LG L4200TC Users manual

Test Report No.: GETEC-E3-04-044
FCC Class B Certification

APPENDIX H

: USER’S MANUAL

EUT Type: 42” LCD TV/Monitor

FCC ID : BEJL4200TC

Regulatory Information

FCC Compliance Statement

This equipment has been tested and found to comply within
the limits of a Class B digital device pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.

This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.

If this equipment does cause harmful interference to radio
or television reception (which can be determined by turning
the equipment on and off), the user is encouraged to try to
correct the interference by using one or more of the
following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.

Caution: Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's (or your) authority to operate the equipment. Only
peripherals (digital input/output devices, terminals, printers,
etc.) certified to comply with the Class B limits may be
attached to this monitor. Operation with non-certified
peripherals is likely to result in interference to radio and TV
reception.
Only shielded signal cables may be used with this System.

The regulations are applied only to the products with the
ID LABEL indicating specific requirements.

NOTICE

Canadian DOC Notice

This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les
exigences du Règlement sur le matériel brouilleur du
Canada.

The regulations are applied only to the products with the
ID LABEL indicating specific requirements.

NOTICE

CE Conformity Notice

Products with the “CE” Marking comply with the EMC
Directive(89/336/EEC) and LOW VOLTAGE Directive
(73/23/EEC) issued by the Commission of the European
Community.
Compiance with these directives implies conformity to the
following European Norms :

• EN 55022:1998 ; Radio Frequency Interference

• EN 55024:1998 ; Electromagnetic Immunity

• EN 61000-3-2 ; Power Line Harmonics

• EN 61000-3-3 ; Voltage Fluctuations

• EN 60950 ; Product Safety

Low Radiation Compliance (MPR II)

This monitor meets one of the strictest guidelines available
today for low radiation emissions, offering the user extra
shielding and an antistatic screen coating. These
guidelines, set forth by a government agency in Sweden,
limit the amount of emission allowed in the Extremely Low
Frequency (ELF) and Very Low Frequency (VLF)
electromagnetic range.

TCO95

Congratulations!

You have just purchased a TCO’95 approved and labelled
product! Your choice has provided you with a product
developed for professional use. Your purchase has also
contributed to reducing the burden on the environment and
to the further development of environmentally-adapted
electronic products.

Why do we have environmentally labelled computers?

In many countries, environmental labelling has become an
established method for encouraging the adaptation of
goods and services to the environment. The main problem
as far as computers and other electronic equipment are
concerned is that environmentally harmful substances are
used both in the products and during their manufacture.
Since it has not been possible so far for the majority of
electronic equipment to be recycled in a satisfactory way,
most of these potentially damaging substances sooner or
later enter Nature.

There are also other characteristics of a computer, such as
energy consumption levels, that are important from both the
working and natural environment viewpoints. Since all
types of conventional electricity generation have a negative
effect on the environment (acidic- and climatic-influencing
emissions, radioactive waste, etc.), it is vital to conserve
energy. Electronic equipment in offices consumes as
enormous amount of energy, since it is often routinely left
running continuously.

What does the environmenal labelling involve?

This product meets the requirements for the TCO’95

1

(for Europe)

NOTICE
The regulations are applied only to the products with the
ID LABEL indicating specific requirements.

Safety Precautions

Please read these safety precautions carefully before using the monitor.

Warning

Caution

Precautions in installing the Monitor

Warning

Keep away from heat sources like electrical heaters.

- Electrical shock, fire, malfunction or deformation may occur.

Keep the packing anti-moisture material or vinyl packing out of the reach of children.

- Anti-moisture material is harmful if swallowed. If swallowed by mistake, force the patient to vomit and visit the
nearest hospital. Additionally, vinyl packing can cause suffocation. Keep it out of the reach of children.

Do not put heavy objects on the monitor or sit upon it.

- If the monitor collapses or is dropped, you may be injured. Children must pay particular attention.

Do not leave the power or signal cable unattended on the pathway.

- The passerby can falter, which can cause electrical shock, fire, product breakdown or injury.

Install the monitor in a neat and dry place.

- Dust or moisture can cause electrical shock, fire or product damage.

If you can smell smoke or other odors or hear a strange sound unplug the power cord and contact the
service center.

- If you continue to use without taking proper measures, electrical shock or fire can occur.

If you dropped the monitor or the case is broken, turn off the monitor and unplug the power cord.

- If you continue to use without taking proper measures, electrical shock or fire can occur. Contact the service
center.

Do not drop metallic objects such as coins, hair pins, chopsticks or wire into the monitor, or inflammable
objects such as paper and matches. Children must pay particular attention.

- Electrical shock, fire or injury can occur. If a foreign object is dropped into the monitor, unplug the power cord and
contact the service center.

If you ignore the warning message, you may be seriously injured or there is a possibility of
accident or death.

If you ignore the caution message, you may be slightly injured or the product may be damaged

Caution

Make sure the monitor ventilation hole is not blocked. Install the monitor in a suitably wide place (more

than 10cm from the wall)

- If you install the monitor too close to the wall, it may be deformed or fire can break out due to internal heat.

Do not block the ventilation hole of the monitor by a tablecloth or curtain.

- The monitor can be deformed or fire can break out due to overheating inside the monitor.

Install the monitor on a flat and stable place that has no risk of dropping the monitor.

- If the monitor is dropped, you may be injured or the monitor may be broken.

Install the monitor where no EMI occurs.

Keep the monitor away from direct sunlight.

- The monitor can be damaged.

Electrical Power Related Precautions

Warning

Make sure to connect the power cable to the grounded current.

- You may be electrocuted or injured.

Use the rated voltage only.

- The monitor can be damaged, or you may be electrocuted.

During a thunder or lightning storm, unplug the power cable or signal cable.

- You may be electrocuted or a fire can break out.

Do not connect several extension cords, electrical appliances or electrical heaters to a single outlet. Use a
power bar with a grounding terminal designed for exclusive use with the computer.

- A fire can break out due to overheating.

Do not touch the power plug with wet hands. Additionally, it the cord pin is wet or covered with dust, dry
the power plug completely or wipe dust off.

- You may be electrocuted due to excess moisture.

If you don’t intend to use the monitor for a long time, unplug the power cable from the monitor.

- Covering dust can cause a fire, or insulation deterioration can cause electric leakage, electric shock or fire.

Fix the power cable completely.

- If the power cable is not fixed completely, a fire can break out.

Hold the plug when pulling out the power cable. Do not bend the power cord with excessive force or put
heavy objects on the power cord.

- The power line can be damaged, which may cause electric shock or fire.

Do not insert a conductor (like a metal chopstick) into one end of the power cable while the other end is
connected to the input terminal on the wall. Additionally, do not touch the power cable right after
plugging into the wall input terminal.

- You may be electrocuted.

Caution

Do not unplug the power cord while the monitor is in use.

- Electrical shock can damage the monitor.

ENGLISH

Precautions in Moving the Monitor

Warning

Make sure to turn off the monitor.

- You may be electrocuted or the monitor can be damaged.

Make sure to remove all cables before moving the monitor.

- You may be electrocuted or the monitor can be damaged.

Safety Precautions

Caution

Do not shock the monitor when moving it.

- You may be electrocuted or the monitor can be damaged

Do not dispose the product-packing box. Use it when you move.

Make the panel face forward and hold it with both hands to move.

- If you drop the monitor, the damaged monitor can cause electric shock or fire. Contact with the service center for
repair.

Precautions in Using the Monitor

Warning

Do not disassemble, repair or modify the monitor at your own discretion.

- Fire or electric shock accident can occur.

- Contact the service center for check, calibration or repair.

Do not spray water on the monitor or scrub with an inflammable substance (thinner or benzene). Fire or

electric shock accident can occur

Keep the monitor away from water.

- Fire or electric shock accident can occur.

Caution

Do not put or store inflammable substances near the monitor.

- There is a danger of explosion or fire due careless handling of the inflammable substances.

When cleaning the brown tube surface, unplug the power cord and scrub with soft cloth to prevent
scratching. Do not clean with a wet cloth.

- The water can sink into the monitor, which can cause electric shock or serious malfunction.

Take a rest from time to time to protect your vision.

Keep the monitor clean at all times.

Take a comfortable and natural position when working with a monitor to relax the muscles.

Take a regular break when working with a monitor for a long time.

Do not press strongly upon the panel with a hand or sharp object such as nail, pencil or pen, or make a
scratch on it.

Keep the proper distance from the monitor.

- Your vision may be impaired if you look at the monitor too closely.

Set the appropriate resolution and clock by referring to the User’s Manual.

- Your vision can be impaired.

Use authorized detergent only when cleaning the monitor. (Do not use benzene, thinner or alcohol.)

- Monitor can be deformed.

On Disposal

The fluorescent lamp used in this product contains a small amount of mercury.
Do not dispose of this product with general household waste.
Disposal of this product must be carried out in accordance to the regulations of your local authority.

Accessories

Please check the accessories in the product package.
* The monitor and the accessories can be different from the figures shown here.

Desktop Stand Type

Free Mount Type

OR

Monitor

Monitor Driver CD/

User's Guide/Cards

Power Cord

15-pin D-Sub Signal

Cable

Audio Cable (PC)

Optional

Wall-mount Rack

Please refer to the enclosed "Installation Guide" when
installing the wall-mount rack.

ENGLISH

Remote Controller/
Batteries (AAA x 2)

DVI-D Signal Cable

Speaker kit / Screws

(Applicable only for models
that support the speakers)

Inserting batteries into remote controller.

1. Take out the battery cap.

2. Insert the battery with correct polarity (+/-).

3. Close the battery cap.

• You can use a remote controller 7 meter distance and 30 degree (left/right)
within the receiving unit scope.

• Dispose of used batteries in the recycle bin to prevent environmental pollution.