LG LBK1000W Installation Manual

Installation Guide

Wall Mount Bracket

Model: LBK1000W

Introduction

This product is designed for the wall mount of LG
Dome camera on the wall.

The installable LG Dome Camera

-LT713, LT913, LT723, LT923, LW9226, LW9228,
LCP2850, LCP3750(T), LNP3700T, LNP2800, LW9424,
LW9422 and LNP2810T models

-Refer to the owner’s manual of LG Dome Camera for
the compatibility of this product.

-Actual set may be dier from the picture described
in this manual.

WARNING:

This product contains chemicals known to the State
of California to cause cancer and birth defects or
reproductive harm. Wash hands after handling.

Installation Precautions

Make sure that the installation place can endure at least
4 times of the total weight of the Wall Mount Bracket
and Camera.

Specifications

yNet Weight: 1.1 kg

yMaterial: Aluminum

yOperating Temperature: -50 °C to 60 °C

yOperating Humidity: 0 to 100 %

yDimensions:

Getting Started

Installation with LW9424/9422 and LNP2810T
models

b

c

a

d

e

Install the PIPE Installation Bracket as
shown below.

Connect the cable to the camera jack.

Connect the safety cable to the camera
body in order to prevent a camera from
falling.

Assemble the camera to the PIPE Installation
Bracket by turning it clockwise. Tighten the M3
SAMS Screws and then align the cover adaptor
and main body.

300 mm

125 mm

227 mm

Install the Wall Mount Bracket to the wall.

Accessories

-Installation manual

-Screw accessory

yWrench(M5) (1 ea)

yWrench(M10) (1 ea)

yHexagon head bolt (M10 x L50.0 mm)

(4 ea)

Installation with LT713/913/723/923, LW9226/8,
LCP2850/3750(T) and LNP3700T/2800

models

a

b

c

e

df

g

e

df

g

Connect the connection cable and the
safety cable to the camera body.

Install the PIPE Installation Bracket to the
Wall Mount Bracket.

Pass the connection cable throught the Wall
Mount Bracket.

Install the Wall Mount Bracket to the wall.

Attach the camera to the PIPE Installation
Bracket by following step a and b. Align
the locking point of the PIPE Installation
Bracket and the camera body.

Tighten the locking screw.

Assemble the PIPE Installation Bracket as
shown below.