
AUTO(Photo Sensor)
Internal
50dB
1Vp-p Composite (75Ω)
24EA
AUTO
ELC
Auto
Auto (1,800 ºK ~ 10,500 ºK)
-10˚C ~ 50˚C / 0% ~ 80%RH
-20˚C ~ 60˚C / 0% ~ 85%RH
152 x 108 x 72 mm
420 g
MODELS
LCU3100R-DN / LCU3100R-DP
LCV1100R-DN / LCV1100R-DP
CAUTION
RISK OF ELECTRIC SHOCK
CAUTION:
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated dangerous voltage
within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of impor tant operating and maintenance (servicing)
WARNING:
FCC WARNING:
modifications to this equipment may cause harmful interference unless the modifications are
expressly approved in the instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
REGULATORY INFORMATION: FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to P
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful inter ference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
• A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this
• Caution: Danger of explosion if batter y is incorrectly replaced. Replaced only with the same or
• Holes in metal, through which insulated wires pass, shall have smooth well rounded sur faces
Warning: Do not install this equipment in a confined space such as a bookcase or similar unit.
Warning: Wiring methods shall be in accordance with the National Electric Code, ANSI/NFPA 70.
Warning: This is a class A product. I n a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
Warning: To reduce a risk of fire or electric shock , do not expose this product to rain or moisture.
Warning: The product has been dropped or the case is broken, turn off the power and unplug the
power cord. (This may cause fire, electric shock, or injury.)
only.
Warning:
immediately and contact the ser vice center. (This may cause fire or electric shock.)
Caution: This installation should be made by a qualified service person and should conform to all
local codes.
Caution: To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel
Caution:
with liquids, such as vases, shall be placed on the apparatus.
Caution:
heavy object.
instructions in the literature accompanying the product.
This product contains chemicals known to the State of California to cause cancer and
This equipment may generate or use radio frequency energy. Changes or
art 15 of the FCC Rules. These limits are designed to provide reasonable protection
product in the end user.
equivalent type recommended by the manufacturer. Dispose
the manufacturer’s instructions.
or shall be provided with brushings.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
If the product has no video
The apparatus shall not be exposed to water (dripping or splashing) and no objects filled
Prevent the power cable from being severely bent or having pressure exerted on it by a
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
out or sound, please stop using. Unplug the power cable
birth defects or reproductive harm. Wash hands after handling.
of used batteries according to
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. I nstall in accordance with the manufac turer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding type plug has two blades and
a third grounding prong. The wide blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the apparatus. When
combination to avoid injury from tip -over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified ser vice personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
a cart is used, use caution when moving the cart/apparatus
Power Supply
This camera must always be operated a DC 12 V. Certified/Listed Adaptor which comply with LPS.
Handling of the unit
Be careful not to spill water or other liquids on the unit. Be cautions not to get combustible or
metallic material inside the body. If used with foreign matter inside, the camera is liable to fail or to
get cause of fire or electr ic shock.
•
Remove dust or dirt on the surface of the lens with a blower.
Use a dry soft cloth to clean the body. If it is very dirty, use a cloth dampened with a small
•
quantity of neutral detergent then wipe dry.
•
Avoid the use of volatile solvents such as thinners, alcohol, benzene and insecticides. They
may damage the surface finish and/or impair the operation of the camera. They may damage
the surface finish and/or impair the operation of the camera.
Operating and storage location
Avoid viewing a very bright object (such as light fittings) during an extended period. Avoid
operating or storing the unit in the following locations.
Extremely hot or cold places (operating temperature -10 °C to 50 °C, however, we
•
recommend that the unit be used within a temperature range of 0 °C to 45 °C)
Damp or dust place
•
Places exposed to rain
•
•
Places subject to strong vibration
•
Close to generators of powerful electromagnetic radiation such as radio or T V
transmitters.
Total / Effective Pixels No.
520,000/480,000PIXELS 610,000/570,000PIXELS
LG Electronics hereby declares that this/these product(s) is/are in
compliance with the essential requirements and other relevant
provisions of Directive 2004/108/EC, 2006/95/EC.
European Standards Centre:
Krijgsman 1, 1186 DM Amstelveen The Netherlands
DC12V , 290mA (3.5W)
INSTALLATION
Install the camera mounting bracket to the ceiling.
按图中步骤 1 和 2 所示装配摄像机和安装架。
1
CONNECTION & ADJUSTMENT
1.Power connection - DC12V
POWER
INPUTDC12V
3. Adjust the Pan/Tilt/Rotate position of the camera.
2
2.Video connection
power input
video output
VIDEO
OUTPUT
4. Focus : The lens is focused far from 1m.
TILTINGPANNINGROTATING
WARNINGS & CAUTIONSWARNINGS & CAUTIONS
The information is provided to ensure your safety and to prevent any losses,
financial or otherwise. Please read it
* For product inquires, please contact the retail shop where you bought the camera.
The use of equipment such as
shall be at your expense.
carefully and use the product accordingly.
an aerial ladder while providing after sales service
NOTE : We recommend the lens focus as is.
NOTES
* Please make sure the product is installed appropriate
places where secured from flood,
* This product is certified as IP66 standard. However, if there is any flood concerns,
you shall
ask the service center if it would be OK to install where you want.
such as under the eaves, to operate properly.
Loading...