LG L5213-BN User Manual

OWNER'S MANUAL

Color Video Camera

Please read this manual carefully before operating
your set and retain it for future reference.

P/NO : MFL63745108 (A)

MODEL

L5213-BN
L5213-BP
L5213-DN

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug.
A polarized plug has two blades with one wider than the other. A ground­ing type plug has two blades and a third grounding prong. The wide blade
or the third prong are provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for replacement of the obso­lete outlet.

10. Protect the power cord from being walked on or pinched particularly at
plugs, convenience receptacles, and the point where they exit from the
apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip­over.

13. Unplug this apparatus during lightning storms or when unused for long
periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.

Accessories

Installation sticker

Camera mounting bracket

M3 Fixing screws

Specication

Item L5213-BP L5213-BN L5213-DN

Signal System PAL NTSC

Total Pixels 470 000 Pixels 410 000 Pixels

Effective Pixels 440 000 Pixels 380 000 Pixels

Image Device 6 mm Super HAD II CCD

DSP XDI-S2

Lens 2.8 mm to 11 mm Vari-focal lens (F1.4)

Digital Zoom X8

Synchronization System Internal

Scanning Frequency

(H/V)

15.625 kHz / 50 Hz 15.734 kHz / 59.94 Hz

Horizontal Resolution 620 TV Lines

S/N Ratio 52 dB

Minimum

Illumination

(30 IRE)

Color

mode

0.06 lx (Sens-up OFF, F1.4)

0.0001 lx (Sens-up Auto, F1.4)

B/W

mode

0.006 lx (Sens-up OFF, F1.4)

0.000 001 lx (Sens-up x128, F1.4)

Control Method Inner Key Button

Video Output Signal 1 Vp-p Composite (75 Ω)

Day & Night Day / Night / Auto

BACKLIGHT OFF / BLC / HSBLC

DNR 3D-DNR (Off/Low/Middle/High)

Item L5213-BP L5213-BN L5213-DN

Auto Gain Control Off / Low / Middle / High

Electronic Shutter

Speed

1/50 to 1/90 000 1/60 to 1/90 000

Electronic Sensitivity OFF/Auto

White Balance

ATW / AWC b PUSH / Manual

Motion Detection 4 Zones

Privacy Zone Masking 8 Masks

Stabilizer( EIS) On / Off

User Color Mode STANDARD/COOL/WARM/VIVID

Power Source DC 12 V / AC 24 V DC 12 V

Power Consumption 2.8 W 2.2 W

Operation Temp. -10 ºC to 50 ºC

Storage Temp. -20 ºC to 60 ºC

Operation Humidity 0 % RH to 80 % RH

Storage Humidity 0 % RH to 85 % RH

Weight 323 g

Dimension (Ø x H) Ø 140 x 87.3 mm

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This lightning flash with arrowhead symbol within an equi­lateral triangle is intended to alert the user to the presence
of uninsulated dangerous voltage within the product’s
enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.

The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the product.

FCC WARNING: This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.

REGULATORY INFORMATION: FCC Part 15

This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equip­ment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful inter­ference in which case the user will be required to correct the interference at his
own expense.

A suitable conduit entries, knock-outs or glands shall be provided in the •
cable entries of this product in the end user.

Caution: Danger of explosion if battery is incorrectly replaced. Replaced •
only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.

Holes in metal, through which insulated wires pass, shall have smooth well •
rounded surfaces or shall be provided with brushings.

This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du
Canada.

Warning: Do not install this equipment in a confined space such as a bookcase
or similar unit.

Warning: Wiring methods shall be in accordance with the National Electric
Code, ANSI/NFPA 70.

Warning: This is a class A product. In a domestic environment this product
may cause radio interference in which case the user may be required to take
adequate measures.

Warning: To reduce a risk of fire or electric shock, do not expose this product to
rain or moisture.

Caution: This installation should be made by a qualified service person and
should conform to all local codes.

Caution: To avoid electrical shock, do not open the cabinet. Refer servicing to
qualified personnel only.

Caution: The apparatus shall not be exposed to water (dripping or splashing)
and no objects filled with liquids, such as vases, shall be placed on the appara­tus.

To disconnect power from mains, pull out the mains cord plug. When install­ing the product, ensure that the plug is easily accessible.

LG Electronics hereby declares that this/these product(s) is/are in
compliance with the essential requirements and other relevant pro­visions of Directive 2004/108/EC, 2006/95/EC, and 2009/125/EC.

European representative :

LG Electronics Service Europe B.V.
Veluwezoom 15, 1327 AE Almere,
The Netherlands (Tel : [phone])

Disposal of your old appliance

1. When this crossed-out wheeled bin symbol is attached to
a product it means the product is covered by the European
Directive 2002/96/EC.

2. All electrical and electronic products should be disposed of
separately from the municipal waste stream via designated
collection facilities appointed by the government or the local
authorities.

3. The correct disposal of your old appliance will help prevent
potential negative consequences for the environment and
human health.

4. For more detailed information about disposal of your old
appliance, please contact your city office, waste disposal
service or the shop where you purchased the product.

<For Turkey only>

5. EEE Compliance with Directive.
(EEE Yönetmeliğine Uygundur.)

AB28

a

Using the
template as a guide,
make a hole through
the ceiling.

<ITALIANO>

Utilizzando il modello come guida, praticare un foro
attraverso il soffitto.

<FRANÇAIS>

En vous servant du modèle comme guide, percez un trou
dans le plafond.

<ESPAÑOL>

Usando la plantilla como guía, haga un agujero en el
techo.

<PORTUGUÊS> Usando o molde como um guia, faça um furo no teto.

<PYCCKNЙ>

Используя шаблон как вспомогательный элемент,
сделать отверстие в потолке.

<POLSKI> Używając szablonu wykonać otwór w suficie.

<ČEŠTINA> Pomocí šablony udělejte díru do stropu.

b

Install the camera
mounting bracket
to the ceiling.

<ITALIANO>

Installare la staffa per il montaggio della videocamera al
soffitto.

<FRANÇAIS> Fixez le support de montage de la caméra au plafond.

<ESPAÑOL> Instale el soporte de la cámara en el techo.

<PORTUGUÊS> Instale o suporte de montagem da câmera no teto.

<PYCCKNЙ> Прикрепить монтажный кронштейн камеры к потолку.

<POLSKI> Zainstalować na suficie wspornik montażowy kamery.

<ČEŠTINA> Instalujte mechanismus pro uchycení kamery na strop.

c

Connect the cables to
the cable jacks of the
camera body.

<ITALIANO> Collegare i cavi alle prese sul corpo della videocamera.

<FRANÇAIS>

Raccordez les câbles aux prises correspondantes du corps
de la caméra.

<ESPAÑOL>

Conecte los cables en los terminales del cuerpo de la
cámara.

<PORTUGUÊS>

Conecte os cabos na tomada de cabos do corpo da
câmera.

<PYCCKNЙ> Подключить кабели к разъемам на корпусе камеры.

<POLSKI>

Podłączyć kable do gniazd znajdujących się w obudowie
kamery.

<ČEŠTINA> Zapojte kabely do konektorů těla kamery.

d

Assemble the camera
and mounting bracket as
illustrated step a and
b.

<ITALIANO>

Montare la videocamera e la staffa come illustrato nei
passi a e b.

<FRANÇAIS>

Assemblez la caméra et le support de montage comme
illustré aux étapes a et b.

<ESPAÑOL>

Monte la cámara y el soporte como se muestra en los
pasos a y b.

<PORTUGUÊS>

Monte a câmera e o suporte de montagem conforme
mostrado nos passoa a e b .

<PYCCKNЙ>

Соединить камеру и монтажный кронштейн, как
показано на иллюстрации шага a и b.

<POLSKI>

Zamontować kamerę na wsporniku montażowym tak, jak
to pokazano na ilustracji kroku a oraz b.

<ČEŠTINA>

Připevněte kameru a mechanismus pro uchycení jak je
vyobrazeno v kroku a a b.

a

Connect a portable monitor to the
video jack.

<ITALIANO> Collegare un monitor portatile alla presa video.

<FRANÇAIS> Raccordez un moniteur portable à la prise vidéo.

<ESPAÑOL> Conecte un monitor portátil a la conexión de vídeo.

<PORTUGUÊS> Conecte o monitor portátil na tomada de vídeo.

<PYCCKNЙ> Подключить переносной монитор к разъему видео.

<POLSKI> Podłącz monitor przenośny do złącza video (video jack).

<ČEŠTINA> Zapojte přenosný monitor ke konektoru videa.

b

Adjust the Pan/Tilt position of the cam­era.

<ITALIANO> Regolare la posizione Pan/Tilt della videocamera.

<FRANÇAIS>

Réglez la position de panoramique/inclinaison de la
caméra.

<ESPAÑOL>

Ajuste la posición de movimiento panorámico/inclinación
de la cámara.

<PORTUGUÊS> Ajuste as posições de Pan/Inclinar da câmera.

<PYCCKNЙ> Регулировать наклон/поворот камеры.

<POLSKI> Ustaw panoramę/pochylenie kamery.

<ČEŠTINA> Nastavte pozici kamery Pan/Tilt.

c

Adjust the azimuth angle.

<ITALIANO> Regolare l’angolo dell’azimut.

<FRANÇAIS> Réglez l’angle d’azimut.

<ESPAÑOL> Ajuste el ángulo de azimut.

<PORTUGUÊS> Ajuste o ângulo de fundo.

<PYCCKNЙ> Регулировать угол перекоса.

<POLSKI> Ustaw kąt azymutu.

<ČEŠTINA> Nastavte azimut.

d

Adjust the zoom and focus.

NEAR FAR

WIDE TELE

<ITALIANO> Regolare lo zoom e la messa a fuoco.

<FRANÇAIS> Réglez le zoom et la mise au point.

<ESPAÑOL> Ajuste el zoom y el enfoque.

<PORTUGUÊS> Ajuste o zoom e o foco..

<PYCCKNЙ> Регулировать зум и фокус.

<POLSKI> Ustaw przybliżenie oraz ostrość.

<ČEŠTINA> Nastavte přiblížení/oddálení a zaostření.

Camera Adjustment

Installation Guide